Whirlpool WFW9150WW Support Question
Whirlpool WFW9150WW Support Question
Find answers below for this question about Whirlpool WFW9150WW.Need a Whirlpool WFW9150WW manual? We have 4 online manuals for this item!
Question posted by muztdougal on August 16th, 2014
Whirlpool Duet Stops Mid Cycle And Door Will Not Open
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Whirlpool WFW9150WW Manual Pages
Owners Manual - Page 4
... for connecting the drain hose ■ Locking pliers (that open to 19/16" [39.5 mm])
■ Flashlight (optional)
Tools needed for Part Number 8572546. The pedestal will add to the total height of different heights separately for your washer or refer to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system...
Owners Manual - Page 5
closet or confined area B. closet or confined area
1" (25 mm)
27" (686 mm)
1" (25 mm)
5 The door opens more than 90°, and it is recommended to be fully opened.
■ Additional spacing should also be considered. Side view - Washer on all sides of installation and servicing. Recessed area B. Recessed area or closet installation
48...
Owners Manual - Page 6
... mm)
6
Recommended installation spacing for recessed or closet installation, with a door, the minimum ventilation openings in .2* (155 cm2)
3" (76 mm)
3" (76 mm)
1" (25 mm) 12" (305 mm)
Drain System
The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Select the...
Owners Manual - Page 8
... can result in the rear panel of the washer that support the suspension system during transportation. Clear the water lines
■ Run water through the opening of the rear panel and close the hole...later date, call your machine must be turned on the washer.
2. Then pull the power cord through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket, to get rid of particles in...
Owners Manual - Page 9
... the corrugated drain hose. Connect the inlet hoses to stop the hose from moving when water is pumped out. Slide drain hose onto washer connection.
3.
Use locking pliers, squeeze hose clamp tabs together and insert over the end of the laundry tub. Secure the Drain Hose
Drain hose must be secured to the...
Owners Manual - Page 10
...cycle. Pour the detergent into a grounded 3 prong outlet. If the washer is not recommended.
1. Use only HE High Efficiency detergent.
10
NOTE: Installing washer on the feet, tightly against the washer...surfaces with the floor, use a level). Check that the washer is perfectly level (use a 9/16" (14 mm) open-end wrench to adjust back feet.
4. Complete Installation
1. ...
Owners Manual - Page 11
... electronic controls are evenly balanced. You can be changed if desired. For some cycles, the default spin speed can wash a pillow or a large stuffed teddy bear. This washer allows a 7-minute period in all laundry products before the washer is used, the washer saves energy, too. In addition, if the Dynamic Balance system detects offbalance loads...
Owners Manual - Page 12
... as it stops. When selecting a Wash Cycle, the preset Temp and Spin Speed for the first time, if not completed during the final installation step, choose the Normal cycle and run it... information. Open the dispenser drawer and add laundry products to determine the amount of the cycle, the washer door will likely result in mesh garment bags. Select one garment bag be opened only if...
Owners Manual - Page 13
...completely (to this compartment. To begin the wash cycle later Press DELAY START until door is complete, press POWER once.
8.
Do not put laundry products directly into the wash tub. Use only...diluted and dispensed automatically at the best time during the cycle to the washer during the first rinse after the wash cycle is opened. Chlorine bleach compartment (Letter C in the main ...
Owners Manual - Page 14
... the washer is pressed. To cancel a cycle
1. NOTE: To add garments after the wash cycle has started
1.
Done
The Done light comes on until door is over, the wash cycle needs to
begin the drain. 5. Door Lock
When the status light illuminates, the door is complete, the door unlocks. Cycles
Wash Cycles
Choose Wash Cycles by either pressing POWER or opening the door...
Owners Manual - Page 15
...-speed tumbling, longer wash time, and high-speed spin to shorten drying times.
This cycle combines fast-speed tumbling and high-speed spin. See "Cleaning Your Washer." Eco Heavy Duty
This cycle is useful for equal distribution of the laundry, and a soaking time without spin assures gentle treatment, even for approximately 1 second) to gently...
Owners Manual - Page 16
...from the washer as soon as in hours) is
illuminated. ■ Press START/PAUSE. This option provides an additional rinse with the same water temperature as it stops. It ... remains activated, the door remains locked, and the TUMBLEFRESH™ option indicator light will flash. See "Troubleshooting." Not all Options are available with all cycles.
■ See the "Laundry Guide" section for ...
Owners Manual - Page 18
LAUNDRY TIPS
Preparing clothes for washing Follow these recommendations to help you are made to avoid pilling.
■ Tie strings and sashes so they would normally be caught with the washer ... knits inside out.
■ Separate dark colors from light colors, colorfast items from washer after the cycle is recommended that more than one garment bag be used , and that each garment bag...
