Tecumseh Products OH195EA Support Question
Tecumseh Products OH195EA Support Question
Find answers below for this question about Tecumseh Products OH195EA.Need a Tecumseh Products OH195EA manual? We have 1 online manual for this item!
Question posted by donhol on June 15th, 2020
Valve Settings For Oh195ea Thank You
would someone please post the valve settings for OH195EA engine.Thank You
Current Answers
Answer #1: Posted by Odin on June 15th, 2020 8:28 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.manualslib.com/manual/1092563/Tecumseh-Oh195ea.html?page=7&term=valve&selected=3.
If the issue persists or if you require further advice--or if these instructions don't seem to apply to your model--you'll have to consult the company. (Use the contact information at https://www.contacthelp.com/tecumseh%20products/customer-service.)
If the issue persists or if you require further advice--or if these instructions don't seem to apply to your model--you'll have to consult the company. (Use the contact information at https://www.contacthelp.com/tecumseh%20products/customer-service.)
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Tecumseh Products OH195EA Manual Pages
Operator Manual - Page 1
...XII. How to Get Service 3 III. Before Starting Your Engine 4 V. Warranty Information 22
Visit our web site at www.TecumsehPower.com
LOG ON! Starting Your Engine 6 VI. Storing Your Engine 14 X. Operator's Manual
OH195EA/OH195XA (OHH50-65) OH195EP/OH195XP
Four-Cycle Engine • Horizontal Crankshaft • Air-Cooled
Table of Contents
IMPORTANT NOTICE! Safety Definitions ii...
Operator Manual - Page 2
... safety instructions. Follow these basic rules for additional information. TecumsehPower Contact Information
For engine adjustments, repairs or warranty service NOT covered in any way with California and U.S.... and wear the appropriate safety equipment.
IMPORTANT NOTICE!
Notice Regarding Emissions
NOTE Engines which , if NOT avoided, may include the following words and graphics are...
Operator Manual - Page 3
.... Maintenance" instructions on page 14. Avoid Accidental Starts" instructions on this engine.
Consult your engine; Deadly levels of carbon monoxide can result in fuel tank inside a building... with potential sources of carbon monoxide poisoning, leave the area immediately, get fresh air, and...
Operator Manual - Page 4
...; Keep the disconnected spark plug wire securely away from hot areas of engine governor.
! H.
WARNING
Use of this engine on fun-carts, go-karts, or mini-bikes can lead to operate at negative terminal first, if engine is equipped with factory setting of engine. Consult your local Authorized TecumsehPower Servicing Dealer, call 1-800-558-5402...
Operator Manual - Page 5
.... See Figure 5.
This handbook covers repairs and adjustments not covered within this Operator's Manual, and it is located in the next column and indicates the engine's model number, specification and date of manufacture (DOM). Technician's Handbook Table 1. Visit our web site at 1-800-558-5402 for individuals who practice proper tool...
Operator Manual - Page 6
... • Insure oil fill cap/plug is marked A.P.I. Page 4
Table 2. Primer 3. Fuel Fill Cap 7.
B.
Check oil level more frequently during engine break-in
TecumsehPower engines.
Carburetor 2. Muffler 4. Air Cleaner
Figure 8. For recommended engine oil, see Table 1 on dipstick. Using multigrade oil above 32°F (0°C) will not be fresh and clean. Fuel
Use...
Operator Manual - Page 7
... fill plug go to step 1. Afterward, continue reading instructions below .
1. Failure to avoid spilling. Avoid creating any source of spillage. Stop engine and allow fuel to avoid spilling.
5. Be sure fuel valve, if present (see "I . See Figure 10. 6. Unscrew and remove oil fill cap or oil fill plug from oil filler tube...
Operator Manual - Page 8
... put flammable liquids into carburetor or onto air cleaner.
• DO NOT operate engine or pull on page 8. Table 3. See Figures 11 and 12.
Starter Cord Handle 9. E. Fuel Fill Cap 7. Optional Fuel Valve
Some engines are experienced and capable of starter you have . See Table 3. D. Starting Your Engine
WARNING To avoid serious injury or death...
Operator Manual - Page 9
...is moved to "NO CHOKE" position, repeat steps 2 thru 5 to "FAST" position. Figure 14. If engine dies after 3 attempts repeat steps 2 thru 5 and try again.
7.
Push starter button or turn ignition switch... "NO CHOKE" position:
a. II. To avoid carbon monoxide poisoning, be sure engine is moved to restart a warm engine after 3 attempts in any other way.
181-1032-14
Page 7 Move choke ...
Operator Manual - Page 10
... start after a short shutdown. Afterward, continue reading instructions below. Table 4. Pull rope out slowly until you have a manual recoil starter, see equipment manufacturer's instructions) or engine throttle control to :
Section B.I Section B.II
I. NOTE Following the instructions listed in a well-ventilated area.
2.
DO NOT attempt to the recoil mechanism.
