1997 Nissan Pickup Support Question
1997 Nissan Pickup Support Question
Find answers below for this question about 1997 Nissan Pickup.Need a 1997 Nissan Pickup manual? We have 1 online manual for this item!
Question posted by olusanqadr on October 22nd, 2013
How To Remove And Install A Clutch In A 97 Nissan Pickup 4 Cylinder 4 Speed
The person who posted this question about this Nissan automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 14
...come on at a NISSAN dealer. For additional details on . 3. Low brake fluid warning
The light warns of the following : 1. Add brake fluid as necessary. See ''Brake and clutch fluid'' in the ON...supplemental air bag needs servicing and your vehicle must be safe, drive carefully to your nearest authorized NISSAN dealer: 1.
If any of a low brake fluid level. Unless checked and repaired, the ...
Owner's Manual - Page 17
... control system, which caused the engine to misfire. ● fuel filler cap was left off or improperly installed, allowing fuel to the position for full illumination when driving at a reduced intensity when the engine is started...instrument lights come on . AIC0739
Lighting
Turn the switch to an authorized NISSAN dealer and have cccurred. position: Turn the switch to select the low beam.
Owner's Manual - Page 25
... shade with the lock nuts, then securely tighten the lock nuts.
1-18
Removing the sun shade
1. IC0198
AIC0706
Closing
Pull the handle forward to remove it. Turn each knob counterclockwise while lifting the sun shade upward. 2. WARNING Do not remove or install the sun shade while driving so that full attention may be given...
Owner's Manual - Page 26
... is in line with the hinge. 2. Pull the sunroof up from outside of the handle and push the sunroof upwards to the roof panel.
5.
Installing the sunroof
1. Remove the sun shade before removing the sunroof. 2. WARNING Do not remove the sunroof while driving so that full attention may be given to the left and...
Owner's Manual - Page 32
Then remove the cap. ● Use only a genuine NISSAN fuel filler cap as a replacement. The support stays hold the tailgate open flames or sparks near the vehicle when refueling. ● Fuel may come on. ...
Owner's Manual - Page 43
... should also be used on the supplemental air bag system should be modified or disconnected. Installation of the supplemental air bag or damage to the supplemental air bag system. ●...Owner's Manual.
2-16 The yellow SRS wiring should not be done by an authorized NISSAN dealer. Tampering includes changes to the appropriate sections in serious personal injury. Unauthorized electrical...
Owner's Manual - Page 47
... collision at your NISSAN dealer. WARNING ● Do not install a child restraint in the system. The lap belt may not fit them .
Infant or small child
NISSAN recommends that infants ...should be seated and restrained by your vehicle and always follow the manufacturer's instructions for installation and use during a collision be
replaced unless the collision was minor and the belts ...
Owner's Manual - Page 49
...seat belt automatically retracts.
Checking seat belt operation
Seat belt retractors are designed to lock during this section for child seat installation. PD1024M
The retractor is designed to lock belt movement by a passenger, the locking mode should not be extracted again ... seat belt has a cinching mechanism for more information. It is visible.
To increase your NISSAN dealer.
Owner's Manual - Page 51
.... ● Periodically check to use a child restraint can use could be used with the installed seat belts. Failure to see that the seat belt and the metal components, such as buckles..., tongues, retractors, flexible wires and anchors, work properly. WARNING ● Only NISSAN belt extenders, made the original equipment belts, should be placed in an appropriate child restraint...
Owner's Manual - Page 53
... as the belt retracts. Pull up on the lap belt until you choose to remove any slack in a sudden stop or collision. Always follow the child restraint manufacturer's instructions for belt routing. Pull upward on the belt to install a child restraint, follow these steps: 1. A clicking sound is fully retracted. 4. Route the seat...
Owner's Manual - Page 54
...engage. 2-27
3.
4.
5.
6. Ensure the retractor is canceled; After the child restraint is removed and the seat belt is properly secured prior to each use force to tilt the child restraint ...on the seat, as normal and will only lock during a sudden stop or impact. 5. If you install a child restraint in the center of the retractor, the belt is securely held in the child restraint...
Owner's Manual - Page 56
.... Tilt operation
Pull the lock lever down and adjust the steering wheel up firmly to lock the steering wheel in place. Your NISSAN dealer can assist you with the installation of your child restraint. Push the lock lever up or down to the anchor points. You could lose control of your vehicle...
Owner's Manual - Page 73
... il3-14
Precautions on cassette player operation
● To maintain good quality sound, NISSAN recommends using cassette tapes of Dolby Laboratories Licensing Corporation. PLAY/STOP button
Push the PLAY... cases, away from the player when not in length. ● Cassette tapes should be removed from direct sunlight, heat, moisture and magnetic sources. If there is a blank interval within...
Owner's Manual - Page 79
... or chrome cassette tape. ● Do not use . This residue accumulation can be removed periodically with a head cleaning tape. Store cassettes in their protective cases, away from the...player operation
● To maintain good quality sound, NISSAN recommends using cassette tapes of a deformed cassette may cause the cassette to remove the antenna before washing the vehicle in the player...
Owner's Manual - Page 108
...links of the tire chain must be secured or removed to prevent the possibility of whipping action damage to location. Never install tire chains on dry pavement. However, some ...heat the key before installing tire chains. before inserting it -yourself operations'' section. In addition, drive at a reduced speed, otherwise, your vehicle on snowy or icy roads, NISSAN recommends the use on ...
Owner's Manual - Page 121
... (N) position. ACE0705
4-WHEEL DRIVE MODELS
NISSAN recommends that a dolly be greater, remove the front and rear propeller shafts beforehand to...Speed: Below 30 MPH (48 km/h) ● Distance: Less than 40 miles (64 km) Manual transmission model: ● Speed: Below 60 MPH (97 km/h) ● Distance: Less than 500 miles (805 km) If the speed or distance must necessarily be greater, remove...
Owner's Manual - Page 151
...originally installed:
Halogen light Wattage 65/35 Bulb No. Be careful not to disturb the aiming adjustment screws. 5. Remove the...removing the headlight from the headlight housing, remove the wiring connector from the rear end of the bulb. DI0075
ADI0732
3. H6059 Incandescent light Wattage 65/55 Bulb No. 6052 ● When aiming adjustment is on the lens is necessary, contact your NISSAN...
Owner's Manual - Page 155
...removed to prevent the possibility of the tire. Never exceed the maximum speed rating of whipping action damage to the fenders or undercarriage. For additional traction on the front wheels. Check the local laws before installing studded tires. When installing... tires
NISSAN specifies summer tires on some areas. Summer tire performance in snowy or icy conditions, NISSAN recommends the...
Owner's Manual - Page 189
... to be used to bring all weights below the ratings. These ratings are exceeded, move or remove items to carry a slide-in camper, the total cargo load of the truck consists of the... figure, plus: ● the weight of installed additional camper equipment not included in the camper. TRAILER TOWING
When the truck is available from your NISSAN dealer. The total cargo load should not exceed...
Owner's Manual - Page 192
...vehicle brake system. Make sure the trailer hitch is installed. ● To reduce the possibility of your ... Pre-towing tips
● Be certain your authorized NISSAN dealer. Trailer lights
Trailer lights should be in use...removed, seal the bolt holes to prevent exhaust fumes, water or dust from the rear, where practical, remove the hitch when not in use.
check for pickup...
