2000 Nissan Quest Support Question
2000 Nissan Quest Support Question
Find answers below for this question about 2000 Nissan Quest.Need a 2000 Nissan Quest manual? We have 1 online manual for this item!
Question posted by fowlerrobin on June 14th, 2012
Not Running Right
not running properly when it warms up it starts dying so i have to keep my foot on the pedal
Current Answers
Related Manual Pages
Owner's Manual - Page 46
...injury or death can occur if the seat belt is being injured or killed in an accident. Never run the belt behind your back, under your arm or across your chest. ARS1134
WARNING ● Every person...; The belt should be greatly reduced if you drive, even if your seat belt and it is properly adjusted. The belt should be worn at all times. Most U.S. SEAT BELTS
PRECAUTIONS ON SEAT BELT ...
Owner's Manual - Page 48
...the rear seat if possible. Larger children
Children who outgrow rear facing child restraints. Never run the lap/shoulder belt over their small hip bones. All US States and Canadian provinces .... The child could cause serious or fatal injury.
The lap belt may not fit them properly. Always use seat belts. NISSAN recommends that it complies with the Federal Motor Vehicle Safety ...
Owner's Manual - Page 93
..., pull off : ABS or , , If any light fails to indicate a low oil level. CAUTION Running the engine with the oil pressure warning light on , it is not designed to come on briefly and ...''Engine oil'' in the electrical system. The following lights come on and stay on until the engine is started: , , , The following lights come on could cause serious damage to do so.
2-6 Instruments and ...
Owner's Manual - Page 94
...is applied, and also warns of this manual for both the parking brake and the foot brake systems. When the ignition key is in the ON position, the light comes ...ON or START position, the supplemental air bag warning light illuminates for approximately 6 seconds and the light illuminates. Supplemental air bag warning light
When the ignition key is running , it may not function properly. If...
Owner's Manual - Page 95
...properly. If the O/D OFF indicator light blinks for repair.
Refuel as soon as it could be driven even in the ''Starting and driving'' section of damage to be dangerous. ● Pressing the brake pedal... you judge it may not be working properly if the warning light is correct, have your vehicle towed because driving it is running, it to the electrical circuits. Otherwise,...
Owner's Manual - Page 96
...driving trips, have the vehicle inspected by an authorized NISSAN dealer. If the CRUISE indicator blinks while the engine is running , it may
Instruments and controls 2-9 indicate a potential emission control malfunction. lamp After a few driving trips, the...lamp on . If the lamp does not turn signal lever is not functioning properly. An emission control system malfunction has been detected.
Owner's Manual - Page 102
... off automatically. It is necessary at a reduced intensity when the engine is released. Failure to do not illuminate. The daytime running lights illuminate once the parking brake is started , the daytime running lights operate with the parking brake released. Make sure the headlight switch is active, tail lights on your headlights. Instruments and...
Owner's Manual - Page 136
... the fuel filler lid, grasp the right hand edge of the fuel system and emission control system.
Failure to tighten the fuel filler cap properly may cause fuel overflow, resulting in ...door cannot be under certain conditions. Then remove the cap. ● Do not attempt to start your vehicle. Continued refueling may cause the malfunction indicator lamp (MIL) to prevent fuel from ...
Owner's Manual - Page 144
...(manual)
WARNING ● The air conditioner cooling function operates only when the engine is running. ● Do not leave children, impaired adults, or pets alone in a closed ...Air flows from defroster outlets. Air flows mainly from center and side ventilators and the front and rear foot outlets.
Heater, air conditioner and audio systems 4-3 See the ''Do it yourself'' section for long ...
Owner's Manual - Page 145
...air control dial to select speed. 3. Rear passenger heat is running. When the position is more than 45°F (7°C). ... of the hot air to be drawn
2. Air conditioning button
Start the engine, turn on (however, the indicator light will not... Position Interior air is operating. Defrosting or defogging
This mode is warmed up . po- Ventilation
This mode directs air to help keep ...
Owner's Manual - Page 146
... in the air conditioner button to the heater operation. Move the temperature control dial to the desired position. 3. AIR CONDITIONER OPERATION
Start the engine, move the fan control dial to the desired (one outlet to four) position, and select an air control position ... defog the windshield. Move the air control dial to the desired position.
Rear passenger heat is running.
2.
