Vtech CS6429-2 Support Question
Find answers below for this question about Vtech CS6429-2.Need a Vtech CS6429-2 manual? We have 1 online manual for this item!
Question posted by andrthe on August 30th, 2014
Why Does My Vtech Phone Say Out Of Range Or No Power At Base When Its Right By
base
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Vtech CS6429-2 Manual Pages
User Manual (CS6429-2 User Manual) - Page 4
...45 Remote access 46
Appendix 47
Handset display screen messages 47
Handset and telephone base indicators 49
Battery 50 Expand your telephone system.......51 Add and register a handset ... safety instructions...........61 Precautions for users of implanted
cardiac pacemakers 62 Operating range 62 Maintenance 63 About cordless telephones 64 The RBRC® seal 64 Limited warranty 65 FCC, ...
User Manual (CS6429-2 User Manual) - Page 5
... cover
(1 for CS6429, 2 for CS6428-2 and CS6429-2, 3 for CS6429-3, 4 for CS6429-4 and 5 for CS6429-5)
Battery
(1 for CS6429, 2 for CS6428-2 and CS6429-2, 3 for CS6429-3, 4 for CS6429-4 and 5 for CS6429-5)
Telephone line cord Telephone base power adapter
Handset
(1 for CS6429, 2 for CS6428-2 and CS6429-2, 3 for CS6429-3, 4 for CS6429-4 and 5 for CS6429-5)
Telephone base
Charger and charger...
User Manual (CS6429-2 User Manual) - Page 6
....
To order a replacement, visit our website at www.vtechphones.com or call 1 (800) 595-9511.
Telephone base power adapter
Electrical outlet not controlled by a wall switch
Telephone line cord
Telephone base
Charger
• Use only the power adapters supplied with this product.
Electrical outlet not controlled by a wall switch
Telephone wall jack
Charger adapter...
User Manual (CS6429-2 User Manual) - Page 8
...power outage, the
handset will prompt you are on a call in low battery mode, the handset plays four short beeps every 50 seconds. The handset cannot be used .
For best performance, keep the battery charged, place it in the telephone base...for battery operating times. After you install your telephone or power returns following table summarizes the battery charge indicators and actions ...
User Manual (CS6429-2 User Manual) - Page 9
... with a standard dual-stud telephone wall mount plate. Plug the small end of the telephone base. Plug one from many hardware or consumer electronics retailers. Insert the extend tabs (marked B) of the telephone base. Route the power cord out of the bottom of the telephone and plug it into the slots (marked B) on...
User Manual (CS6429-2 User Manual) - Page 10
... cord are bundled, untie
them first. 2.
Unplug the end of the telephone line cord (or DSL filter) from the power outlet. 3. Unplug the power adapter from the telephone wall jack. See Telephone base and charger installation on page 2.
Slide the black wall mount bracket up and remove it from the wall mount bracket...
User Manual (CS6429-2 User Manual) - Page 11
When the phone is answering a call , or another telephone sharing the same line is not in use, press twice to delete all system...page 42).
On when the handset is in use, or the answering system is not in use , press to adjust the telephone base ringer volume (page 10).
/PLAY/STOP Press to delete the message currently playing (page 42).
Press to adjust the volume during message ...
User Manual (CS6429-2 User Manual) - Page 12
... 18, 27 and 34 respectively).
/FLASH
Press to make or answer a call , press to the right. TONE
Press to switch to tone dialing temporarily when using the dialing keys, press to mute the microphone...page 16). Getting started
Handset layout
CHARGE light On when the handset is charging in the telephone base or charger (page 3).
/VOLUME Press to the directory. Press to make or answer a call...
User Manual (CS6429-2 User Manual) - Page 25
...INT on your handset when not in the directory or call log, or is out of range, the originating handset shows UNABLE TO CALL. Your handset shows CALLING HANDSET X. Both handsets....
21
To answer the intercom call , press OFF/CANCEL or place the handset back in the telephone base or charger. Both handsets now show INTERCOM. The destination handset rings and its screen shows OTHER HANDSET IS...
