Whirlpool GH7208XRB Support Question
Whirlpool GH7208XRB Support Question
Find answers below for this question about Whirlpool GH7208XRB - Microwave.Need a Whirlpool GH7208XRB manual? We have 4 online manuals for this item!
Question posted by Iwakuni16 on May 12th, 2013
How Do You Replace The Lightbulb In The Whirlpool Gh7208xrb Microwave?
The screw in the light bulb cover has no grooves for a screw driver to fit. I showed a picture of the screw at Home Depot and they had no idea what tool to suggest
Current Answers
Related Whirlpool GH7208XRB Manual Pages
Owners Manual - Page 1
If you should experience a problem not covered in the microwave oven.
All safety messages will tell you don't immediately ....whirlpool.com for additional information. You will follow the specific "PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY" found in this section and in the provided Installation Instructions.
■ Install or locate the microwave oven only...
Owners Manual - Page 2
....
■ Do not cover racks or any openings on sealing surfaces.
(c) Do not operate the oven if it has been damaged or dropped.
■ The microwave oven should not be overheated beyond... near water - Visible bubbling or boiling when the container is removed from the microwave oven is no damage to microwave energy.
This will cause overheating of electric shock.
■ Do not clean ...
Owners Manual - Page 3
... power supply cord is a visual picture of the estimated running time of the microwave oven cavity, behind the metal screen.
...bulb and a 500-watt quartz bulb. Progress Bar
The progress bar is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. It also shows instructions, tips and graphics. Observe all cord connected appliances: The microwave oven...
Owners Manual - Page 4
...steaming, or use the dish in the microwave oven.
4 Use the pan to catch the drippings. Convection rack
E. Steamer lid
Cookware and Dinnerware
Microwave-Safe ■ Browning dish (Follow manufacturer ... paper plates, napkins (Use non-recycled paper.) ■ Plastic wraps, bags, covers, dinnerware, containers (Follow
manufacturer recommendations.) ■ Pottery and clay (Follow manufacturer...
Owners Manual - Page 5
... following the prompts. Clean with your microwave oven.
Doneness is cool.
Microwave Oven Care
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are replaceable.
■ Cavity light: The cavity light bulb is located under the vent screen on the top of the microwave oven, under the vent screen on the top of the microwave oven, or one hour before sensor cooking...
Owners Manual - Page 6
... sealing surfaces are clean.
■ Frequency Some 2.4 GHz-based cordless phones and home wireless networks may be on during convection cooking
■ This is off .
www.whirlpool.com
Microwave oven will dissipate with some models), which may experience static or noise while microwave oven is being started. If the problem continues, call for 2 minutes at the...
Owners Manual - Page 8
...IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO...microwave oven opening, behind the door.
Service must be borne by a Whirlpool designated service company. Consumable parts are excluded from your home of repair or replacement under this limited warranty. This major appliance is designed to repair or replace appliance light bulbs...
Dimension Guide - Page 1
...outlet
VENTING REQUIREMENTS
Roof venting
roof cap
3-1/4" x 10" through-the-roof
Recommended standard fittings
Wall venting
wall cap 3-1/4" x 10" through-the-wall
Recommended vent length Use ...microwave oven hood. We recommend:
✔ using rigid metal vent. ✔ that length of vent and number of system you need, add the equivalent feet for planning purposes only. Because Whirlpool...
Installation Instructions - Page 1
...Tools and Parts 2 Location Requirements 2 Product Dimensions 3 Electrical Requirements 3 INSTALLATION INSTRUCTIONS 4 Remove Mounting Plate 4 Convert Microwave Oven...Microwave Oven 9 Install Filters 10 Complete Installation 10 VENTING DESIGN SPECIFICATIONS 11 ASSISTANCE 12 Replacement Parts 12 Accessories 12
MICROWAVE... instructions cover different models. All safety messages...
Installation Instructions - Page 2
... template
Mounting plate (attached to back of microwave oven)
Aluminum grease filters
Charcoal filters (Depending on model, charcoal filters may be combined. For external (wall or roof) venting, see "Replacement Parts" section. Vent deflector (for recirculation installation. Materials needed
■ Standard fittings for 1/4" x 2" lag screws
■ Scissors
■ 1½" (3.8 cm) diam...
Installation Instructions - Page 3
...¹⁄₂"
(39.4 cm)
Electrical Shock Hazard
Plug into an outlet that is properly grounded. Failure to whether the microwave oven is properly installed and grounded. Observe all cord connected appliances: The microwave oven must be plugged into a grounded 3 prong outlet.
In the event of an electrical short circuit, grounding reduces the risk...
Installation Instructions - Page 4
... with 2 mounting screws (1 on your model, the mounting plate may be used. When the vent deflector is as far back as shown in inset. Replace vent screen.
4 INSTALLATION INSTRUCTIONS
Remove Mounting Plate
Depending on each end). Tape the microwave oven door closed so that the wide side is to the work surface, cover the work...
Installation Instructions - Page 5
..., gently snip out the damper vent cover at this time. A
B C
A. Diagonal wire cutting pliers B. Perforations
3. Then secure with mounting screw.
Save the cover for possible change of microwave oven C. NOTE: Do not install damper assembly at the perforations. Mounting screw B. Locate the roof damper vent cover on the top of microwave oven C. Using diagonal wire cutting pliers, gently...
