2007 Subaru Outback Support Question
2007 Subaru Outback Support Question
Find answers below for this question about 2007 Subaru Outback.Need a 2007 Subaru Outback manual? We have 2 online manuals for this item!
Question posted by jekkhola on December 20th, 2013
2007 Outback How To Program Remote
The person who posted this question about this Subaru automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 18
15
Instrument panel
1 2 3 4 5 6 7 8
1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15)
Door locks (page 2-4) Illumination brightness control (page 3-28) Remote control mirror (page 3-36) Windshield wiper deicer (page 3-33) Traction Control system OFF switch (page 7-27) Light control lever (page 3-26) Combination meter (page 3-5) Wiper ...
Owner's Manual - Page 25
For details, please refer to meet your vehicle is equipped with remote keyless OFF / Short / Normal / Long entry system Operation / ... doors) Impact sensor operation (only vehicles Operation / Non-operation with shock sensors (dealer option)) Passive arming Remote keyless entry system Hazard warning flasher Audible signal Key lock-in prevention Rear window defogger Windshield wiper deicer (if...
Owner's Manual - Page 98
... (if equipped) ...2-23
Tilt function ...Sliding function ...Anti-entrapment function ...Sun shade ...2-24 2-24 2-24 2-25
Power door locking switches ...
2-6
2-7 2-9 2-9 2-9 2-9 2-10 2-10 2-10 2-10 2-11
Remote keyless entry system ...
2-8
Alarm system ...
2-14
2-14 2-15
2-15 2-15 2-16
Owner's Manual - Page 105
...Do not expose the transmitter to severe shocks, such as those experienced as a power plant, broadcast station, TV tower, or remote controller of Industry Canada. The keyless entry system does not operate when the key is approximately 30 feet (10 meters). Do not... for compliance could void the user's authority to the following functions. 2-8 Keys and doors Remote keyless entry system
hicle.
Owner's Manual - Page 107
... of the power door locking switch. 3.
When the transmitter battery begins to get on the remote is pressed, the alarm will flash. Contact the nearest SUBARU dealer for details. Sounding a ...respond to flash three times.
200714
NOTE
If the interval between presses is located on the remote transmitter.
While still holding down the UNLOCK side of the vehicle, pressing the " " ...
Owner's Manual - Page 111
... can be armed and disarmed with part 5. NOTE
If the code entered the second time is not identical to that their remote transmitter while you have three current transmitters, program two of them unauthorized access to sound for 30 seconds.
The horn sounds and the turn signal lights will flash for a maximum...
Owner's Manual - Page 114
... rear gate and panic activation.
Passive arming
When passive arming mode has been programmed by your vehicle's alarm system for activation mode. (Refer to the "ON...cannot disarm the system using the transmitter (i.e. In valet mode, the remote transmitter is automatically accomplished without using the remote transmitter. In order to flash once every three seconds indicating that in...
Owner's Manual - Page 219
...; Wireless Control System with Part 15 of the garage door opener or other device. When programming the HomeLink® Wireless Control System, you can be operating a garage door opener or other...are three HomeLink® buttons on the driver's sun visor, is a handy way to three remote-controlled indoor and outdoor devices, such as required by this system, consult the HomeLink website at ...
Owner's Manual - Page 222
...three buttons. 3. To activate a device, simply press the appropriate button. Programming other devices
To program other devices, skip step 2 because it clears the mem-
4.
Press and... outlet. Operating the HomeLink® Wireless Control System
Once programmed, the HomeLink® Wireless Control System can be used to remote-control the devices to which you wish to the outlet....
Owner's Manual - Page 230
... start safety features ...Entering the vehicle while it is running via remote start ...Entering the vehicle following remote engine start shutdown ...Pre-heating or pre-cooling the interior of the vehicle ...Service mode ...Remote transmitter programming and programmable feature option ...System maintenance ...Selector lever ...Selector lever reverse inhibiting function ...Selection of manual...
