RCA VH126N Support Question

Find answers below for this question about RCA VH126N.
Need a RCA VH126N manual? We have 3 online manuals for this item!

RCA Overview Questions Manuals Reviews Videos Research

Question posted by mkharris10 on February 26th, 2012

Rotator Not Working

i have the control box wired to the rotator correctly..the motor buzzes when the arrow keys are pushed but motor does not rotate. the unit is new out of box and has not been mounted yet.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related RCA VH126N Manual Pages

Warranty Card - Page 1

... displays the rotator cycle time. Press and hold the INITIAL and > keys (make sure you may not apply to be proven defective in material or workmanship within the terms of original purchase, such defect(s) will perform the initialization procedure. Release the D key and turn the control unit back on the control unit's front panel. 3. The unit is authorized...

Owner/User Manual - Page 1

... terminal 2. For longer runs, use with lock washers attached (4) Nuts without washers Installing the Outdoor Drive Unit Step 1: Attach cable to grip the mast securely. Press the grommet back into place. Doublecheck the wiring order. Programmable Antenna Rotator VH126N User's Manual Unpacking Make sure the following pieces are in the cable make sure the inserts...

Owner/User Manual - Page 2

... diameters of cable needed to 2" (3-5cm) may be wired correctly. Position the brackets and nuts/washers so that they leave just enough room for unguyed masts over the ends of the U-bolts to keep the brackets in cable to the antenna, fasten it to the control unit 1. Cut the cable to that you deform the...

Owner/User Manual - Page 3

... the control unit 1. The back of driver motor may cause the rotator to receive. 4. The ANT POSITION display shows 36 to each letter key. ABCD E F GH I J UL INITIAL MEMORY LEARN NOTES: • You must perform the learning procedure before installing the antenna mast. Write down this chart. 8. Press the INITIAL key. Use the INITIAL key to the new antenna orientation...

Owner/User Manual - Page 4

... antenna positions. 1. U.S.A.: Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, New York 11788 CANADA: Audiovox Return Center, c/o Genco, 6685 Kennedy Road, Unit ...VH126N US IB 00 Trademark(s) ® Registered Made in connection with the product. Simultaneously press and hold the D key on a second time. Resetting the Memory Keys Resetting the control unit's memory keys...

Owner/User Manual - Page 5

...to the lead-in cable's grounding unit and run the wire down the building in contact with Yellow Pages under "Antennas or Television and Radio Antenna Systems" for the minimum recommended safe ...install your set . If possible, find a mounting place directly above the ground, the better it performs. A good practice is above your antenna about a careful, safe installation-don't try ...

RCA Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Troubleshooting the Jensen CD6112 CD Receiver
... connected properly. Why am I getting poor reception from improper speaker wiring, a short in my favorite channels on at , rotate the volume control to a constant hot wire. Make sure the antenna control power wire is nothing obstructing the signal. If this does not solve the problem, then the unit may also be depleted or inserted incorrectly. Manually tune in...
Troubleshooting the Jensen CD4610 CD Receiver
.... Make sure speaker wires are working and connected properly. Install fuse of range. Tighten if needed. Why is there no sound from my radio tuner on at , rotate the volume control to be dirty or damaged. The disc may be a tracking error. Make sure the label side is out of correct rating and size. Make...
Pressing the wrong programmed position on the VH126N Antenna
...control unit off, then turn it back on my VH126N antenna? Press the INITIAL key to the Ask A Question Page so you can submit a support request and we can I purchase replacement parts for Audivox products Finding the Best Location for your product. NOTE: Search for a MODEL NUMBER, searching for your RCA ANT2000 Antenna... system 1. New to the ...box in the blue area above, then push...