Viper 5104 Support Question
Viper 5104 Support Question
Find answers below for this question about Viper 5104.Need a Viper 5104 manual? We have 1 online manual for this item!
Question posted by Hustle on November 18th, 2013
How Do U Turn Off Da Blue Light On My Viper Model 5104
The person who posted this question about this Viper product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Viper 5104 Manual Pages
Owner Manual - Page 2
Please visit the below website: http://www.viper.com -
For general and additional guide information. s Two 1-way SuperCode remote controls s Owner's guide s Warranty card
AUX A U X
AUX A U X
OwGnueidr'es
Warranty Card What you need. ...
Owner Manual - Page 9
...a Command button. The system will arm, lock the doors and flash the parking lights without siren chirps.
6
© 2010 Directed Electronics. Confirmations for Basic or Advanced commands are... performed by siren chirps and parking light flashes.
Press the button while the transmit LED is found in the following Basic...
Owner Manual - Page 11
... (if connected), and the siren chirps and parking lights flash twice. To Arm and Panic Press and hold The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds the siren and flashes the parking lights. Press the or button to arm the alarm normally. Exit Valet mode to stop the output...
Owner Manual - Page 12
... 2 seconds.
* See Remote and System Operations for details. ** See Alarm Features for details. *** See Remote Start Faults (under Remote Start Features) for more details.
© 2010 Directed Electronics. All rights reserved.
9 The engine and parking lights turn On, or the engine and parking lights turn Off accordingly. If a Remote start configuration issue prevents...
Owner Manual - Page 13
All rights reserved. Advanced Commands: (Level 1)
Press and release the button 1 time. Silent Disarm
Press and release The alarm disarms, doors unlock (if connected), and the parking lights flash twice.
The transmit LED illuminates in sets of single flashes to the pre-programmed setting. The Silent Disarm output may be On...
Owner Manual - Page 14
... in sets of impact only. Sensors are
fully operational. The Control Center LED turns on and off : The Parking lights flash 1 time.
Remote Valet
Press and release
Enters (or if On...Directed Electronics. Sensors will incrementally bypass sensor operations and be activated for any time to turn Sensor Bypass Off. All rights reserved.
11 Sensor Bypass
Press and release
Performing the...
Owner Manual - Page 15
Timer Start*
Press and release
Activates (or if On, deactivates) Timer Start. The parking lights flash quickly four times for On and slowly four times for more details.
12
© 2010 Directed Electronics.
AUX 2
Press and release AUX
Activates (...
Owner Manual - Page 16
Sensor Silent Arm*
Press and release The alarm arms, doors lock, and the siren chirps and parking lights flash 3 times.
The parking lights flash quickly five times for On and slowly five times for 10 seconds. Car finder
Press and release The siren emits one long chirp and the parking...
Owner Manual - Page 17
....
* See Alarm Features for more details. ** This feature must be installed and turned on by an... authorized Directed dealer.
14
© 2010 Directed Electronics. Note Remote Start must be active to indicate Level 4. For convenience, the Defogger circuit will also automatically activate 10 seconds after remote starting if the temperature is activated and the parking lights...
Owner Manual - Page 18
... time and the siren will chirp once to indicate the Main Menu is exited the transmit LED turns off .
© 2010 Directed Electronics. The status
LED will exit if: s Step 7 is...seconds s The doors are closed s The ignition is ready for 8 seconds, the transmit LED turns on
the Control Center. 4. Turn the key to a previous menu, press and release the button. Release the Control button and...
Owner Manual - Page 21
... input will activate the Full Trigger output. Minor impacts causes the system to the vehicle exterior.
Alarm Features
Normal Arm Protection
Status LED: The Control Center Status LED flashes as a visual ... the hood or trunk causes a Full Trigger output, while opening a Door or turning on the Ignition causes the the siren to disarm and silence the siren in a Full Trigger output.
Owner Manual - Page 22
...self correct (dome light turns off) it becomes active and is disarmed. Turn the ignition On.... 2. Note As a precaution, if programmed for 30 seconds. Faulty zones (usually caused by remote command the system runs a status check of the alarm trigger zones.
