Home » Suzuki » Technical Support » 2008 Suzuki Grand Vitara

Get support for 2008 Suzuki Grand Vitara

2008 Suzuki Grand Vitara Support Question

Find answers below for this question about 2008 Suzuki Grand Vitara.
Need a 2008 Suzuki Grand Vitara manual? We have 1 online manual for this item!

Suzuki Overview Questions Manuals Reviews Videos Research

Question posted by 73shovelhead on May 3rd, 2014

'auto' On Lcd Blinking

2008 grand vitara...air worked fine earlier this year now "auto" is blinking non stop and a/c compressor has shut down. anyone know what this is?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 2

This owner's manual applies to the GRAND VITARA series: 66J001 NOTE: The illustrated model is one of the GRAND VITARA series. © COPYRIGHT SUZUKI MOTOR CORPORATION 2007

Owner's Manual - Page 39

...the anchor down while pulling the lock knob out. The front passenger's seat belt reminder works in the front seat. WARNING Be sure that the shoulder belt rides on , a ...be away from Reminder 1 or Reminder 2 according to the vehicle speed. (Refer to the "ON" position then will blink for about 6 seconds (Reminder 1). 2) If the vehicle is driven (vehicle speed > 8 km/h), Reminder 2 will operate...

Owner's Manual - Page 40

...buckles, latch plates, retractors, anchorages and guide loops. Replace any seat belts which do not work properly and are damaged. Infant restraint - Any seat belt assembly which was in any collision... after any way or the seat belt pretensioners were activated (that is, if the front air bags were activated). Any seat belt assembly which was not in use during a collision should...

Owner's Manual - Page 49

... it was provided for front seat belt only) sensors and the electronic controller of the air bag system also control the seat belt pretensioners. The retractors will remain locked after the ... of the belt is equipped with the SUPPLEMENTAL RESTRAINT SYSTEM (advanced air bags). The seat belt pretensioner system works with a seat belt pretensioner system at all those precautions. The ...

Owner's Manual - Page 50

..." light on the instrument cluster does not blink or come on briefly when the ignition switch is specially trained. Supplemental Restraint System (air bags) EXAMPLE 54G022 WARNING This section of a collision. Please read and follow ALL these two conditions may not work on or around the pretensioner system components or wiring must be...

Owner's Manual - Page 52

... air bag is located behind the center pad of the air bag. Frontal collision range 63J030 If the "AIR BAG" light on while driving, the air bag system (or the seat belt pretensioner system) may not work ... EXAMPLE 60G032 Front air bags are molded into the air bag cover to the "ON" position, or the "AIR BAG" light stays on, or comes on the instrument cluster does not blink when the ignition...

Owner's Manual - Page 57

... If you may not even realize that the air bag may not work properly. The inflators inflate the appropriate air bags with side air bags, and side curtain air bags, crash sensors will trigger the inflators. In...vehicle. Since your view nor make it will trigger the side air bag and side curtain air bag inflators. How the System Works WARNING • Do not spill any heavy objects on the ...

Owner's Manual - Page 59

... in the event of these conditions may cause severe injury. Do not touch air bag system components or wires. BEFORE DRIVING Servicing the Air Bag System WARNING (Continued) • For vehicles with side air bags, do not place any electrical service work on your SUZUKI. If your dealer, body repair shop or scrap yard...

Owner's Manual - Page 66

... lights, Tail lights Head lights D.R.L. Lighting switch position IG OFF Main lights to operate your lights as shown in the "AUTO" position) and the Daytime Running Light (D.R.L.) system. The three systems work together to be operated D.R.L. (1) OFF Parking lights, Tail lights Head lights D.R.L. Parking lights, Tail lights Head lights (3) Third 52D166 Your...

Owner's Manual - Page 67

...side of the lever. Do not cover the sensor (5). STEERING COLUMN CONTROLS Lighting Operation HIGH Auto-On Headlight System (4) (3) (5) LOW (2) (1) PASS 66J025 66J024 This control lever is ... are on, a light on the instrument panel will not work correctly. 3-6 in the "AUTO" (4) position, refer to "Auto-On Headlight System" for Auto-on in the second (2) position the front parking lights,...

Owner's Manual - Page 68

.... As the sensor is infrared type, it will return to its normal position. The lever will not work correctly with ambient lights that do not contain infrared rays. STEERING COLUMN CONTROLS WARNING It takes about 5 ... the third position at night or at any time of ambient light. Lane change in the "AUTO" position and it is light around the light sensor. To help avoid an accident due to ...

Owner's Manual - Page 78

... and stopping ability. If there is a passenger in the "BEFORE DRIVING" section. After repeating several times under -inflated tire causes the tire to overheat and can check that the light is working. When...as soon as possible, and inflate them to the proper pressure as indicated on and then blink. Driving on briefly so you when one or more of the instrument panel. When the...

Owner's Manual - Page 79

...dealer. Have your tire inflation pressure at lower inflation pressures. Stop in severe injury or death. Refer to an accident, ...system has recovered, make sure to restore normal operation of air pressure. WARNING If the low tire pressure warning light ...be repeated approximately ten minutes after blinking, indicating that driving on and blinks while driving there may affect steering ...

Owner's Manual - Page 81

... on when driving, there may be canceled temporarily to avoid overheating the brake pads, and the light will blink 1 time per second when one of the ESP® systems other than ABS is working. The light will come on automatically and the light will go out. • When the transfer switch (if...

Owner's Manual - Page 83

... to the "ON" position so you know the light is working . A malfunction indicator light is provided on if there is a problem in the tank. INSTRUMENT PANEL "AIR BAG" Light Malfunction Indicator Light NOTE: If...light is on when the ignition switch is working and goes out when the engine is started. If so, the lamp will come on or blinks when the engine is running, service to the...

Owner's Manual - Page 85

...For details, refer to "Using the Transfer Switch" in the "AUTO" (1) (2) (3) 64J044 These indicators show the 4WD operating mode as...The lighting switch is in the transfer system and you know that the lights are working. (1): Neutral (2): 4-wheel drive high range center differential ...when the following three conditions are turned on briefly to blink, there is a problem in the second or third...

Owner's Manual - Page 99

...selector to turn on and off . This selector is used to turn on the LCD display. To turn on the air conditioning system, push in the switch again and "A/C" will appear on the blower ...to select blower speed. To turn off the air conditioning system, push in the switch and "A/C" will go off the air conditioning system. If the "AUTO" switch (7) is used to adjust the ...

Owner's Manual - Page 100

... is selected, outside air is introduced. "FRESH AIR" and "RECIRCULATED AIR" are selected alternately each time the air intake selector is recirculated. FRESH AIR (b) When this mode is selected, outside air is shut off and inside air is pushed. (c) (d) (e) (f) (4) 64J070 66J239 Push this selector to change among the following modes. AUTO (7) Temperature-controlled air comes out of the...

Owner's Manual - Page 102

... work automatically. These sensors are maintained, and the other functions remain under the automatic operation, you are controlled automatically to regulate temperature. NOTE: If the "AUTO" on the LCD display blinks,... not to your vehicle has been left in the heating system and/or air conditioning system. The manually selected functions are used by an authorized SUZUKI dealer...

Owner's Manual - Page 114

... CD without removing it will be drawn into the unit automatically after about 15 seconds. (Auto reload function) The buck up eject mechanism: This function allows you to eject the CD ...button (4). 66J143 Both the indication "In" and the selected disc number in the CD indicator will blink in the display. Load the next CD. 4) After loading the required number of CD's, press ...