2004 Pontiac Aztek Support Question
2004 Pontiac Aztek Support Question
Find answers below for this question about 2004 Pontiac Aztek.Need a 2004 Pontiac Aztek manual? We have 1 online manual for this item!
Question posted by sweetbamagirl1 on August 22nd, 2014
Pcm
Where is the location of the PCM? Could it have been moved to change out my alternation and start causing problems?
Current Answers
Answer #1: Posted by waelsaidani1 on August 22nd, 2014 11:06 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
inside the dash behind the glovebox. look at the battery ground as is connected to the rest of the car. At this point (end of the 1/0 cable) is critical...welds itself with each start as it pulls over 300 cold cranking amps to start the engine...sadly they couple the needs of the ignition, fuel pump and dashboard, ECU----ON this leg of your ground from the battery~...use a wirebrush on the end of the 1/0 cable as it attaches to the frame/fender
BUT
Get a New battery if yours is older than five years old (knock-off labels on top of battery)...with a clean, wirebrushed GROUND connection the ECU (and a new battery) will act normally then
Related Manual Pages
Owner's Manual - Page 12
... the label on the back of the seat for proper location. When you can be flipped forward or removed individually.
1-6
Split Bench Seats
The seatbacks can be sure it could cause injury to adjust, fold, remove and reinstall the seats. That could move forward in a sudden stop or crash. Folding or Reclining...
Owner's Manual - Page 15
... the sections of each section, showing where the section must be placed in the proper location for the legs to be seriously injured. The seat must go. A safety belt that...
If the seatback isn't locked, it could move around in a collision or sudden stop or crash. That could cause injury to lock the seat into place properly can move forward in a sudden stop . After installing the...
Owner's Manual - Page 81
...void authorization to get locked out of your keys inside the vehicle, OnStar ® may cause undesired operation of the FCC Rules. Notice: If you ever lock your keys in . ...This device may not cause interference, and 2. Changes or modifications to this key from your vehicle is needed, you may cause undesired operation of Industry Canada. The key will start your new key. ...
Owner's Manual - Page 94
... of the high number of the FCC Rules. When trying to start the vehicle if the engine does not start the vehicle will stop being delivered to Federal Communications Commission (FCC)...that may not cause interference, and 2. When the PASS-Key® III system senses that matches a decoder in the key that someone is subject to the following two conditions: 1. Changes or modifi...
Owner's Manual - Page 98
... it there as you hold the key in START for longer than 15 seconds at a time will go down while you 're already moving could change the way the engine operates. Shift to work... might not perform properly.
2-20 Your engine won 't start in your vehicle. The idle speed will cause your battery to START. Do this until the engine starts. As soon as your engine warms up. Notice: Your...
Owner's Manual - Page 99
... from moving engine parts. The electrical cord is not required.
{CAUTION:
Plugging the cord into an ungrounded outlet could be damaged. Plug it could overheat and cause a fire. You'll get easier starting your ...your vehicle. Also, the wrong kind of the coolant heater is located on the outside temperature, the kind of four hours prior to list everything here, we ask that ...
Owner's Manual - Page 103
..., you will pop up to the released position.
If the ignition is located on the driver's side under the instrument panel.
2-25 Notice: Driving ... Brake System Warning Light on page 3-36. If you remove your foot from moving.
• Prevent ignition key removal unless the shift lever is
in the case...system and cause premature wear or damage to brake system parts. Shift lock release is...
Owner's Manual - Page 109
..., leave the control in the direction you are . After selecting which mirror to adjust, move the knob in the center (off) position. If you want the mirror to adjust the...
{CAUTION:
A convex mirror can see the side of your shoulder before changing lanes.
Outside Convex Mirror
Your passenger's side mirror is located on your vehicle. A convex mirror's surface is curved so you (to...
Owner's Manual - Page 121
... be injured. People in it easier to open them . Push the release lever located in a collision or sudden stop. You will hear a click when the tray ... rear convenience tray.
{CAUTION:
If any such item properly. Your vehicle may cause damage. You will hear a click when the tray is locked into position.... tray can move around in front of the handle of 400 lbs. (181.4 kg) on top.
Owner's Manual - Page 134
...starts to flash. The lever will return automatically. The lever on the instrument panel cluster and the HUD display will not see your lane change .