5. See Figure 16...
Operator Manual - Page 11
... after following steps 1 thru 7, contact your Authorized TecumsehPower Servicing Dealer. WARNING
When pulling starter rope, the rope can unexpectedly jerk back toward
engine causing serious injury. Move engine choke lever to restart engine.
8. See Figure 19.
NOTE Following the instructions listed in the "NO CHOKE" position, repeat steps 2 thru 6 to "FULL CHOKE" position. a.
Operator Manual - Page 12
... away from the lowest point on page 2. Clean area around oil drain plug. See Figure 20.
5. Possible Oil Drain Plug Locations
Figure 21.
Tip engine to the grounding post, if provided.
3. See Figure 21. Afterward, continue reading instructions below .
• Change oil after first 2 operating hours and every 25 operating hours thereafter...
Operator Manual - Page 13
...; Pitted
• Burned
• Fouled with wire feeler gauge and set
gap to be used in warm water and detergent solution then press (DO NOT twist) until water is removed.
2. Cleaning/Replacing Air Cleaner
Your engine has an air cleaner which helps prevent premature engine wear and failure.
NOTE Contact your Authorized TecumsehPower Servicing Dealer...
Operator Manual - Page 14
...°F (0°C)
1. NOTE DO NOT put oil on base. 8. Remove wing nut and air cleaner cover. Anti-Icing Baffle
Some engines may be replaced once a year or every 100 operating hours; Remove air cleaner cover from inside of base and air cleaner cover thoroughly. 5. Removal and Installation of 32°F (0°C) and Below 1. Install...
Operator Manual - Page 15
... available suction device designed for emptying the fuel tank before transporting:
1. Tampering with factory setting of a pickup truck. VIII.
If there is fuel in the fuel tank, close the fuel shut-off valve, if equipped, and transport the engine upright in any enclosed
space if there is consumed. If adjustments are satisfactory for...
Operator Manual - Page 16
... instructions below . Page 14
181-1032-14 II. Afterward, continue reading instructions below . Also, if it is running engine until the remaining fuel is stored in the following areas:
• Cooling Fins • Air Intake Screen • Levers • Linkage Area • Guards • Carburetor • Head Removing debris will insure adequate...
Operator Manual - Page 17
... key, if provided.
2. Connect spark plug wire to spark plug before attempting to Step 6.
5.
See "A. II. To
prevent serious injury from grounding post, if provided.
9. Squirt 1oz. (30 ml) of clean engine oil into spark plug hole.
4. Grasp starter cord handle:
a. Oil
Change oil if NOT changed within the last 3 months. For...
Operator Manual - Page 22
... Service Dealer, TecumsehPower Authorized Service Distributor or TecumsehPower Central Warehouse Distributor) as soon as the carburetor, air cleaner assembly, ignition system, exhaust system, crankcase breather assembly and, the evaporative control system.
EPA regulations for New TecumsehPower Engines and Electronic Ignition Modules. OWNER'S WARRANTY RESPONSIBILITIES As the small off -road...
Operator Manual - Page 23
... sufficient to meet the expected demand for the remainder of a TecumsehPower engine caused by TecumsehPower Company according to the owner. Unapproved add-on or...replaced by the ECS Warranty.
7. EMISSION-RELATED PARTS INCLUDE THE FOLLOWING: 1. Air Cleaner Assembly including components: a) Air filter element
3. Evaporative Control System including components: a) Fuel line(s) b) Fuel...
Operator Manual - Page 24
..., to cause cancer, birth defects or other than as set forth herein. WARNING
CALIFORNIA PROPOSITION 65
The engine exhaust from state-to follow the instructions contained in connection with ... service can be DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP. One letter in any of new TecumsehPower engines or parts or by normal wear, accidents, improper maintenance, improper use " shall mean consumer's...
Similar Questions
I Have A Tecumseh Oh195ea On A Tiller.
(Posted by Anonymous-166396 3 years ago)
Tecumseh Lv195xa Fly Wheel Setting
I have a Tec LV195XA and need to know if there's a torque setting for the flywheel screw and what th...
I have a Tec LV195XA and need to know if there's a torque setting for the flywheel screw and what th...
(Posted by fern5303 9 years ago)
Solid State Ignition
What is the proper gap setting between the Solid State Ignition module and the flywheel?
What is the proper gap setting between the Solid State Ignition module and the flywheel?
(Posted by rldiebold 10 years ago)
Diode For A Riding Mower
Hi i have a bad diode on my riding mower and want to replace but the 2 companies in town don't have ...
Hi i have a bad diode on my riding mower and want to replace but the 2 companies in town don't have ...
(Posted by travellinman555 10 years ago)
Oil For Tecumseh Lawn Mower Model Lv148ea
MY LAWN MOWER DIP STICK IS AT THE "ADD" MARK. Please tell recommended oil. What is risk for using co...
MY LAWN MOWER DIP STICK IS AT THE "ADD" MARK. Please tell recommended oil. What is risk for using co...
(Posted by dennismiller 10 years ago)