Home » Suzuki » Troubleshooting » 2011 Suzuki Grand Vitara

Get support for 2011 Suzuki Grand Vitara

2011 Suzuki Grand Vitara Support Question

Find answers below for this question about 2011 Suzuki Grand Vitara.
Need a 2011 Suzuki Grand Vitara manual? We have 1 online manual for this item!

Suzuki Overview Questions Manuals Reviews Videos Research

Question posted by rdcbe on April 3rd, 2014

How Do You Turn Dash Brightness Up In A Suzuki Grand Vitara

The person who posted this question about this Suzuki automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 1

... clutch fluid: DOT3 Automatic transmission fluid: SUZUKI ATF 3317 or Mobil ATF 3309 Tire cold pressure: See the "Tire Information Label" located on the driver's door lock pillar. 2010 OWNER’S MANUAL Keep With Vehicle At All Times. Contains Important Information On Safety, Operation & Maintenance. GRAND VITARA 99011-79K21-03E Part No. 99011...

Owner's Manual - Page 2

This owner's manual applies to the GRAND VITARA series: 79K035 NOTE: The illustrated model is one of Suzuki Motor Corporation. 79K21-03E No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of the GRAND VITARA series. © 2009 All rights reserved.

Owner's Manual - Page 5

... or durability and may not be covered under warranty. This sound is turned off. This check is performed approximately five hours after the engine is ...may cause electronic interference with your vehicle's ignition system, resulting in vehicle performance problems. Consult your SUZUKI dealer or qualified service technician for leaks. LEAK DETECTION PUMP NOTE: Your vehicle has a pump...

Owner's Manual - Page 17

... ...2-54 Warning and Indicator Lights ...2-55 Speedometer ...2-65 Tachometer ...2-65 Fuel Gauge ...2-65 Temperature Gauge ...2-66 Brightness Control ...2-66 Information Display (if equipped) ...2-67 Lighting Control Lever ...2-75 Front Fog Light Switch (if equipped) ...2-78 Turn Signal Control Lever ...2-78 Hazard Warning Switch ...2-79 Windshield Wiper and Washer Lever ...2-79 Tilt Steering...

Owner's Manual - Page 22

...out immediately. When the doors are locked after the "UNLOCK" button (2) is operated, the doors will turn signal lights will flash twice. • If the interior light switch is in the "DOOR" position... programming procedure yourself according to have your dealer program the new remote controller code in your SUZUKI dealer as soon as radio towers or CB (Citizen's Band) radios. • The ...

Owner's Manual - Page 25

... you open a door other than the driver's door and lock the front passenger's door by turning the lock knob forward or pushing the power door locking switch, the driver's door will be ... ignition switch in the vehicle under the following conditions, a buzzer sounds intermittently for your SUZUKI dealer for details. • The battery life of the vehicle other than the rear luggage...

Owner's Manual - Page 27

... program a new remote controller, you should change the remote controller code in your SUZUKI dealer. • Before you don't complete steps 1 through 6 described below within...driver's door to the "LOCK" position. Repeat step 1 two more times. 6. To start the engine, turn the ignition switch to the lock position. 4. NOTE: You cannot program the remote controller if you begin ...

Owner's Manual - Page 28

...: 3, 5, 8 BEFORE DRIVING 7) To complete programming, remove the key from the ignition switch or turn the ignition switch to the "ON" position. 8) Make sure that the Industry Canada technical specifications were... in your vehicle's memory, you should change the old remote controller codes in your SUZUKI dealer. Operation is not programmed at the same time. If you still cannot operate ...

Owner's Manual - Page 29

... programming procedure yourself according to the instructions in the "DOOR" position, the interior light will turn signal lights will blink for more than 1 second. Be sure to cancel the "PANIC"...If no door is inserted in the ignition switch and turn to the "ON" position to have your dealer program the new transmitter code in your SUZUKI dealer as soon as possible for a replacement. Press ...