Owners Manual - Page 20
... POWER to keep it will not immediately stop the cycle. Open the washer door and remove any detergent to this will proceed to complete. 9.
Close the washer door and dispenser drawer. 5.
b) Wipe the seal/bellow area with AFFRESH™ cycle.
6. Washer Maintenance Procedure
a) If no items are in combination with door open after each cycle to allow the cycle to Step 8. Once the...
Owners Manual - Page 21
... drain system and attach to faucets. 3. To transport the washer:
1. Shut off both water faucets. 5.
If storing or moving your washer only when you are away. ■ Slightly open door to the rear panel of the washer. 6. Shut off both water faucets. 5.
Run the washer through the Normal cycle with ½ the manufacturer's recommended amount of HE...
Owners Manual - Page 22
..., and during the end of flashes before the pause to cancel the cycle. Count the number of draining. Do not remove ground prong. Leaking
■ Was the door opened after the start counting again to . To determine your second code (E code). Unplug washer or disconnect power. All four feet of drainpipe or sink. As...
Owners Manual - Page 23
... of water will unlock. Check electrical source or call an electrician.
■ Is your voltage low? Washer stops working outlet, and check for 1 second.
■ Was the door open to allow the washer to the dispensers? Run another cycle.
23 This washer has a tight seal to lock/unlock controls.
■ Are the touch pad buttons not responding...
Owners Manual - Page 24
... any accumulated film or particles. Check for smaller load sizes (2-3 items) of tumbling and soak.
■ Is the washer overloaded? This extends the cycle.
■ Are you washing many loads? This is blocked open .
■ Is the water inlet hose kinked? The hose needs an air gap. Check water hose connections to provide...
Owners Manual - Page 25
...;C) may not completely dissolve the detergent. Dispensing balls will cause wrinkling. Unload the washer as soon as it stops.
■ Did you use HE detergent? Loads should use enough HE detergent? ...dye, unload the washer as soon as it in a small load or delicate cycle? Do not add detergent to the right faucets. Powdered detergents may cause imbalance. If the laundry is wrinkled, ...
Dimension Guide - Page 1
...laundry tub must be at least 30" (762 mm) above the floor. It is recommended.
Ref. Drain System Options
Standpipe drain system - See "Tools and Parts." For complete details, see Installation Instructions packed with equivalent air ventilation
openings are required. Front-Loading Automatic Washer...
Because Whirlpool Corporation policy includes a continuous commitment to...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How to remove odors from front-load washer (for washers with stored program for cleaning washer)
...not immediately stop the cycle. The machine will unlock. Open the door and remove the items from the washer. Leave the door slightly open the ...washer cleaner. Always do I clean my front-load washer door seal? See your laundry room is complete, wipe out the washer with a cloth if any clothing or items from a front-load washer without a Clean Washer cycle My front load washer... -
Removing odors from a front-load washer with the Clean Washer cycle (on control panel)
... washer cleaner is the Clean Washer Reminder on Affresh washer cleaner, click The cleaning cycle may be interrupted by pressing the Pause/Cancel button once. When the cycle is complete, leave the door open after a few minutes, see My front-load washer display shows rL or F34 . Press Start. For additional information on my Duet® The cleaning cycle... -
Adding items in my dishwasher during a cycle
... the door latch to stop the cycle. Wait for the spraying action to stop before the main wash starts. Open the door and check the detergent dispenser. If the detergent dispenser lid is still closed , add the item. My dishwasher cycle takes too long Dishes are damaged during a cycle? Firmly close the door until it latches. Open the door...
Similar Questions
Washer Quit Mid-cycle, Door Locked, Won't Open. No Power/no Lights.
My Whirlpool Duet WFW9150WW quit mid-cycle and the door is locked. No lights on. No power to unit. U...
My Whirlpool Duet WFW9150WW quit mid-cycle and the door is locked. No lights on. No power to unit. U...
(Posted by tishcrawford 9 years ago)
Why Would A Front Load Washer Stop Mid Cycle That Is Not Related To Electric
supply
supply
(Posted by su1molen 10 years ago)
Stops Mid Cycle
Imy washer stops in mid cycle and starts beeping and i cant get it to restart or anything.
Imy washer stops in mid cycle and starts beeping and i cant get it to restart or anything.
(Posted by ledbetterscottie 10 years ago)
Washer Overloaded; Slight Burning Smell; Stops Mid Cycle.
I think I may have overloaded the washer in my new house. I took half of the clothes out, drained, a...
I think I may have overloaded the washer in my new house. I took half of the clothes out, drained, a...
(Posted by nda151 12 years ago)
Whirlpool Wfw9150ww Wash Light Flashes And Stops Mid Cycle.
Machine is stopping mid wash and begins to beep constantly and the wash light starts flashing until ...
Machine is stopping mid wash and begins to beep constantly and the wash light starts flashing until ...
(Posted by danmuniz24 12 years ago)