Owner's Manual - Page 152
... the OFF button.
The Electronic Automatic Temperature Control (EATC) is located at the extreme right of the control panel. You can override fan speed by rotating the vertical thumbwheel located at...or any of the instrument panel, below the radio. The EATC operates only when the ignition is running. ● Do not leave children, impaired adults, or pets alone in the AUTOMATIC mode. It...
Owner's Manual - Page 180
... engine while warming it to ...And that's true for drugs, too (over , particularly if the loss of the injury. Starting and driving 5-3
●
● ● DRINKING ALCOHOL/DRUGS AND DRIVING
● CAUTION...may cause drowsiness). Remember, drinking and driving don't mix! Keep your vehicle. Running out of people are detected. AVOIDING COLLISION AND ROLLOVER
WARNING Failure to misfire, ...
Owner's Manual - Page 181
...to LOCK and removed until the shift lever is not running. KEY POSITIONS
LOCK (Normal parking position) OFF The engine... the ignition switch is in the ON position, and the foot brake pedal is depressed. Never remove or turn it cannot be moved ... wheel slightly right and left in the ignition.
5-4 Starting and driving START This position activates the starter motor, which starts the engine....
Owner's Manual - Page 182
...foot brake pedal. The shift selector lever cannot be moved out of P and into any of the other gear positions under the following conditions: ● The ignition key is turned to the LOCK position. ● The ignition key is turned to run... key is turned to help start the engine. Warm-up Allow the engine to start , turn the key off the accelerator pedal by turning the ignition key ...
Owner's Manual - Page 188
...malfunctions, it . To properly set speed increases by about 1 MPH (1.6 km/h). When the vehicle attains the speed you do not run the engine over 30... CRUISE light in any gear. ● Avoid quick starts. ● Avoid hard braking as much as possible...., use one of the following three methods: a) Depress the accelerator pedal. Failure to warn the driver. ● When the CRUISE light ...
Owner's Manual - Page 191
...result, your foot on the brake pedal while driving. WARNING ● While driving on the brake pedal is required to... running or is designed to normal. To dry the brakes, drive the vehicle at low speeds. However, greater foot ...pressure on a slippery surface, be harder. Overheated brakes may reduce braking performance and could cause the wheels to operate. As a
5-14 Starting...
Owner's Manual - Page 205
...cover the vent holes as it run for more than 10 seconds. This may be push or tow started . IF YOUR VEHICLE OVERHEATS
If..., apply the parking brake and move the temperature control dial to warm and fan control dial to drive if your engine, carefully disconnect ...it may cause transmission or other vehicle at about 2,000 RPM, and start right away, turn the key off and wait 3 to the P (Park)...
Owner's Manual - Page 223
Start the engine, then move the shift ...°C) using the HOT range. 1. ADI1085
WDI0004
WARNING ● When the engine is running, keep hands, jewelry and clothing away from any moving parts such as it -yourself Park...COLD range on a level surface and set the parking brake. 2. If the level is warmed up and before driving. Reinsert the dipstick into the dipstick tube as far as the cooling...
Owner's Manual - Page 235
... intervals should not change. 4. Run the engine for about 30 seconds; If the brakes do not operate properly, see the appropriate maintenance schedule information in the ''Maintenance'' section of a higher amperage rating than that specified on the fuse box cover. While depressing the brake pedal, start the engine. the pedal height should be followed. With...
Similar Questions
Runs Then Dies
my 1996 nissan quest when driving in hot tempratures will run fine then just die i have to wait till...
my 1996 nissan quest when driving in hot tempratures will run fine then just die i have to wait till...
(Posted by scott510florida 9 years ago)
Nissan Quest 2004- Foot Pedal To The Floor Van Wont Go Above 60
(Posted by CinRobinH 10 years ago)
1993 Nissan Quest Xe Radiator Not Running
I mhave a 1993 nissan quest XE ,My radiator fan wont come on and all my fuses are good
I mhave a 1993 nissan quest XE ,My radiator fan wont come on and all my fuses are good
(Posted by hnj39 10 years ago)
Ecm/relay Problems?
My husband was messing with the wiring trying to connect the fans to the ignition (they weren't gett...
My husband was messing with the wiring trying to connect the fans to the ignition (they weren't gett...
(Posted by susaahn6 11 years ago)