Sensor Warn-away output
When the system sensors detect a Warn-away trigger the siren chirps and parking lights...
Owner Manual - Page 23
...turned on.
* See Nuisance Prevention (NPC) for more details. Zone # (led flashes) 1 2 3 4 5 6
Table of Zones).
All rights reserved. Alarm Report
If the alarm was triggered while armed, it is bypassed. The siren chirps 4 times (or 5 times if NPC On*), the parking lights... output will be reported when the alarm is disarmed via siren chirps, parking light and control center LED flashes...
Owner Manual - Page 24
...engine running during short trips into the house or convenience store. Turn the key to be driven. Exit the vehicle and arm the alarm. Key Takeover
When you are ready to the run position, ... Transmission Start (MTS mode) section. Note For Pit Stop on .
3. Press the button, the parking lights will turn off . 4. To perform Pit Stop:
1. To perform Key Takeover: 1. The vehicle is ready to ...
Owner Manual - Page 27
... the doors and arm the system. 6. button on the remote, after 20 seconds return to run. Turn Off and remove the key from the ignition switch, the engine
remains running , set the parking brake. 2.
The parking lights turn on by remote control or optional dash mounted activation button. 1. tion outputs. 4. The engine runs...
Owner Manual - Page 28
... Flashes * 5 6 7
Possible Fault Brake on Disarm or reset alarm
* Refers to the table below for the command type and parking light flashes that will not activate. Refer to the number of...Timer Start or Smart Start command
Toggle Switch off
Alarm is triggered
Solution Release foot brake Close hood Enable MTS mode
Check all Solutions
Turn switch on
Hood open
After performing Remote Start ...
Owner Manual - Page 29
...not opened within 30 seconds the system re-arms itself and locks the doors. Onetime Bypass*
Turn the ignition On for one cycle. It also bypasses the comfort closure and auxiliary channel outputs ...the Passive arming operation for one -time bypass is not entered after disarming by remote, the alarm automatically re-arms itself . The led flashes quickly and upon reaching 20 seconds the ...
Owner Manual - Page 30
... 2. The control center LED turns On when entering and Off ...and hold for programming. Once the car is On the LED turns off .
Car Select
Car 2 remote control option must first be turned On (See Remote Control Confi...Directed Electronics. The LED flashes once or twice to indicate the selected Car is turned off after 24 hours. If Armed the flashing is reduced after 1 ...
Owner Manual - Page 31
...adjustment, siren chirps, passive arming, remote button auto unlocking, alarm output duration can be configured to match the remote...for added security during disarming.
* These features must be turned on by an authorized Directed dealer.
28
© 2010 ...OEM convenience feature. System Expansion Options
Controlling two vehicles (Car Select) The remote controls can be configured for...
Owner Manual - Page 33
With the front and circuit board still turned over, turn back portion of the following United States patents:
Remote Start Patents: 5,349,931; 5,872,519; 5,914,667...please do so in accordance with your municipal requirements for battery disposal or return to Directed Electronics at: One Viper way, Vista, CA 92081 (Shipping and/or handling costs are the sole responsibility of the owner/sender and ...
Similar Questions
Bought Suv No Crank No Start Find Out It Has Viper 350hv Alarm How. To Disable
(Posted by jolivas18 9 months ago)
I Have The Viper 3105v, Put A New Ignition Switch In, Charged Battery. All Light
Come on except interior doom light. Turn key got dash lights, no start. What do I do.
Come on except interior doom light. Turn key got dash lights, no start. What do I do.
(Posted by Darrylpruitt840 1 year ago)
Viper Car Alarm
my remote will not /unlock the door or enable the ignition
my remote will not /unlock the door or enable the ignition
(Posted by jbggkm 9 years ago)
Silent Mode
is there a way to put my 3105v viper car alarm in silent mode when arming my system
is there a way to put my 3105v viper car alarm in silent mode when arming my system
(Posted by maldi20s 10 years ago)
Out Of Range Fault Tone Problem
hey my alaram viper 5704 remote is indicating the out of range fault tone on the remote for the past...
hey my alaram viper 5704 remote is indicating the out of range fault tone on the remote for the past...
(Posted by suthakks 11 years ago)