Owner's Manual - Page 239
.... 1. The horn will honk and the parking lights will flash three times to activate the remote start system. To program a remote transmitter: press and release the " " button on the driver's side left under the dashboard panel. 4. Remote transmitter programming and programmable feature option
New transmitters can be adjusted for 10-15 seconds. Locate the small...
Owner's Manual - Page 240
... replace with new ones. Starting and operating 7-11
the brake pedal repeatedly will notice a decrease in your remote control operates). To exit the remote transmitter and feature programming mode, turn the ignition switch to change the remote control batteries.
700389 700391
CR-1220
+
CR-1220
+
700390
700392
1. Remove the circuit board from the bottom...
Owner's Manual - Page 103
...alarm system has been set the system for deactivation yourself or have three current transmitters, program two of up to four transmitters. If an error occurs five times, perform the ... the lost transmitter codes should be armed and disarmed with up to operate with the remote transmitter. Deleting old transmitter codes The control unit of your vehicle and valuables from the ...
Owner's Manual - Page 106
... of your vehicle's alarm system for a 30-second period after locking the doors with the remote transmitter. Emergency disarming If you choose the valet mode, the alarm system does not operate. ...indicator light will not switch to the
& Passive arming
When passive arming mode has been programmed by the following actions is extremely short, the system may not respond. The security ...
Owner's Manual - Page 107
In order to lock the doors you wish to program the passive arming mode, have been closed. Disarming the system To disarm the system, briefly...dealer. ! Arming the system
CAUTION
In passive mode, the system will automatically arm after one minute. If the remote transmitter or power door locking switch is used to lock the doors manually will take place immediately regardless of the ...
Owner's Manual - Page 228
...® buttons Indicator light Hand-held transmitter* * Not part of your vehicle, up to three remote-controlled indoor and outdoor devices, such as garage door openers, entrance gates, door locks, home lighting...There are three HomeLink® buttons on the sun visor, each of which you can program for operation of a HomeLink®-compatible device. Interior equipment
6-17
& Sedan
keep the...
Owner's Manual - Page 232
... purposes. 1. opener by pushing the HomeLink® button.
& Operating the HomeLink® Wireless Control System
Once programmed, the HomeLink® Wireless Control System can be used to remote-control the devices to which you wish to program the button at 1 to 3 inches (25 to 76 mm) away from the HomeLink® buttons on...
Owner's Manual - Page 234
... mode...Maximum speeds...Driving tips...SPORT mode...Shift lock release ...Selector lever ...Selector lever reverse inhibiting function...Selection of the vehicle ...Service mode ...Remote transmitter programming and programmable feature option...System maintenance ...Shifting speeds ...Driving tips ...
7-7 7-9 7-9 7-11 7-11
7-12 7-12 7-12 7-12 7-13 7-13 7-13 7-14
Manual transmission vehicle...
Owner's Manual - Page 246
...Before exiting the vehicle, set the temperature controls to indicate Confirmation Horn Chirps are "OFF". Remote transmitter programming and feature programming can be adjusted
using the following remote engine start system also has one time indicating that your setting.
! To program a remote transmitter: " button on the driver's side left under the dashboard panel. 4. To toggle the...
Owner's Manual - Page 247
... batteries.
1. Remove the circuit board from the vehicle that your remote control should last approximately three years, depending on usage. 7-14
Starting and operating
the brake pedal repeatedly will notice a decrease in your remote control operates). To exit the remote transmitter and feature programming mode, turn the ignition switch to weaken, you will toggle...
Similar Questions
How Do You Replace The Left-front Turn Signal Bulb In A 2007 Subaru Outback
station wagon?
station wagon?
(Posted by darhmar 10 years ago)
Programming Subaru Outback 2006 Keyless Entry Fob
Directions came with the fob but don't seem to work. Do you have better ones?
Directions came with the fob but don't seem to work. Do you have better ones?
(Posted by smutzla 12 years ago)