Whirlpool DU1010XTXD Support Question

Whirlpool DU1010XTXD Support Question

Find answers below for this question about Whirlpool DU1010XTXD.
Need a Whirlpool DU1010XTXD manual? We have 5 online manuals for this item!

Current Answers

Related Whirlpool DU1010XTXD Manual Pages

Dimension Guide - Page 1

... instructions. Use a U.L.-listed or CSA-approved conduit connector. Water Supply Requirements: A hot water line with product. Water temperature must meet all surfaces have no protrusions that meets the wiring requirements for installing the power supply cord. Use a 90° elbow with dishwashers. Drain Requirements: A new drain hose is connected to use with ³⁄₈...

Installation Instructions - Page 2

... killed or seriously injured if you and others are not followed. Table of Contents Dishwasher Safety 2 Installation Requirements 3 Tools and Parts 3 Location Requirements 3 Product and Cabinet Opening Dimensions 4 Drain Requirements 5 Water Supply Requirements 5 Electrical Requirements 5 Installation Instructions 6 Prepare Cabinet Opening-Existing Utilities 6 Prepare Cabinet Opening...

Installation Instructions - Page 3

... (Part Number 8212560) Masking or duct tape NOTE: Parts available for installing underneath the countertop. Motor should not touch the floor. Shelter dishwasher and water lines leading to water, electricity and drain. • Convenient access for proper operation and appearance. • cabinet front perpendicular to floor. • level floor. (If floor at the end...

Installation Instructions - Page 5

... supply cord kit (Part Number 4317824) marked for your dishwasher. Water Supply Requirements • A hot water line with dishwasher. • Power supply cord must have: • 120-volt, 60 Hz, AC-only, 15- amp, fused electrical supply. • copper wire only. Drain Requirements • A new drain hose is resistant to heat and detergent, and fits the...

Installation Instructions - Page 6

... inside a cabinet next to the "Install Drain Hose" section. Existing utility hookups No existing utility hookups Water line Cable Prepare Cabinet Opening-Existing Utilities 1 Check water and electrical placement Water line (15.2 6" cm) Cable If the water line and the cable extend to the locations shown, proceed to the dishwasher cabinet opening. 1 Power Supply Cord-Drill...

Installation Instructions - Page 7

... or rear. Metal cabinet: Cover hole with grommet (Part Number 302797) included with grommet (Part Number 302797 not included) Hot water line Measure overall length of cabinet opening . Tape cable to the dishwasher should have a manual shutoff valve. 7 Drill hole Optional location PPrreferrreedd lolocactaitoionn (1.9 cm) Drill a ³⁄₄" (1.9 cm) hole in...

Installation Instructions - Page 8

... line Connect the ³⁄₈" compression fitting to the water supply line prior to installing the unit into the cabinet opening. Tape drain hose to the sink. 2 Route drain hose Drain hose Route drain hose as it does not touch the dishwasher base, frame or motor. 8 1¹⁄₂" (3.8 cm) If needed, drill a 1¹⁄...

Installation Instructions - Page 9

... of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Use pliers to disposer inlet with large silver drain hose clamp (provided). Attach drain hose to squeeze clamp open and move into position. Use pliers to...

Installation Instructions - Page 14

... keep them from tipping, open and close door If the door falls open, increase the spring tension by moving when dishwasher is near the center of the cabinet opening . 3 Check water and drain hose position If the door closes too quickly, decrease the spring tension by moving the spring end toward the front...

Installation Instructions - Page 15

... kink or pinch water line, drain hose, power supply cord or direct wire between dishwasher and cabinet. Do not remove insulation blanket - You may need to adjust alignment to be even with your cabinets. 9 Check for plumb and adjust legs if needed Place level against top front opening of dishwasher to raise dishwasher off the...

Installation Instructions - Page 16

... FAQ tab. Option B, Direct Wire: 1 Direct Wire-Route cable into the black drain hose connector up to catch any water in drain hose. Make Direct Wire Electrical Connection NOTE: If the power supply cord was connected earlier proceed to 16-gauge dishwasher wiring. 16 Select UL listed or CSA approved twist-on wire connectors...

Installation Instructions - Page 20

... that you press it to ensure exceptional cleaning. Selecting certain options could increase cycle time past 3.5 hours. Do not use less water and energy so they depend on ? Check that dishwasher is water in Canada, call . • Has the circuit breaker tripped or the house fuse blown? • Is the door closed within...

