2010 Suzuki Kizashi Support Question
2010 Suzuki Kizashi Support Question
Find answers below for this question about 2010 Suzuki Kizashi.Need a 2010 Suzuki Kizashi manual? We have 1 online manual for this item!
Question posted by clmoe715 on March 7th, 2014
Is It Hard To Change A Headlight On A Kizashi
The person who posted this question about this Suzuki automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 2
No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of the KIZASHI series. This owner's manual applies to the KIZASHI series:
57L1F001
NOTE: The illustrated model is one of Suzuki Motor Corporation.
© 2009
All rights reserved.
Owner's Manual - Page 3
..., your concern, and any obligation to make the same or similar changes to assist you are temporarily operating your vehicle. When we receive your correspondence, we encourage every... vehicle owner to make production changes at any time, without notice and without incurring any other changes, there may have a question or problem regarding the warranty ...
Owner's Manual - Page 26
...than 1 second; If you operate the "LOCK" button (1). Be sure to have changed to cancel the "PANIC" mode. The headlights and taillights will blink for a replacement. If any button (PANIC, LOCK, UNLOCK...signal lights will be operated with the remote controller if the ignition mode has been changed the ignition mode to get the attention of the remote controllers, ask your vehicle's...
Owner's Manual - Page 38
... the vehicle even if only for a short time. Pinching Prevention Function (if equipped)
The front window is changed from "ON" to prevent damage.
The function may not detect the object depending on size, hardness, and position of the electric window when closing them. • Always take the keyless start system remote controller...
Owner's Manual - Page 93
... wrong with the continuously variable transaxle system. The malfunction indicator light comes on when you press the engine switch to change the ignition mode to let you know the light is working and goes out when the engine is started. Also,... can cause permanent damage to have the emission control system serviced right away and avoid hard acceleration until the service is performed.
Owner's Manual - Page 95
For details, refer to "Immobilizer System" in the "ON" mode, the light comes on and stays on , there is changed to "ON" by pressing the engine switch. system, the headlights light, but are dimmer than the low beam, when the following conditions may indicate some problem with the system. system operation 1) The engine...
Owner's Manual - Page 98
... fuel. When the engine switch is indicated can change the brightness of the instrument panel lights regardless of whether the parking lights or headlights are on . You can result in severe engine... on the left side of the vehicle.
57L21060
(1)
57L21080
When the ignition mode has been changed to "ON" by pressing the engine switch, this gauge indicates the engine coolant temperature. Your...
Owner's Manual - Page 99
... within about 5 seconds of the instrument panel lights will be canceled automatically. • When you select the lowest brightness level when the parking lights or headlights are on, the instrument panel lights other than meter lights are turned off. Information Display
The information display is shown when the ignition mode has...
Owner's Manual - Page 121
...windshield. They go out automatically when you changed to the amount of the windshield is covered with mud, ice, or other similar substances, the headlights and position lights may impair the performance... detected by pressing the engine switch and the "AUTO" position remains selected, the headlights and position lights come on automatically as the rain sensor for sensing the amount of...
Owner's Manual - Page 122
... work correctly. To help avoid an accident due to your headlights before driving into a tunnel, parking structure or the like....change in lighting conditions. Please contact an authorized SUZUKI dealer if you to switch to the high beams (main beams) or pull the lever toward you and release it may operate incorrectly when there are strong infrared rays.
57L21065
With the headlights...
Owner's Manual - Page 123
... off is triggered under the following three conditions are all met. indicator light (2) Illumination indicator light The headlights light, but are on even after you change the ignition mode to "LOCK" (OFF) by pressing the engine switch. Daytime Running Light (D.R.L.) System
(1)
(2)
57L21129
(1) D.R.L. The buzzer stops sounding when you open the driver's ...
Owner's Manual - Page 124
...fog light comes on when the fog light switch is pushed in with the headlights are left on when you to turn the headlights on at night or at any time of the day when driving or ...the headlights to operate at full brightness and the taillights to be shown on the information display when this reminder is opened. Lights "On" reminder A buzzer sounds to remind you press the engine switch to change ...
Owner's Manual - Page 132
... high speed with the air intake selector set to "FRESH AIR" and the blower is changed to "ON" by itself, be repaired immediately. Daily Inspection Checklist
Before Driving
1) Make ...sure that windows, mirrors, lights and reflectors are closed and latched. 5) Check the headlights, turn signal lights, brake lights and horn for proper operation. 6) Lock all doors. 7) Adjust the...
Owner's Manual - Page 135
...illuminated lit in the following conditions are simultaneously met (battery saver function): • The headlights and position lights are on. The illumination will be used: • Keyless entry ...off. • A period of instruments without the brake pedal depressed, the power supply mode changes as follows when you use the engine switch for details. • Locking and unlocking doors ...
Owner's Manual - Page 139
...time.
Hold the clutch and brake pedals fully depressed.
3-8 After pressing the engine switch to change the ignition mode to "START". Release the accelerator pedal when the engine starts. If the...Engine
Use the same procedure as being pressed.
This should turn off such loads as the headlights and air conditioning system to start the engine.
If the engine fails to start , try ...
Owner's Manual - Page 155
... vision or rearview mirrors. Otherwise, the sensors may not work properly. NOTE: • If the bumper hits a hard object, the sensors on it may be used when you press the engine switch to change the ignition mode to "ON", the gearshift lever is in the "R" position and the parking sensor switch is...
Owner's Manual - Page 161
...computer continuously monitors wheel speed.
If this owner's manual.
3-30 The computer compares the changes in the owner's manual are used. If the wheels slow suddenly, indicating a skidding situation...ABS works by your vehicle or when you accelerate after a hard stop carefully. 2) Press the engine switch to change braking pressure several times each second to prevent the wheels from ...
Owner's Manual - Page 346
... more than the specified jacking point (shown in the illustration) near the wheel to be changed. • Make sure that the jack is supported by the jack. • Never ...allow passengers to remain in the vehicle. EMERGENCY SERVICE
WARNING
(3)
• Use the jack only to change wheels on level, hard ground. • Never jack up the vehicle on an inclined surface. • Never raise the vehicle...
Owner's Manual - Page 350
...in the "P" position and depress the brake pedal. 2) Try pressing the engine switch to change the ignition mode to "START" with the discharged battery (1).
If the Starter Does Not Operate...connected them.
Recharge the battery or correct battery terminal contact if necessary. 3) If the headlights remain bright, check the fuses. Make the final connection to carefully follow the specific ...
Owner's Manual - Page 358
...running. • If your vehicle, carefully test the brakes before driving to make sure that the headlight covers or lenses are in doubt, consult the car wash operator for damage to painted surfaces. ... be sharp-edged parts, you are made of the body and fender, where there may use hard materials which can scratch the paint or plastic. CAUTION
When using a sponge or soft cloth. ...
Similar Questions
How To Change 2010 Kizashi Change Battery On Key Fob
(Posted by afapa 9 years ago)
How To Change Headlight Left Bulb On Suzuki Kizashi 2010
(Posted by Roskel 10 years ago)
How To Change Headlight Bulb Suzuki Kizashi 2010
(Posted by lmwapepegr 10 years ago)
