Onkyo TX-NR525 Support Question
Onkyo TX-NR525 Support Question
Find answers below for this question about Onkyo TX-NR525.Need a Onkyo TX-NR525 manual? We have 3 online manuals for this item!
Question posted by chriskeurentjes on December 9th, 2021
Within 3-5 Seconds Shut Down And Power Off, Onkyo Tx-nr525
Within 3-5 seconds shut down and power off, Onkyo TX-NR525.After some time overheated and shut down, full power volume for 30 minutes with quality speakers, severe marge of max power speakers.Power supply or electronics amplifier faillure ?Please adress to fix in the Netherlands (Near 's-Hertogenbosch).Greetings Chris
Current Answers
Answer #1: Posted by SonuKumar on December 10th, 2021 8:26 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,620,300
Member since:
May 9th, 2021 Points: 16,620,300
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Onkyo TX-NR525 Manual Pages
Owner's Manual English - Page 1
AV RECEIVER
TX-NR525
Instruction Manual
Contents
Safety Information and Introduction 2 Table of Contents 5 Connections 11 Turning On & Basic Operations 20 Playback 24 Advanced Operations 41 Controlling Other Components 57 Appendix 63 Internet Radio Guide Remote Control Codes
En
Owner's Manual English - Page 2
.... Read these instructions. 3. Heed all instructions. 5. Clean only with liquids, such as power-supply
cord or plug is intended to alert the user to the presence of electric shock to escape... persons. En-2
Damage Requiring Service
Unplug the apparatus from being walked on top of time.
14. If liquid has been spilled, or objects have fallen into the apparatus through...
Owner's Manual English - Page 4
... the power supply cord of this apparatus may not correspond with the letter L or coloured red. Supplied Accessories...name indicates the color. Check for purchasing an Onkyo AV Receiver.
Specifications and operations are coloured in the ...antenna (➔ page 18) Power cord (Taiwanese models) (➔ page 20) Speaker cable labels (➔ page 11) Speaker setup microphone (➔ page...
Owner's Manual English - Page 5
... Controlling Other Components 58 Using the Onkyo Dock 61 Controlling Your iPod/iPhone 62
Appendix
Troubleshooting 63 Firmware Update 68 About HDMI 71 Network/USB Features 72 License and Trademark Information 74 Specifications 75
To reset the AV receiver, see page 63. Sp Config (Speaker Configuration 46 5. Digital Audio (Digital Audio Input 46 4. Audio Adjust 48 8.
Owner's Manual English - Page 6
...-Wide Range Amplifier Technology
(5 Hz to 100 kHz bandwidth) • Optimum Gain Volume Circuitry • H.C.P.S. (High Current Power Supply) Massive
High Power Transformer
Processing
• HDMI (Audio Return Channel, 3D, DeepColor, x.v.Color, Lip Sync, 4K Passthrough, DTS-HD Master Audio, DTS-HD High Resolution Audio, Dolby TrueHD, Dolby Digital Plus, DSD and MultiCH PCM)
• Dolby TrueHD...
Owner's Manual English - Page 11
... all you should use , a powered subwoofer is to the corresponding speaker terminal.
Attaching the Speaker Cable Labels
The speaker terminals are also colorcoded and you need to the positive (+) side of each jack.
Speaker Front left Front right Center Surround left Surround right
Color White Red Green Blue Gray
The supplied speaker cable labels are color-coded...
Owner's Manual English - Page 12
...sound will be out of phase and will sound unnatural. C Front speaker R
B Front
speaker L
D Center speaker
Red
Green
White
Gray
Blue
Connections
Before connecting the power cord, connect all of your speakers and AV components.
• Read the instructions supplied with your speakers. • By default, speakers for 5.1-channel surround. In other words, connect positive (+) terminals only...
Owner's Manual English - Page 16
...; On the TV, when you adjust the volume or switch the input on the TV speakers, audio will be switched to "TV/CD".
• The AV receiver will be able to 2ch PCM. (It may be available. Even if the AV receiver is not necessary. You will automatically power on in conjunction when the TV is...
Owner's Manual English - Page 18
..., etc. AM loop antenna (supplied)
Indoor FM antenna (supplied)
Note
• Once your AV receiver is the same as possible from your AV receiver, TV, speaker cables, and power cords.
The audio quality is ready for use the tuner.
■ Analog audio (RCA) Analog audio connections (RCA) carry analog audio. Push. En-18 ■ Coaxial digital audio Coaxial digital connections allow you...
Owner's Manual English - Page 19
... following special functions:
■ System On/Auto Power On When you start playback on a component connected via V, while the AV receiver is on standby, the AV receiver will automatically turn down the volume before connecting your Onkyo components.
• While Zone 2 is inserted in the PHONES
jack, the speakers are turned off .) • When you connect...