Installation Instructions - Page 6
...of preferred installation configurations with the mounting plate. Possible Wall Stud Configurations
These depictions show examples of the wall stud(s) within 6" (15.2 cm) of each stud,...opening , do not install the microwave oven.
1. See illustrations in "Possible Wall Stud Configurations."
2.
Mounting plate center markers
6
Holes for lag screws E. No Wall Studs at Corner ...
Installation Instructions - Page 7
...NOTE: The mounting plate must be installed on both bottom corners. 1. Mark Rear Wall
The microwave oven must be secured to the wall at both bottom corner holes.
NOTE: If the front ...wall stud, preferably 2, using either 1/4-20 x 3" round-head bolts and toggle nuts or 1/4 x 2" lag screws. Draw the 2 vertical, plumb lines down from the mark made in Step 3 of mounting plate.
7 Using ...
Installation Instructions - Page 8
...frame around the supply cord hole, as installed) has a partial wall covering (for No Wall Studs at Both Corner Holes (Figure 4)
1. Cut...Leave enough space for example, the thickness of the microwave oven. Insert lag screws into the remaining bottom corner hole. 6. Disconnect .... 8. Check alignment of mounting plate, making sure that fits over the 3/4" (19 mm) hole drilled in the ...
Installation Instructions - Page 9
... tilted, thread power supply cord through the power supply cord hole in
place. A
A
B
A. Place a washer on a covered surface. 8. Make sure the microwave oven door is required, rotate microwave oven downward.
Adjust mounting plate and retighten screws. 9. With the microwave oven centered, and with at least one corner of the shaded rectangular
area "F" on support tabs at the bottom...
Installation Instructions - Page 10
... screw. Install the filters by inserting the wide tab of the filter frame into the inner portion of the filter housing, then swinging the outside of the frame up until it fits ...B. Failure to damper assembly. Plug microwave oven into the slot on the turntable, and programming a cook time of the damper assembly slides into grounded 3 prong outlet. 2. Replace the fuse or reset the circuit ...
Installation Instructions - Page 12
... the microwave oven. When you call, you will need additional assistance, call us at our toll free number listed in the User Instructions.
Each panel is located behind the door. ■ Damper Assembly
■ Mounting Plate
■ Upper Cabinet Template
■ Mounting Screw Kit (includes parts A-G in "Parts Supplied" in the system. Replacement Parts...
Warranty - Page 1
...WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR ...home service is covered by an
authorized Whirlpool servicer is
contrary to use of consumables or cleaning products not approved by Whirlpool...replace appliance light bulbs, air filters or water filters. The cost of repair or replacement...microwave oven opening, behind the door. If you need assistance using your authorized Whirlpool...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Replacing the cooktop light on my SpeedCook microwave oven with convection
replace the cooktop light on my SpeedCook microwave oven with bare fingers. You will fit right and work right because they are made with the same precision used to remove the bulb cover mounting screw. Remove the burned-out bulb. Plug in my SpeedCook microwave oven with convection? FSP replacement parts will need to order replacement parts, we recommend that you need a TORX ᾠ... -
My TV, radio or cordless phone is interfering with my microwave oven
...or TV antenna. Is your cordless phone frequency 2.4 GHz? My microwave oven makes humming noises Lighting burners during oven operation. Some 2.4 GHz-based cordless phones and home wireless networks may experience static or noise while the oven is interfering with my microwave oven. Gas cooktops FAQs Knowledgebase search tips How to install or replace the water filter Animation- -
How do I replace the light bulb? - Bottom freezer/French door refrigerator
.../French door refrigerator How do I change the light bulb on my upright freezer? Replace burned-out bulb(s) with an appliance bulb no greater than 40 watts. To change the refrigerator light bulb: Unplug refrigerator or disconnect power. Not all appliance bulbs will fit your refrigerator. Make sure to access the light assembly. Replace the light bulb cover by Side with Ice Bin in...
Similar Questions
Meed To Replace Door On Microwave Hood Combination
Door Handle Is Broken And A Crack In Door.
Door Handle Is Broken And A Crack In Door.
(Posted by bettwheel702 7 years ago)
The Cover Plate In Top Of Oven Cavity Where Microwaves Enter Is Burnt.
can a replacement part be purchased? Will it just burn up again?
can a replacement part be purchased? Will it just burn up again?
(Posted by Anonymous-149470 9 years ago)
Unexplained Single Beep Sound Once/min From This Model Microwave, New 11/4/11
This unit is still emits a single beep eventhough it is unplugged.
This unit is still emits a single beep eventhough it is unplugged.
(Posted by joneswong1 9 years ago)
Gh7208xr Microwave Convection Oven
the screen will rapidly skip from onescreen to another and be beeping all by it's self. The machine ...
the screen will rapidly skip from onescreen to another and be beeping all by it's self. The machine ...
(Posted by narquiette 10 years ago)
Replacing Parts On Microwave, Is It Hard?
(Posted by rickatch 13 years ago)