Ryobi RY13010 Support Question
Ryobi RY13010 Support Question
Find answers below for this question about Ryobi RY13010.Need a Ryobi RY13010 manual? We have 1 online manual for this item!
Question posted by siretia on June 14th, 2014
Quits Running
Every time I start it, as soon as I squeeze the throttle it shuts off. I added oil, its a 4 cycle oil that I used. This is when it started having problem. It was smoking before I added oil. I hope this makes since. I just put a new throttle system on it this week, that seems to be working fine.
Current Answers
Related Ryobi RY13010 Manual Pages
Operator's Manual - Page 7
...approached, stop the engine and remove the spark plug wire before making any , vibrations or extent of exposure may result in poor....
Allow the engine to cold and dampness, diet, smoking, and work should be scheduled for gasoline, and secure the unit...; Secure long hair above shoulder level to use this unit.
Never start or run the engine in the cutting line.
...
Operator's Manual - Page 8
... Inspect before use any other type...use. It is properly installed and securely fastened. Make sure fasteners are properly and securely attached.
Never use...attachment. Use only the manufacturer's replacement line in good condition.
This product is intended for infrequent use blades,...etc. Do not use . Failure to do so can cause serious injury.
Make sure all guards,...
Operator's Manual - Page 9
SYMBOLS
The following symbols may result in minor or moderate injury. CAUTION:
Indicates a potentially hazardous situation, which, if not avoided, may be used on a product displaying this product. Read Operator's Manual Eye and Hearing Protection
To reduce the risk of risk associated with hearing protection. away. English
Always ...
Operator's Manual - Page 10
... safety rules. NOTE: Be careful not to check and add lubricant when necessary. Use of 4-Cycle Lubricant Operator's Manual
WARNING:
If any parts on the Packing List are attempting....OIL CAP/DIPSTICK
Remove the oil fill cap to bend the throttle cable when unpacking. Parts on the tool and in this product, familiarize yourself with all items listed in serious personal injury.
Make...
Operator's Manual - Page 11
...WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
Place the throttle cable in the clip...bracket and into the slots located on the side opposite the throttle cable and is sharp.
To remove line for tightness during use , pull from open area on front of the power head...
Operator's Manual - Page 12
... to safely handle fuel could result in period. Failure to a machine with a running or hot engine.
NOTE: Do not engage the throttle lever during the starting process. Press the primer bulb 10 times slowly. Set start lever to start the engine before each use in the ON ( | ) position. Failure to comply with ANSI Z87.1, along...
Operator's Manual - Page 13
... engine runs. Set the start lever back to prevent fuel spillage.
9 - To stop the engine: Place the on /stop switch in operation. If grass becomes wrapped around the string head, STOP
THE ENGINE, disconnect the spark plug wire, and remove the grass. Use the tip of the machine and squeeze throttle...
Operator's Manual - Page 14
..., cleaning, or servicing the machine, shut off engine, wait for adjustment and discontinue use until the repair is a fire hazard and must be in objects being thrown into your gas powered tool, you find any leaks, correct the problem before using solvents when cleaning plastic parts.
Chemicals can often make adjustments and repairs described here...
Operator's Manual - Page 15
... starting , and increased emissions. MAINTENANCE
SPARK PLUG replacement
This engine uses an...garden chemicals and de-icing salts.
Abide by pulling the recoil starter grip just...lubricant following the instructions in the Adding/Checking Engine Lubricant section previously ...oil fill hole into a container approved for both rocker arms.
NOTE: Use a standard automotive feeler gauge. Run...
Operator's Manual - Page 16
... string head
Operating trimmer at ground level. See Adding/Checking Engine Lubricant in this manual.
Engine starts, runs, and accelerates Idle speed screw on the severity of the flooding, this manual.
See Figure 13. Grass wraps around driveshaft housing Cutting tall grass at part throttle.
Drain the oil out
of this manual. Spark plug fouled...
Operator's Manual - Page 17
...cover:
A.
Techtronic Industries North America, Inc.'s, responsibility in respect to claims is limited to making the required repairs or replacements and no claim of breach of warranty shall be cause for...Ryobi service center within these time periods from the date of purchase.
Three years if the product is used for personal, family or household use of parts or accessories which...
Operator's Manual - Page 18
...soon as a problem exists. If you should contact a Techtronic Industries North America, Inc., Customer Representative at the time...be repaired or replaced at any other device used .
MANUFACTURER'S WARRANTY COVERAGE:
This product's ... system).
(ii) Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(iv) Fuel Tank.
(2) Air Induction System
(i) Controlled hot...
Similar Questions
Trimmer Hasn't Run For 2 Years, Won't Start. Seeking Recommendations On How To
didn't use Ryobi 28040 trimmer for 2+ years due to health issues. Won't fire/start when pulled. Want...
didn't use Ryobi 28040 trimmer for 2+ years due to health issues. Won't fire/start when pulled. Want...
(Posted by klewis1114 8 years ago)
Ryobi Ry13010 Carburettor
My Trimmer starts fine and idles fine for a minute or so then stalls as soon as I open the throttle....
My Trimmer starts fine and idles fine for a minute or so then stalls as soon as I open the throttle....
(Posted by terry43343 11 years ago)
Will Fuel Tank With Rear Facing Spout Fit My Ry13010 Trimmer? Front Faceing Spou
Will fuel tank with rear facing spout fit RY13010 with front facing spout? If so, where can I get on...
Will fuel tank with rear facing spout fit RY13010 with front facing spout? If so, where can I get on...
(Posted by bettybuddy33 12 years ago)
Stopped Running
while trimming it just stopped running and I can't get it started. It had gas, I checked the oil and...
while trimming it just stopped running and I can't get it started. It had gas, I checked the oil and...
(Posted by edschech 12 years ago)
Field Trimmer Ry13010 String Is Stuck
String is stuck on the insert end. How do I get it out? I would like to continue to use. I also had ...
String is stuck on the insert end. How do I get it out? I would like to continue to use. I also had ...
(Posted by PaceTen 12 years ago)