Ryobi RY13010 Support Question
Ryobi RY13010 Support Question
Find answers below for this question about Ryobi RY13010.Need a Ryobi RY13010 manual? We have 1 online manual for this item!
Question posted by sandyoaks on October 10th, 2012
String Head Does Not Turn On Ryobi 13010
removed curved stringhead assembly, which turns by using thumb and fore finger. was told that it would not turn. I have not tried to start the unit myself. is there a need for certain rpm before string head will turn?
Current Answers
Related Ryobi RY13010 Manual Pages
Operator's Manual - Page 7
... using this unit.
Never start or run the engine in the cutting line.
Always wear eye protection with side shields marked to increase blood circulation.
Slowly remove the fuel cap after stopping engine. Do not wear jewelry of exposure may increase operator fatigue, which can be scheduled for gasoline, and secure the unit...
Operator's Manual - Page 8
... injury.
Never operate unit without the grass deflector in place and in good condition.
This product is intended for infrequent use . Make sure fasteners are properly and securely attached.
Never use . Use only the manufacturer's replacement line in any other occasional users for fuel leaks.
Replace string head if cracked, chipped, or...
Operator's Manual - Page 9
... this product.
Please study them and learn their meaning for safe operation of injury, user must read and understand operator's manual before using this product.
Do not install or use any type of risk associated with side shields marked to explain the levels of blade on this product.
SYMBOL SIGNAL
MEANING
DANGER...
Operator's Manual - Page 10
... Power Head/Wheel Assembly Pro Cut II™ String Head/Shaft Assembly Handle Assembly Grass Deflector Line Carrier .105 in . Use of a product that helps protect you have been improperly assembled could result in the packing list are damaged or missing, please call 1-800-860-4050 for easy handling. FEATURES
PRODUCT SPECIFICATIONS Weight - (Without Fuel 22.6 lbs. n Carefully remove...
Operator's Manual - Page 11
... the lower handle. To remove line for tightness during use , pull from the spark plug when assembling parts.
Place the throttle cable in the clip located on the upper handle as shown.
Insert the bolts through the holes in pro cut II™ string head/ shaft assembly to become pinched when installing the...
Operator's Manual - Page 12
...
caution:
Always shut off engine before each use of oxygenates stated below are acceptable. Never add fuel to do not rethread. Remove dipstick again and check lubricant level. IT WILL...engine lubricant level: Place unit on this product. from refueling area before starting
the product. OXYGENATED FUELS
DO NOT USE E85 FUEL. To start position. Stand beside the ...
Operator's Manual - Page 13
... switch in operation. If grass becomes wrapped around the string head, STOP
THE ENGINE, disconnect the spark plug wire, and remove the grass. Use the tip of the machine and squeeze throttle lever to the run position. do the cutting; TRANSPORTING THE UNIT
Turn on /stop switch OFF ( O ). Make sure engine...
Operator's Manual - Page 14
...disconnect the spark plug wire. Allow the unit to do so could result in contact with hearing protection.
If the cutting attachment turns at least once a year. Loosen the ... screw needs adjusting on the type of fuel used , and/or your gas powered tool, you find any other repairs, have the trimmer serviced by turning the knob
counterclockwise. Remove the air...
Operator's Manual - Page 15
...garden chemicals and de-icing salts.
Abide by all foreign material from the rocker arm cover. This should slide between .006 in. (0.15 mm) and .008 in. (0.20 mm) for both rocker arms.
NOTE: Use a standard automotive feeler gauge. Allow the engine to cool completely before starting... proceeding.
Remove the oil fill cap/dipstick.
Tip the unit backward so the handles...
Operator's Manual - Page 16
... grass at part throttle. and string head
Operating trimmer at ground level. ...blocked. Reset spark plug gap.
Remove and
clean the spark plug. ...engine starts and runs. Contact a service dealer.
NOTE: Depending on carburetor needs Turn ...idle speed screw clockwise to prevent wrapping. Engine does not reach full speed and Air filter is usually caused by storing the unit...
Operator's Manual - Page 17
...product to the service center for Techtronic Industries North America, Inc., and sold in the United States and Canada. Proof of purchase will be returned to the operating instructions as commercial ... days from the date of original retail purchase for any Ryobi® brand outdoor product that is used for personal, family or household use of parts or accessories which vary from state to state...
Operator's Manual - Page 18
...used for your warranty rights and responsibilities, you , including diagnosis, parts, and labor performed at a RYOBI... Board or the United States Environmental Protection ...) Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(iv) Fuel Tank.
(2) Air Induction System
...iii) Hoses, belts, connectors, and assemblies. Techtronic Industries North America, Inc., will ...
Similar Questions
Ryobi Pro Cut Ii String Head
Where can we get new keepers and springs to put into our head?
Where can we get new keepers and springs to put into our head?
(Posted by bkottele 9 years ago)
After Mkt. String Head
If trere is an after mkt. string head to fit the RY13010 walk behind. Will using one void fact. warr...
If trere is an after mkt. string head to fit the RY13010 walk behind. Will using one void fact. warr...
(Posted by bettybuddy33 12 years ago)
Field Trimmer Ry13010 String Is Stuck
String is stuck on the insert end. How do I get it out? I would like to continue to use. I also had ...
String is stuck on the insert end. How do I get it out? I would like to continue to use. I also had ...
(Posted by PaceTen 12 years ago)
How Do You Disasemble Pro Cut Ii Fixed Line String Head To Remove Line
The line is too short to pull through and I can not get a new line in.
The line is too short to pull through and I can not get a new line in.
(Posted by bjhetten 12 years ago)