Starting Problem

Hi. It may be stuck on Security Mode - or there is something wrong with the security system.

Use this procedure after replacing any of the following components:

• The PASS-Key III plus keys • The theft deterrent module (TDM) • The powertrain control module (PCM)

This procedure is not available on vehicles equipped with EXPORT configured TDMs.

• When performing the 30-minute relearn procedure, all previously learned keys will be erased from the TDM memory. Additional keys may be learned after performing the relearn procedure.

When replacing a TDM with a GM SPO Replacement Part, ensure the procedure to setup a new TDM is performed prior to the 30-Minute Relearn Procedure.

1. With a master vehicle key, turn ON the ignition, with the engine OFF.
2. Observe the security indicator. After approximately 10 minutes, the telltale will turn OFF.
3. Turn OFF the ignition, and wait 5 seconds.
4. Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.

   Important: The vehicle learns the key transponder information and/or passwords on the ignition switch transition from OFF to RUN. You must turn the ignition OFF before attempting to start the vehicle.

5. With a master vehicle key, start the vehicle. The vehicle has now learned the key transponder information and/or the ECM has now learned the fuel continue password.
6. If additional keys are required to be learned, continue to step 7.
7. With a previously learned master key, turn ON the ignition, with the engine OFF.
8. Turn OFF the ignition and remove the key.
9. Within 10 seconds insert the key to be learned. Turn ON the ignition with the engine OFF. The vehicle has now learned the new key.

---

www.satechhelp.co.za