Home » Nissan » Troubleshooting » 1999 Nissan Pathfinder

1999 Nissan Pathfinder Support Question

Find answers below for this question about 1999 Nissan Pathfinder.
Need a 1999 Nissan Pathfinder manual? We have 1 online manual for this item!

Nissan Overview Questions Manuals Reviews Videos Research

Question posted by seradogg on May 28th, 2011

Running Boards

how to remove running board bracket if bolt is spinning

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 30

Never run the belt behind your back, under your arm or across your shoulder. ¼ Position the lap belt as low and snug as possible AROUND THE HIPS, NOT THE WAIST. See your NISSAN dealer. ¼ Removal and installation of the pretensioner seat belt system components should be done by an authorized NISSAN...

Owner's Manual - Page 31

... or near the face and neck, use of a booster seat (commercially available) may not fit them . The seat belt should be placed in this . Never run the lap/shoulder belt over their small hip bones. NISSAN recommends that pregnant women use of approved child restraints for children who are available for...

Owner's Manual - Page 47

... can assist you with the center lap belt or the lap portion of your child restraint. The tether strap anchor bracket is available through the holes. To install the anchor bracket, a metric bolt of exhaust fumes entering the passenger compartment through your child restraint has a tether strap, it must be used for adult...

Owner's Manual - Page 76

... to turn the switch off . ¼ Do not put anything hard or heavy on the instrument panel can be removed immediately with a pin or similar object. Start the engine. Push the (Low) or (High) position of the switch, ...use the seat heater for extended periods or when no one is not running. 2. The battery could run down if the heater is operated while the engine is using the seat.

Owner's Manual - Page 82

...place cargo higher than the seatbacks. Instruments and controls 2-29 SPA0346A ¼ Make sure the luggage board closes securely. ¼ Do not drive with seats and seat belts. In a collision, people ...allow anyone to ride in the fold-down position. ¼ It is not equipped with the board removed. Do not place valuable items in the luggage side console box. ¼ Properly secure all cargo...

Owner's Manual - Page 113

...SPA0952 ¼ When changing batteries, do not let dust or oil get wet, immediately wipe completely dry. Remove the battery. 3. Recommended battery: Sanyo CR2025 or equivalent Make sure that the ⊕ side faces the ... button two or three times to touch a circuit board and a battery terminal. ¼ An improperly disposed battery can harm the environment. Close the lid securely.

Owner's Manual - Page 127

...control dial to the desired position between the middle and the hot position. ¼ To quickly remove ice or fog from the floor outlets. 1. posi- Turn the air control dial to the...or defogging This mode is drawn into the passenger compartment. As soon as possible after the window is running. Turn on the fan control dial. 4. Push the air recirculation button to the off position. ...

Owner's Manual - Page 140

... or again, or the button. Push the button again to the display window. The tape runs quickly, stops, then plays the next selection. Heater, air conditioner and audio systems 4-17 The...tape automatically changes directions to play the other side when the first side is playing to be removed periodically with labels which are peeling and loose. The use cassettes with a head cleaning tape....

Owner's Manual - Page 156

... LOCK and ACC, although it gently while rotating the steering wheel slightly right and left. Never remove the key while driving. KEY POSITIONS LOCK (Normal parking position) (0) OFF (1) The engine can...so that the key cannot be moved toward the LOCK position. 4) Remove the key. If the key is not running. When removing the key from the ignition switch, the selector lever cannot be turned...

Owner's Manual - Page 157

... the use of the other devices. ¼ Make sure the area around the vehicle is removed from the registered Nissan Vehicle Immobiliser System key. Restart the engine while holding the device (which... likewise. ¼ Check the operation of the driving positions. If the engine starts, but fails to run, repeat the above procedure. - If the engine is very hard to operate if the selector lever is...

Owner's Manual - Page 159

...an accident injuring yourself and others. These instructions for this selector position when the vehicle is running and the brake pedal depressed, the stop . Apply the parking brake. Depress the brake ...N (Neutral) should only be used for starting the engine. Shut the engine off and remove the key. 2. All other positions can 5-10 Starting and driving If the selector lever cannot...

Owner's Manual - Page 173

...off while driving, the power assist for the steering will not work. If the engine is not running or is designed to use a hydraulic pump, driven by the engine, to assist steering. POWER STEERING...curb and move away from the center of the vehicle. However, much harder to the LOCK position and remove the key. Failure to engage the transfer shift lever in H or 4L could result in the vehicle ...

Owner's Manual - Page 174

... gas mileage. Using the system Depress the brake pedal and hold it down a slope or long grade, reduce speed and downshift to minimize swerving and spin- This will not work. Doing so may feel a pulsation in an accident. ¼ If the engine is not...

Owner's Manual - Page 177

... and stiff-bristled brush to refill the reservoir tank. Extra window washer fluid to remove ice and snow from around your heater with care. these conditions. Accelerate and slow...ENGINE BLOCK HEATER (if so equipped) An engine block heater to avoid driving on . A sturdy, flat board to be slick and very hard to give it . If accelerating or downshifting too fast, the drive ...

Owner's Manual - Page 186

...if the booster battery is in the sequence as it run for a few minutes. 6. In case of the...if so equipped). Do not keep starter motor engaged for example, engine lift bracket, etc. - not to do not contact any moving parts in the ...off all unnecessary electrical systems (light, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). If the engine does ...

Owner's Manual - Page 187

... 4. If engine overheating is coming from the radiator before proceeding. 5. When the radiator cap is removed, pressurized hot water will spurt out, possibly causing serious injury. ¼ Do not open the ...hoses and radiator should not be damaged. ¼ Never try to drive if your vehicle is running. when the engine starts, the forward surge could cause a vehicle fire. ¼ To ...

Owner's Manual - Page 201

... closely observed. ¼ Always wear eye protection whenever you work on your vehicle. ¼ If you must run the engine in an enclosed space such as rings, watches, etc. If it is necessary to remove necktie and any jewelry, such as a garage, be aware that incomplete or improper servicing may result in...

Owner's Manual - Page 206

Run the engine until it clean. Remove the dipstick and wipe it reaches operating temperature. 3. If the oil level is not covered by warranty. ...the severity of oil can damage the engine, and such damage is below the L mark, remove the oil filler cap and pour recommended oil through the opening. Remove the dipstick again and check the oil level. Do-it all the way. 5. ENGINE OIL ...

Owner's Manual - Page 208

...5. Turn the engine off . 3. Park the vehicle on the new filter with oil filter removal on the mounting surface of children. SDI0417 SDI0488 CHANGING ENGINE OIL FILTER 1. This tool can ...oil may be hot. 4. Check the oil level. AUTOMATIC TRANSMISSION FLUID Be careful not to remove any moving parts such as fan and drive belt. ¼ Automatic transmission fluid is poisonous ...

Owner's Manual - Page 216

... clear after cleaning the blades and using the windshield washer of the windshield with the air cleaner removed. Pull the wiper arm. 2. Push the lock pin, then remove the wiper blade. 3. Insert the new wiper blade to start the engine with a washer solution... injury. If it with clear water. Clean the outside of if a wiper blade chatters when running, wax or other material may be burned.