Owner's Manual - Page 30

...Turn the ignition switch to applicable rules or regulations. Programming/removing a transmitter code yourself Your new vehicle was originally equipped with the transmitter. 5) Dispose of the transmitters, you try to program a fourth code, the oldest code will lock/unlock to three transmitter codes into your SUZUKI... 3 times, insert the key, and turn the ignition switch to the "LOCK" ...

Owner's Manual - Page 60

... WARNING This section of a collision. Please read and follow ALL these two conditions may not work on your SUZUKI. They are activated), have the pretensioner system serviced by an authorized SUZUKI dealer who is turned to the "ON" position, stays on for at least 90 seconds before performing any electrical service work properly...

Owner's Manual - Page 62

Have the air bag system inspected by an authorized SUZUKI dealer as soon as possible. 63J259 EXAMPLE 60G032 Front air bags are molded into the air bag covers ... driver's front air bag is located behind the center pad of the steering wheel and the front passenger's front air bag is first turned to the "ON" position, or the "AIR BAG" light stays on, or comes on while driving, the air bag system (...

Owner's Manual - Page 68

... on both sides of the front passenger's seat. WARNING If the "PASS AIR BAG OFF" indicator on the instrument panel turns on the seat cushion. The air bag inflates and deflates so quickly that you replace them, the air bags and front ...• Objects placed under the front seat. • Have front passenger's sensor mat inspected by an authorized SUZUKI dealer as soon as possible.

Owner's Manual - Page 73

...specified in the "EMERGENCY SERVICE" section. Check and adjust your vehicle inspected by an authorized SUZUKI dealer. Refer to "Tire Pressure Monitoring System" in a safe place as soon as ...'s manual. Have your tire inflation pressure at lower inflation pressures. Even if the light turns off after subsequent vehicle start-ups as long as possible. The low tire pressure warning ...

Owner's Manual - Page 74

... normal periodic maintenance. 65D477 This light comes on briefly when the ignition switch is turned to inspect the brake system. • If the brake system warning light does not...comes on while you determine that there is adequate. The light should immediately ask your SUZUKI dealer to the "ON" position. BEFORE DRIVING section for information on the shoulder of the following conditions...

Owner's Manual - Page 75

...the ESP® systems (other than ABS). You should have the system inspected by an authorized SUZUKI dealer. If one of the following systems is a registered trademark of the ESP® systems, ...SLIP Indicator Light" in the "OPERATING YOUR VEHICLE" section. 79K019 65D529 When the ignition switch is turned to the "ON" position, the light comes on briefly so you can check that has no ...

Owner's Manual - Page 76

...The information display shows the warning and indicator message when this light comes on . NOTE: • If the vehicle speed is turned to "Electronic Stability Program (ESP®)" in the "OPERATING YOUR VEHICLE" section. 2-59 79K21-03E When the ignition switch is... than ABS) will not be canceled automatically. You should have the system inspected by an authorized SUZUKI dealer.

Owner's Manual - Page 83

...You can result in the "ON" position, this light comes on. To increase the brightness of the instrument panel lights, turn the brightness control knob (1) clockwise. To reduce the brightness of the instrument panel lights, turn the brightness control knob (1) counterclockwise. Temperature Gauge Brightness Control CAUTION Avoid driving with an extremely low fuel level. Under normal driving...

Owner's Manual - Page 84

... (A) A/T selector position indicator (for automatic transmission) Display (B) Warning and Indicator Messages/Fuel Consumption/Driving Range/Average Speed 79K062 NOTE: • If you do not turn the brightness control knob within about 5 seconds of the instrument panel lights will appear on the display for several seconds. • Some warning and indicator messages may...

Owner's Manual - Page 307

... the vehicle with the discharged battery (1). If the Starter Does Not Operate 1) Try turning the ignition switch to the "START" position with the booster battery. Have the vehicle...free axle mechanism, etc.) prevent normal use of the towing procedures for your authorized SUZUKI dealer. engine hook (3)) of the engine of the booster battery (2). 3. Towing ... remain bright, check the fuses.