These positions allow you signal a turn or a lane change...the left ) positions. Hold it . Turn Signal/Multifunction Lever
Turn and Lane-Change Signals
The turn , move the lever all the way up or down. As you to -Pass
N Windshield ...
Owner's Manual - Page 137
...cruise control will automatically disengage.
On such roads, fast changes in heavy traffic. Setting Cruise Control
{CAUTION:
If ...the traction control system begins to the speed you can cause needless wheel spinning, and you could be dangerous on ... .
3-11 When road conditions allow you to ON. 2. Move the cruise control switch to safely use cruise control on slippery roads...
Owner's Manual - Page 147
... is easy to the desired HUD image brightness.
To adjust the HUD so you are located to the right of the HUD image is determined by the ambient light conditions in the...distance and damage your seat position you change your vehicle. The HUD image should remain in full view, straight ahead near the front bumper. Adjust the driver's seat. Start your vehicle is on the optional steering...
Owner's Manual - Page 157
Paying attention to cause an expensive repair or replacement. Waiting to do about...lights come on when there may be or is a problem with one of the warning lights comes on and stays on briefly when you start the engine just to know your warning lights and gages ... familiar with this section, you what to let you locate them. Gages can signal that may be on page 3-43.
3-31
Owner's Manual - Page 167
...none of fuel? Did you recently changed brands of the above steps have developed. It will cause your engine not to fuel your ..., when it is safe to fix any mechanical or electrical problems that may go away once the engine is still flashing,...making sure to park your dealer for service as soon as stalling after start-up .) This will usually be wet. Find a safe place to...
Owner's Manual - Page 237
...Enter):
[ (Fast Forward):
q (Return): Press this button to start play of this button to view the media menu. Press this button.... \ (Clear):
Press this button, located on the bottom left arrow buttons to move to the previous menu. This button may... moves through subtitle options (English, Spanish, French, etc., if available).
Press this button again. This button changes camera angles on...
Owner's Manual - Page 262
... skid, too much speed or steering in a curve causes tires to see its front in your inside mirror, activate your right lane change signal before passing the next vehicle. The vehicle you just... skids correspond to your vehicle's three control systems. In the braking skid, your left lane change signal and move back into the right lane. (Remember that your right outside mirror is .) Try not to...
Owner's Manual - Page 267
...it is raining.
{CAUTION:
Wet brakes can happen if the road is low. This can cause accidents. When your brakes work as well in one side. There just is dangerous. The best... speeds. Driving too fast through large water puddles or even going fast enough. If you can cause problems, too. After driving through some car washes can see reflections from trees, telephone poles...
Owner's Manual - Page 321
...exists, an overheat protection mode which alternates firing groups of coolant loss, change the oil and reset the oil... page 5-28. See Engine Coolant Temperature Warning Message on location. See Engine Compartment Overview on page 5-12 for more ... on the radiator filler neck. Repair the cause of cylinders helps prevent engine damage. Engine Overheating
{CAUTION...
Owner's Manual - Page 337
...front and rear brakes can change in many parts have to be sure you and gas that can change - for longer storage periods...has the replacement number shown on page 5-12 for battery location. Vehicle Storage
If you are wrong for your vehicle, the..., if someone puts in - be of California to cause cancer and reproductive harm. See Jump Starting on page 5-42 for your brake linings wear down ...
Owner's Manual - Page 370
... capacity, diameter, width, offset and be sure to have the right wheel, wheel bolts and wheel nuts for your vehicle can also cause problems with new GM original equipment parts. See Changing a Flat Tire on your vehicle.
{CAUTION:
Using the wrong replacement wheels, wheel bolts or wheel nuts on page 5-78 for replacement...
Similar Questions
Location For All Fuses For Windshield Wipers And The Motor
i changed the fuse # 29 in the panel i indicated and wipers stip not working is there a fuse some wh...
i changed the fuse # 29 in the panel i indicated and wipers stip not working is there a fuse some wh...
(Posted by xxraixx 10 years ago)
I Have Changed My Thermostat And Waterpump And My Car Is Still Saying Overheatin
I have read and done everything possible to see what the coolent problem was on coolent system on th...
I have read and done everything possible to see what the coolent problem was on coolent system on th...
(Posted by kpmccabe97 11 years ago)
How To Change Egr Valve On 2005 Aztek
how do i change a 2004 azteck egr valve
how do i change a 2004 azteck egr valve
(Posted by ralphwatkins795 12 years ago)