How To Install Mud Flaps?

http://www.instructables.com/id/How-to-install-Splash-Guard-Mud-Guard/

Thanks

1. Make sure the wheel well and installation area where you plan to attach your new mud flaps is clean and clear of dirt, grime and debris.
2. Turn your front wheels all the way to the left to maximize the clearance in-between the tire and the wheel well.
3. Next turn your mud flaps over to see where they are marked on the back. They should be marked L or LH for the left side and R or RH for the right hand side. The left hand side of the vehicle is always the drivers side.
4. The mounting holes used will be the ones that are currently factory drilled on your vehicle located in your wheel well. Remove the screws that are currently there, but hold onto them.
5. With the screw removed, move your mud flap into place. You'll notice it fits perfectly to the contours of your vehicle.
6. Without fully tightening, reinstall the screws into the holes from which you removed them. This attaches them to the wheel well.
7. Take any additional screws and washers provided with the mud flap and attach them to the mud flap and screw them into any remaining holes left open.
   • NOTE : Do not forget to insert any hex nuts between the mud flap and wheel well if those nuts were provided with your kit
8. Before tightening your mud flap, adjust your mud flap to the angle you want it to be positioned.
9. Tighten the screws.
10. If your mud flap comes with additional holes and there is no available spot on your truck for a screw to enter, you will need to drill these holes out if you wish for extra stability.
11. Follow steps 6-9 to complete the additional holes.
12. Repeat steps 3-9 as needed for remaining mud flaps.