Owner's Manual English - Page 20
... & Basic Operations
Turning On/Off the AV Receiver
Connecting the Power Cord
1 (Taiwanese models)
Connect the supplied power cord to the Internet (➔ page 15). Doing so may cause a momentary power
surge that might interfere with any loud surprises when you turn on the AV receiver, always turn down the volume before you turn it off. To...
Owner's Manual English - Page 23
... appears after Audyssey MultEQ Room Correction and Speaker Setup requires you 're using a powered subwoofer and it outputs very low-frequency sound at any speakers during Audyssey MultEQ Room Correction and Speaker Setup.
• If the AV receiver is not detected.
The setup of the volume level of each speaker also can be unmuted automatically when Audyssey...
Owner's Manual English - Page 36
...audio signal channels
are within the listening room. Sp Config (Speaker Configuration)" for audio source with a powerful... two speakers.
%
This is 5.1-channel surround sound.
Suitable for the speaker setup (➔ page 46).
;
9
$
■ Onkyo-Original DSP...audio formats are activated in each channel. This surround system has five main channels of sounds.
*1 The AV receiver...
Owner's Manual English - Page 37
See "On-
%
screen Setup" for more details (➔ page 41). Do l b y T r u eHD
Speaker Layout 9$
9$
DTS
DTS
DTS-HD High Resolution Audio
DTS -HD HR
DTS-HD Master Audio
DT S - Speaker Layout
;9$
■ Listening Modes
Listening Mode Pure Audio*1*2
Pu r eAAu d i o
Direct
Di rec t
Stereo
St e r eo
Mono
Mo n o
Multichannel
Mu l t i c h
Description
Input Source
In this mode...
Owner's Manual English - Page 39
...
Changing the Input Display
When you connect an V-capable Onkyo component, you press again on the AV receiver. Tip • See "Name" in 10 minute steps.
Tip • To unmute, press MUTING again or adjust the volume. • Muting is automatically cancelled when the AV
receiver is displayed. The following information can work properly.
1 Change...
Owner's Manual English - Page 52
... is no audio and no operation for linked operation.
• When the HDMI Through is closed, the names of equipment is not compatible or it to "On", the power consumption in standby mode slightly increases. (Depending on the TV status, the AV receiver will appear on the AV receiver's display and OSD 30 seconds before the...
Owner's Manual English - Page 63
... yourself, contact your Onkyo dealer.
Make sure that all speaker cables and input sources are not shorting. (➔ page 13)
Check the volume. Appendix
Audio
■ There's no sound, or it on the AV receiver
Make sure that is not still connected. If the MUTING indicator is flashing on a TV that the power cord is output...
Owner's Manual English - Page 64
... been adjusted to high positive values, then the maximum master volume possible may be reduced. Video
■ There's no sound with power cords, speaker cables, and the like may degrade the audio performance, so refrain from doing it does for about three seconds and then resume playback.
Try repositioning your cables.
■ The Late Night...
Owner's Manual English - Page 70
... error persists, please contact Onkyo Support and provide the error code.
When the AV receiver has two USB ports, you can use either one.
5 Make sure the AV receiver and TV are denoted by HOME on -screen display will begin. If the USB storage device has its own power supply, use RECEIVER on the TV screen...
Owner's Manual English - Page 75
...
±10 dB, 30 Hz (BASS) ±10 dB, 20 kHz (TREBLE)
Signal to Noise Ratio 100 dB (LINE, IHF-A)
Speaker Impedance 6 Ω ...1611/1710 kHz
Preset Channel
40
General
Power Supply
AC 120 V, 60 Hz (North American and Taiwanese) AC 230...CBL/SAT, GAME, PC, TV/CD, AUX
■ Audio Outputs
Analog
ZONE2 LINE OUT
Subwoofer Pre Outputs
2
Speaker Outputs
Main (L, R, C, SL, SR)
Phones
1 (ø...
Similar Questions
Why Does My Receiver Power On For A Second, Than Power Off Immediately
(Posted by eltrain4968 2 years ago)
Can You Provide A Pdf Copy Of Power Supply Circuit Diagram?
I have Onkyo TX SR501 I purchased it in Saudi Arabia. Now the unit is not getting ON. I've checked t...
I have Onkyo TX SR501 I purchased it in Saudi Arabia. Now the unit is not getting ON. I've checked t...
(Posted by rictutanes 9 years ago)
Onkyo Tx-nr509 How To Prevent Prevent Volume Information From Displaying On Tv
(Posted by led9dizz 9 years ago)
How To Adjust Volume Of Zone 2 Speakers Onkyo Tx-sr601
(Posted by bensctb73 9 years ago)
Hi My Tx Sr307 Does Not Keep The Settings After Power Off
My TX SR307 does not keep the settings for the different speakers after a power off any more. Is the...
My TX SR307 does not keep the settings for the different speakers after a power off any more. Is the...
(Posted by tralei 10 years ago)