Panasonic CZ-RTC5 Support Question
Panasonic CZ-RTC5 Support Question
Find answers below for this question about Panasonic CZ-RTC5.Need a Panasonic CZ-RTC5 manual? We have 4 online manuals for this item!
Question posted by Sylvslum on August 27th, 2017
How Do I Balance The Heat Equally Between Upstairs And Downstairs?
Please could someone advise how to balance the heat downstairs. When we turn our central heating on it all works well upstairs...however downstairs is still cold. We can feel heat coming out of the vents but it is noticeably cold. Whilst upstairs is stuffy and very hot. I can't find the instructions and manuals online don't seem to address this issue.
Current Answers
Answer #1: Posted by BusterDoogen on August 27th, 2017 7:58 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Go here for some possible solutions to your temp problems.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Panasonic CZ-RTC5 Manual Pages
CZ-RTC5 Installation Manual - Page 5
Dimensions Weight Temperature/ Humidity range Power Source
Clock
Precision
Holding time
Number of connected indoor units
CZ-RTC5 (H) 120 mm x (W) 120 mm x (D) 16 mm 180 g 0 ˚C to 40 ˚C / 20 % to 8 units
5 (EN)
consumption 13
Confirming Information 14 Test ...
CZ-RTC5 Installation Manual - Page 6
...).
Install vertically against the floor. When installing more from the room airflow. • Location where condensation
occurs (The remote controller is induced to each other terminals...occur.
If noise is not moisture proof or drip proof.) • Location near heat source • Uneven surface Keep distance of 1 m or more than 1 remote
controller ...
CZ-RTC5 Installation Manual - Page 7
... main and sub remote controllers After installation, set this unit to [Main]. *CZ-RTC2, CZ-RTC4, CZ-RE2C2, CZ-RELC2
Using 1 indoor unit
RC (main)
RC (sub)
12...
12
RC wiring (field supply) • No polarity
Terminals for RC wiring
R1 R2
Indoor unit
Using more than 1 indoor unit or heat...
CZ-RTC5 Installation Manual - Page 15
...Test run
3 Select [ON]. (The unit enters the test operation mode. Then, [TEST] turns on or operation is automatically turned off in step 3. ([TEST] display disappears.) Any of the units) ... do not operate for purposes other than the test operation. (To prevent overload of the Heat, Cool and Fan operations can only be performed. Temperature cannot be changed. &#...
CZ-RTC5 Operation Manual - Page 1
CZ-RTC5
Installation Instructions Separately Attached. Panasonic Corporation 1006 Kadoma, Kadoma City, Osaka, Japan
Panasonic Corporation http://www.panasonic.com
CV6233312187
Operating Instructions High-spec Wired Remote Controller
Model No. ENGLISH
Before operating the unit, read these operating instructions thoroughly and keep them for future reference.
CZ-RTC5 Operation Manual - Page 4
...easily accessible by users. Other languages are translation of user change /Temp sensor/
Main/sub/Vent output/Contact address...38 Ventilation Setting 40 Setting List 41
...the Panasonic high-spec wired remote controller. Read the Operating Instructions
carefully for Each Air Outlet .......13
• Lock indiv. flap 13 Timer Reservation 14
&#...
CZ-RTC5 Operation Manual - Page 7
... P.20
- Setting information icons displayed on the top screen
Icon
Description
The indoor unit filter needs to be replaced. (Only when using a gas heat pump air conditioner.) Switching operation modes is prohibited. (Switching to be cleaned.
CZ-RTC5 Operation Manual - Page 8
... contents before mains power failure has occurred. If no operation is in
decreased cooling/heating performance. (If the current of outdoor units does not reach the peak due to set....Press . (The operation indicator illuminates.)
To change the setting (P.10)
To turn the energy saving operation ON/OFF Press during operation. (Only for illumination.) The energy ...
CZ-RTC5 Operation Manual - Page 9
...Auto: Cannot be selected in step 2 on page 8. Operation mode (e.g. Heat Dry Cool Fan Auto
*Auto: The mode is not
visible) Cursor
...swing can
stop the flap at your
preferred position.
• 5-level adjustment
is possible
during Heat,
Fan and Auto
(Heat) modes.
9 (EN) Cool, Heat, etc.)
Press ◄.
↓ ↓
Set temperature Press . (When the cursor ...
CZ-RTC5 Operation Manual - Page 11
...Vent output
Contact address
Sets the administrator password.
P.41
*Depending on the right can be used. Restores the temperature
after a
certain period of time each indoor unit.
P.35
Operation Locks the button
lock
operations.
P.39 Interlocks the ON/OFF of the air conditioner... the heat
P.40
exchange ventilation...◄ ► to turn the
P.8
page.
2 FLAP*
Sets fl...