User Manual (CS6429-2 User Manual) - Page 49
...messages recorded, or the total number of messages recorded. The telephone base speaker volume level while adjusting. The telephone base ringer level while adjusting. The answering system is full. The answering... 0-99 (flashing)
1-99 & F (alternating)
1-8 0-6 - - The telephone base may have lost and regained power.
The answering system is full with total number of old messages recorded.
User Manual (CS6429-2 User Manual) - Page 52
... charging. NO SIGNAL, CALL ENDED
NOT AVAILABLE AT THIS TIME
OUT OF RANGE OR NO PWR AT BASE
**PAGING**
PHONE
Communication between the handset and the telephone base is on a call log or answering system. The handset is lost communication with the telephone base.
The handset speakerphone is no messages in the answering system.
48...
User Manual (CS6429-2 User Manual) - Page 55
...before use . • To reset the telephone, unplug the power and the battery for about 60 seconds to the telephone base at a time.
51 For instance, if the telephone system... handset: 1. Each handset is assigned HANDSET 3. This telephone system accommodates up to the telephone base.
Each handset must be registered with your telephone system. The handset shows HANDSET REGISTERED and you...
User Manual (CS6429-2 User Manual) - Page 56
... on and starts to complete. Press OFF/CANCEL and place the handset back in the telephone base. -OR• Unplug the power from the telephone base, then plug it back in use.
52 To make deregistration easier, read all of a registered handset, you must press
/FIND HANDSET while the IN USE ...
User Manual (CS6429-2 User Manual) - Page 57
...power adapter is securely plugged into the telephone base and the
telephone wall jack. • Unplug the electrical power to purchase a new battery. • Disconnect the telephone base...Allow up to one minute for the cordless handset and telephone base to synchronize. • Charge the... and install the battery again. It may be out of range. • The telephone line cord may take up to ...
User Manual (CS6429-2 User Manual) - Page 59
... or other cordless telephones plugged into a different working telephone at the telephone wall jack.
Try installing your phone as far away as possible from these types of them to the base. Try installing your phone as far away as possible from these types of range. • Reset the telephone base by unplugging the electrical power to ring...
User Manual (CS6429-2 User Manual) - Page 62
...base. Place the handset in the telephone base and allow up to one minute for the handset and telephone base to the telephone base.
• Make sure the power...display, then your telephone has received a signal from your cordless phone. They are new messages (see Answering system new message ..., change the number of range. Disconnect the battery from your telephone service provider...
User Manual (CS6429-2 User Manual) - Page 65
... in performance. 13. The user should not plug the phone into a power outlet, and should not put the handset of the telephone base and handset are provided for cleaning. 4. industrial gases ... or cabinet outlet. Appendix
Important safety instructions
When using a telephone (other than cordless) during an electrical storm. Read and understand all warnings and instructions marked on an...
User Manual (CS6429-2 User Manual) - Page 66
... /FLASH. If the handset moves out of range, the handset displays OUT OF RANGE OR NO PWR AT BASE. Even so, this handset and telephone base can vary with pacemakers from the pacemaker. ... opposite the pacemaker. If there is a call . Operating range
This cordless telephone operates with the maximum power allowed by the U.S. Appendix
Precautions for users of implanted cardiac pacemakers
Cardiac ...
User Manual (CS6429-2 User Manual) - Page 68
... between the telephone base and the cordless handset by radio waves, so there is part of service within range of Rechargeable Battery Recycling Corporation.
64 VTech's participation in a...interference, do not place the telephone base of the cordless telephone near or on corded telephones.
• Electrical power: The telephone base of cordless telephone conversations as being as private...
User Manual (CS6429-2 User Manual) - Page 73
... digits and 15 characters Handset call log: 50 memory locations; Appendix
Technical specifications
Transmit frequency
Channels Nominal effective range Power requirements
Memory
Handset: 1921.536-1928.448 MHZ Telephone base: 1921.536-1928.448 MHZ
5
Maximum power allowed by FCC and IC. up to environment conditions at the time of use. Handset: 2.4V Ni...
Similar Questions
What Does It Mean When Phone Says Registration Failed Base Vtech 6429
(Posted by nabel 9 years ago)
Why Do My Vtech Says No Power At Base Or Out Of Range
(Posted by tannjpir 10 years ago)