Owners Manual - Page 2

... more. The plug must be washed: 1) Locate sharp items so that has not been used for such a period, before using the dishwasher turn on all hot water faucets and let the water flow from service or discarding it will not fit the outlet, have a proper outlet installed by providing a path of the equipment...

Owners Manual - Page 3

... is closed detergent B container in better cleaning. STEP 2 Add Detergent ■ Use automatic dishwasher detergent only. Hard Water Soft Water Hard Water Soft Water C PRE- 1 Prepare and load dishwasher. Remove labels from containers before starting a cycle. ■ Fresh automatic A dishwasher detergent results in a cool, dry place. Main Wash section C. Mix other hard items...

Owners Manual - Page 4

... per U.S. Select Options (options vary by Full allowing water to drain off of the dishes after the final rinse. ■ Rinse aid helps to approximately 155°F (68°C). Repeatedly press the button until the water is hot. Sani Rinse - (use detergent. Certified residential dishwashers are locked. Press 4-hr Delay. Close the door firmly...

Owners Manual - Page 5

... the washer, screen, and screen holder or aerator for future use the thick washer. Attach the adapter onto the end of the dishwasher. Thin washer C. Screens D. Turn off the water. 2. A B C A. Failure to faucets with internal threads Insert the 2 screens, the thin washer, and then the thick washer from the faucet adapter kit...

Owners Manual - Page 6

... supply cord and return it if the dishwasher isn't draining well. Dishwasher Care Cleaning the Dishwasher Clean the exterior of powdered dishwasher detergent and water or use detergent. Put 2 cups (500 mL) white vinegar in a seasonal dwelling such as a second home or vacation home, avoid water damage by having your dishwasher winterized by turning the connector upside-down...

Owners Manual - Page 7

... website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call an electrician. Is there power to the dishwasher hot enough? Is the water supplied to the dishwasher? A delay automatically occurs in the covered section of the dispenser Is the cycle complete? Replace detergent if necessary. Is the dispenser...

Owners Manual - Page 8

..., grating, crunching or buzzing sounds A hard object has entered the wash module (on cookware with nonstick finish Has the dishwasher detergent removed cookware seasoning? Is the water temperature too low? Use recommended dishwasher detergents only. Detergent must be fresh to the covered section of fresh detergent? Use fresh detergent only. Is the pump...

Owners Manual - Page 9

... www.whirlpool.ca If you on the right-hand or left-hand side of the dishwasher interior. Expenses for travel and transportation for repairs. Proof of original purchase date is required...the customer. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. This major appliance is designed to be easily determined. Major appliances with the product,...

Whirlpool Knowledge Base Results

• How to position my dishwasher on a built-up floor
  ... installation for electrical, drain and water supply connections for dishwashers. NOTE: Shims must be securely attached to floor to the proper height. How to position my dishwasher on a built-up floor How to position my dishwasher on a built-up to prevent their movement when the dishwasher is being operated. Tilt the dishwasher backward to move...
• How to position my dishwasher on a built-up floor
  ... be securely attached to floor to prevent their movement when the is not level Recommended installation for electrical, drain and water supply connections for dishwashers . My Dishwasher door hitting countertop is being operated. How to position my dishwasher on a built-up to the proper height. Tilt the backward to move it into the opening without...
• My dishwasher is noisy or vibrates
  ... during operation to prevent noise transfer through drains. When the object is completely ground up, the sound should stop. This grinding will not start is a normal noise. The spray arms will circulate water against the inner door of the , creating a water sloshing sound.  My dishwasher is noisy or vibrates is noisy...

Similar Questions

Is All Of The Water Supposed To Drain Or Is Some Still Left After Washing?

(Posted by srworrell 10 years ago)

Whirlpool WDF310PAAW

Answers

Dishwasher Not Working
My whirlpool dishwasher model no. mdf530paym4 stops during normal wash cycle. Starts and washing lig...

(Posted by Angelojohn 10 years ago)

Whirlpool DU1010XTXD

Answers

Dishwasher Will Not Drain.
water will not drain out of dishwasher model# DU890SWKQO    

(Posted by bletourneau75 11 years ago)

Whirlpool DU1055XTVS - 24" - Dishwasher

Answers

Brand New ..1st Time It Ran, It Was Fine. The Second Time, The Water Won't Drain

(Posted by suecat1 11 years ago)

Whirlpool WDF750SAYW

Answers

Water Line
can i use my old water supply line. i is briaded and good shape

(Posted by karenogle1338 13 years ago)

Whirlpool DU1010XTXD

Answers