CZ-RTC5 Operation Manual - Page 14
... at the specified time. (e.g.
Turning ON/OFF after 3 hours)
ON
OFF
OFF
ON
Set
3 hours
Operation stop
SSeett
3 hours
Operation stop
• Use OFF timer for example when: Reducing electric consumption while sleeping • Use ON timer for example when: Operating the air conditioner according to the
meeting start timing
1 Display...
CZ-RTC5 Operation Manual - Page 24
... human movements are detected. • Continues to operate in fan only mode. • Heating: Heating will stop and the unit will resume operation to do so, please contact the dealer.
24... activity level.
• Cooling: Target temperature is the same as the set temperature. • Heating: Target temperature is 1 °C lower than the set
temperature.
• Cooling: Target temperature is...
CZ-RTC5 Operation Manual - Page 25
... ECONAVI sensor may judge no person is in the room. Depending on the right. You want to keep air conditioner running while nobody is present, causing the indoor unit to
Note Turn the ECONAVI function OFF if:
- The sensor fails. -
Only infants, babies, or people only with disabled persons or infants...
CZ-RTC5 Operation Manual - Page 27
... the item and set to
5 Set the temperature range Press 2 times to finish.) Setting range • Cool/Dry: 18 °C to 30 °C • Heat: 16 °C to 30 °C • Auto: 17 °C to [Saving], this functions only when the temperature set in series Repeat from step 4 without pressing...
CZ-RTC5 Operation Manual - Page 39
... instructions for the temperature sensor setting, the [Main] sensor controls the operation.)
Vent output
• [Set]: When the air conditioner is turned ON/OFF, the connected ventilation fan is turned ON/OFF, too.
• To interlock the air conditioner and the fan, another installation work is selected for indoor units or outdoor units.
Contact address
• If you...
CZ-RTC5 Operation Manual - Page 42
... sensor of the outdoor unit is restricted.
-
[Schedule peak cut] is set . Switching between Heat and Cool/Dry mode is prohibited (Switching to be replaced (only when the gas heat pump air conditioner is used for ventilation.
(Only when connecting a heat exchange ventilation unit or connecting a
P.40
commercially sold fan)
[Outing function] is set. Page...
CZ-RTC5 Parts List - Page 4
... Installation Instructions
NOTE: Metal and plastic parts will be supplied basically
with an asterisk (*) means the
recommended service parts.
1 8FA0005119600 1 8540530493700 1 8540530492400 1 8140523016900 1 8546460933101 1 8546436985601
CZ-RTC5 High-spec Wired Remote Controller
KeyNo. ATTENTION!
Each key number with necessary heat insulation pads or packing.
Part No.
CZ-RTC5 Quick Reference Guide - Page 6
...prohibited.) 10 The engine oil needs to be replaced. (Only when using a gas heat pump air conditioner.) 11 The indoor unit filter needs to be cleaned.
„ Setting ...heat exchange ventilation unit or connecting a commercially sold fan.) 5 Energy saving operation is in process. 6 [Weekly timer] is set. 7 [ON/OFF timer] is set. 8 Remote control operation is restricted by a central...
CZ-RTC5 Quick Reference Guide - Page 7
...z If no operation is performed for a certain period of time, the backlight turns off to
save electricity. (Press any button for illumination.) z The energy saving operation restricts the maximum current... value, resulting in
decreased cooling/heating performance. (If the current of outdoor units does not reach the peak due to set ...
CZ-RTC5 Quick Reference Guide - Page 8
...;
„ Set temperature Press . (When the cursor is possible
during Heat,
Fan and Auto
(Heat) modes. Heat Dry Cool Fan Auto
*Auto: The mode is automatically switched to Cool or Heat to achieve the set temperature.
• Cool/Dry : 18 °C to 30 °C • Heat : 16 °C to 30 °C • Auto : 17 °...
Similar Questions
No Power To Air Conditioner
hello, I don't have any power to the mini split unit. We tried to change the batteries to the remote...
hello, I don't have any power to the mini split unit. We tried to change the batteries to the remote...
(Posted by Maryams 2 years ago)
Panasonic Ducted Air Conditioner Cz-rtc3
the fan is not starting in the ducted unit in the attic?
the fan is not starting in the ducted unit in the attic?
(Posted by patrickmerrigan 4 years ago)
My Panasonic Cz-rtc5 Keeps Swapping From Warm To Cold Air. Most Annoying. A Symb
as above
as above
(Posted by Anonymous-163312 6 years ago)
I Am Looking For A User Manual For A Panasonic Split Air Conditioner Cs903ke
(Posted by oxenhalltrading 9 years ago)
Where Can I Buy A Panasonic Compact Air Conditioner?
(Posted by dinoclmail 13 years ago)