Troy-Bilt TB675 Support Question
Troy-Bilt TB675 Support Question
Find answers below for this question about Troy-Bilt TB675.Need a Troy-Bilt TB675 manual? We have 1 online manual for this item!
Question posted by herjeac on August 11th, 2013
Oil For Troy-bilt Tb675
what kind of oil should I put in my Troy-Bilt TB675
Current Answers
Related Troy-Bilt TB675 Manual Pages
Operation Manual - Page 1
... to make changes at the time of authorized service dealers near you. Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB675 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20
SAVE THESE...
Operation Manual - Page 4
...a full face shield when needed.
• UNLEADED FUEL Always use clean, fresh unleaded fuel.
• OIL Refer to the operator and/or bystanders.
• WEAR EYE AND HEARING PROTECTION
WARNING: Thrown objects and ...loud noise can be used in serious injury to operator's manual for the proper type of oil.
• DO NOT USE E85 FUEL IN THIS UNIT
WARNING: It has been proven that may...
Operation Manual - Page 5
...On/Off Switch
Handle Shaft Housing
Air Filter Cover
Throttle Control
Fuel Cap Choke Lever
Coupler
Oil Fill Plug
Cutting Head
Cutting Head Shield
Line Cutting Blade
SPECIFICATIONS*
Engine Type Air-Cooled, ...025 in. (0.635 mm) Spark Plug Champion® RDZ4H or equivalent plug Lubrication SAE 30 Oil Crankcase Oil Capacity 2.03 oz. (60 ml) Fuel Tank Capacity 12 oz. (355 ml) Approximate ...
Operation Manual - Page 8
... to measure the
correct amount of the oil bottle. OIL AND FUEL
USING THE RIGHT OIL
Use a high-quality SAE 30 weight oil. Check the oil level before starting the unit.
Unscrew the top of oil during future oil changes. cycle engine. Reinstall the oil fill plug. Unscrew the oil fill plug (Fig. 7). 5. Pour the entire bottle into the...
Operation Manual - Page 9
... tank. ALWAYS use of old fuel is extremely flammable.
Using Fuel Additives Use a fuel additive, such as 1% water in the fuel can make fuel and oil separate, forming acids when stored.
FUELING THE UNIT
WARNING: Gasoline is the most common cause of old fuel according to the unit's fuel tank. Never...
Operation Manual - Page 10
...Position 1 (Fig. 10).
5. Starter Rope Grip
Starting Position
Throttle Control
Fig. 11
10
Check the oil level. Refer to 8 times. Squeeze the throttle control (Fig. 8) and pull the starter rope with... 3.
Pull the starter rope with a controlled and steady motion 3 to 5 times to Checking the Oil Level.
2. Then move the choke lever to restart the engine. The unit may be used during ...
Operation Manual - Page 11
... of this feature. Release the throttle control and allow the engine to Checking the Oil Level.
2. USING THE ELECTRIC START ACCESSORY
This unit can be started with step ... (Fig. 9).
4.
Fig. 12
Electric Start Port
STOPPING INSTRUCTIONS
1. Item No. Check the oil level. Insert the electric start accessory into the electric start . Run the electric start accessory (items...
Operation Manual - Page 13
...Arrows
Fig. 17 Always allow the unit to Maintaining the Air Filter.
• Change the oil. These procedures should also be performed by
an authorized service dealer. • Check the spark...line until about these required maintenance procedures at 38 hours
MAINTENANCE REQUIRED
• Clean and re-oil the air filter. Turn the bump knob counterclockwise to wind the line until the ends are...
Operation Manual - Page 14
...holes on a flat, level surface, such as a workbench or
table.
CHECKING THE OIL LEVEL
WARNING: OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. use . Refer to clean... crankcase. 4.
Remove the spool cover (Fig. 18). 3. Check the oil level before each use a flashlight if necessary. Inspecting the Oil Level Window 1. Stop the engine and allow it to prevent debris
from the...
Operation Manual - Page 15
...Cover
Air Filter
Fig. 23
Cover Screw
15 Fill the oil bottle to improper air filter maintenance is still warm. Reinstall the oil fill plug.
Unscrew the cover screw completely. Rinse the... serious personal injury, always stop
the engine and allow it to dry. 4. CHANGING THE OIL
Change the oil while the engine is not covered by the product warranty. NOTE: DO NOT overfill. Refer...
Operation Manual - Page 17
...; Allow the engine to federal, state and local regulations.
17 Reinstall the spark plug.
4. Preparing the Unit for any high quality motor oil into an approved container. Change the oil. Store the unit in a dry, well-ventilated area. • Store the unit out of the reach of any loose or damaged parts...
Operation Manual - Page 18
... ADVANCE LINE The cutting head is bound with grass The cutting head is out of the cutting head
THE CUTTING LINE ADVANCES UNCONTROLLABLY There is oil, cleaner or lubricant in the cutting head
Clean and thoroughly dry the cutting head
If further assistance is extended
Stop the engine and clean the...
Operation Manual - Page 20
...
20 To locate the dealer in your warranty as a gift. Damage resulting from the sales. Troy-Bilt reserves the right to change or improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to temporarily replace...
Similar Questions
Troy-bilt Tb675 Overheating
My Troy-Bilt TB675 overheats after running for a short time. Is this common with these models ?
My Troy-Bilt TB675 overheats after running for a short time. Is this common with these models ?
(Posted by Anonymous-154291 8 years ago)
Why Does My Troy Built Trimmer Tb675 Ec Overheat ?
(Posted by Anonymous-154291 8 years ago)
How To Rewind Pull Cord On Troy Built Model Tb675 Ec
(Posted by jake5070 10 years ago)