2004 Nissan Altima Support Question
2004 Nissan Altima Support Question
Find answers below for this question about 2004 Nissan Altima.Need a 2004 Nissan Altima manual? We have 1 online manual for this item!
Question posted by bobspong on December 15th, 2013
How To Activate 2004 Altima Alarm
The person who posted this question about this Nissan automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 22
... ADJUSTMENT (if so equipped for driver's seat)
Turn either dial to the desired position. They could become trapped in serious accidents. Unattended children could unknowingly activate switches or controls and become involved in a window. If the motor stops during operation, wait 30 seconds, then reactivate the switch. ● Do not operate...
Owner's Manual - Page 37
...system may not function properly. Correct pre-tensioner disposal procedures are used on after activation.
When selling your vehicle to the pre-tensioner seat belt operation. Those with the... collisions, helping to restrain front seat occupants. The pre-tensioner is to prevent accidental activation of a breathing condition should also be done by your NISSAN dealer. ● No...
Owner's Manual - Page 39
..., unless it could cause personal injury. Additionally, if any damage to the front end or side portion of the supplemental front air bags inflate, the activated pre-tensioner seat belts must be replaced. The air bag module and pre-tensioner seat belt system cannot be done only by a NISSAN dealer. Incorrect...
Owner's Manual - Page 42
... in the vehicle than one person to help protect them. Have the system checked by a NISSAN dealer. ● Once the pre-tensioner seat belt has activated, it may reduce its effectiveness. ● Do not allow more people in the system.
See your shoulder. ● Position the lap belt as low and...
Owner's Manual - Page 45
... restraints" later in the latched position. WRS0138 3 4
WARNING
When fastening the seat belts, be activated.
During normal seat belt use by two separate methods: ● When the seat belt is pulled... quickly from the buckle and fully retracted.
Be sure the shoulder belt is activated it is routed over your shoulder and across your chest. Unfastening the seat belts
1
...
Owner's Manual - Page 65
... selected:
The distance to empty (dte) mode provides you with an estimation of the trip computer can be affected by the trip computer change to activate the computer. Press the mode switch if you wish to return to draw the driver's attention. The dte mark (dte) will illuminate in order to...
Owner's Manual - Page 72
... been detected which may exist if the slip indicator blinks on and goes out when the low beams are selected. the cruise control system is activated. Have the system checked by
a NISSAN dealer. Operation The malfunction indicator lamp will blink when the traction control system is operational. Check the fuel filler...
Owner's Manual - Page 73
... . Have the brakes checked as soon as possible if the warning sound is activated. LIC0301
Light reminder chime
With the ignition switch in the ignition switch. Your vehicle...System-NVIS
VEHICLE SECURITY SYSTEM (if so equipped)
The vehicle security system provides visual and audio alarm signals if parts of this is operational. Turn signal/hazard indicator lights
The appropriate light flashes...
Owner's Manual - Page 74
...or trunk lid with the key, or by pressing the button on the keyfob. The alarm is activated by pressing the button on the keyfob. How to indicate all doors are in this section....
4. The hazard lights flash twice and the horn beeps once to stop an activated alarm
The alarm stops only by unlocking a door or the trunk lid with again. Keyfob operation: ● Push the...
Owner's Manual - Page 75
...) This device complies with part 15 of the FCC Rules and RSS-210 of the device. To activate: Press and hold both the and buttons at the same time for at least 2 seconds.
If ... beep feature has been deactivated. Deactivating the horn feature does not silence the horn if the alarm is subject to the following procedures: 1. Operation is triggered. NISSAN VEHICLE IMMOBILIZER SYSTEM (NVIS)...
Owner's Manual - Page 78
... headlights are not correctly aimed, they might temporarily blind an oncoming driver or the driver ahead of you and cause a serious accident. If headlights are active (Canada only), the xenon headlights do not turn off operation. It is close to a NISSAN dealer and have your vehicle to burning out, the brightness...
Owner's Manual - Page 80
... sensor located in the AUTO position 1 . close the driver's or passenger's door, and then close all doors. See your NISSAN dealer to have the autolight activation sensitivity setting adjusted. ● Turn off and the key in the or position, the headlights will illuminate. If the ignition switch is light. ● Keep...
Owner's Manual - Page 81
... are off automatically. The daytime running for full illumination when driving at night.
The instrument brightness control will remain on until the ignition switch is active, tail lights on your headlights. It is started with the headlight switch in the OFF position or in ON position. The daytime running lights illuminate...
Owner's Manual - Page 92
... install the cargo net, attach the hooks to the retainers. In a sudden stop or collision, unsecured cargo could become trapped in a window. They could unknowingly activate switches or controls and become involved in serious accidents.
WIC0285
1. 2. 3. 4. 5. 6. WINDOWS CARGO NET (if so equipped)
The cargo net helps keep packages in the cargo...
Owner's Manual - Page 94
...) to something caught in the ON position. To stop the window, lift the switch up to the OFF position. The auto-reverse function can be activated when the window is closed position which cannot be activated if an impact or load similar to the second detent and release it;
Owner's Manual - Page 96
... turned ON. WIC0264
● The ignition switch is in the ACC or ON position.
The lights will turn off while the 30 second timer is activated when: ● The driver's door is in the OFF position. ● The driver's door is opened and then closed and the ignition switch is in...
Owner's Manual - Page 100
regulations required handheld transmitters to activate the garage door, etc. The phone numbers are "code protected" and manufactured after ...with new batteries. ● position the hand-held transmitter appears to program the HomeLink Universal Transceiver but does not activate the garage door. ● Press and hold the two outside buttons and release when the indicator light begins to ...
Owner's Manual - Page 107
... to remove the key from being opened only from outside . The keyfob can be opened accidentally, especially when small children are located on , and activate the panic alarm by using the keyfob from the outside the vehicle.
Pre-driving checks and adjustments 3-5
Be sure to become wet. ● Do not drop the...
Owner's Manual - Page 109
...cancel switch is in this section for longer than 0.5 second. Using the panic alarm
If you are completely closed.
The panic alarm stops when: ● it has run for 25 seconds. Pre-driving checks...the keyfob is pushed, all doors are near your vehicle and feel threatened, you may activate the panic alarm to ON. See "Trunk lid" later in the ignition switch. Push the 5 seconds. The ...
Owner's Manual - Page 110
... can be deactivated using the keyfob.
3-8 Pre-driving checks and adjustments
Please contact a NISSAN dealer. To activate: Press and hold the and buttons for at least 2 seconds. This opening windows function of the keyfob can... beep feature does not silence the horn if the alarm is triggered. To deactivate: Press and hold the and buttons for at least 2 seconds once more.
Similar Questions
How To Make The 2008 Nissan Altima Horn Silent When Activating The Alarm
(Posted by johnsbig 9 years ago)
Nissan 2004 Altima Trunk Light Blinks When Turn Signals Applied
(Posted by lanneplkw 10 years ago)
