Get support for 2007 Mercury Milan

2007 Mercury Milan Support Question

2007 Mercury Milan Support Question

Find answers below for this question about 2007 Mercury Milan.
Need a 2007 Mercury Milan manual? We have 8 online manuals for this item!
Question posted by onbaz on March 14th, 2014

How To Check Transmission Fluid Level On 2007 Milan

The person who posted this question about this Mercury automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 233

...and lower lines. Do not add fluid if the level is in the reservoir. While the engine idles, turn off . 4. Check the fluid level in this range. 5. If the fluid is low, add fluid in small amounts, continuously checking the level until the above driving cycle is ... and C). 2. Be sure to put the cap back on the reservoir. 233 2006 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)
Owner's Manual - Page 235

...correct. 235 2006 Milan (mln) Owners Guide (post-2002-fmt) USA (fus) Remove the dipstick and inspect the fluid level. High fluid level Fluid levels above 50°F (10°C). The fluid should be in between the notches if at normal operating temperature 149°F (65°C) on a level surface. Correct fluid level The transmission fluid should be checked at normal operating...
Owner's Manual - Page 237

... the recommended fluid level may result in transaxle failure. Adjusting automatic transmission fluid levels Before adding any fluid, make sure the correct type is used is necessary at the proper fluid temperature. Note: Only one ATF fluid specification has been tested and approved for use with the automatic 6-speed without damage or voiding warranty. 237 2006 Milan (mln) Owners...
Scheduled Maintenance Guide 1st Printing - Page 14

... VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 10,000 miles ❑ Change engine oil and replace oil filter. ❑ Inspect tires for wear and rotate. Inspect automatic transmission fluid level, if equipped with zerk fittings. Inspect brake pads/shoes/rotors/drums, brake lines & hoses, and parking brake system. Inspect engine cooling system and hoses. Lubricate...
Scheduled Maintenance Guide 1st Printing - Page 17

... TRUCKS, FULLSIZE VANS & SUVS 40,000 miles ❑ Change engine oil and replace oil filter. ❑ Inspect tires for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with zerk fittings. Inspect and lubricate 4X4 front axle shaft U-joints (F250/350/450/550). Lubricate ball joints and steering linkage if equipped...
Scheduled Maintenance Guide 1st Printing - Page 20

... ❑ optimal tire life. Replace cabin air filter, if equipped. Inspect engine cooling system and hoses. Rotation recommended for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with zerk fittings.
Scheduled Maintenance Guide 1st Printing - Page 23

... SCHEDULE TRUCKS, FULLSIZE VANS & SUVS 100,000 miles ❑ Change engine oil and replace oil filter. ❑ Inspect tires for wear and rotate. Inspect automatic transmission fluid level, if equipped with zerk fittings. Multi-point inspection (recommended) Normal Schedule Trucks, Fullsize Vans & SUVs DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: Scheduled Maintenance 23 Normal...
Scheduled Maintenance Guide 1st Printing - Page 26

... 125,000 miles ❑ Change engine oil and replace oil filter. ❑ Inspect tires for wear. Rotation recommended for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with zerk fittings. Inspect engine cooling system and hoses. Lubricate ball joints and steering linkage if equipped with dipstick. ❑ Inspect brake pads...
Scheduled Maintenance Guide 1st Printing - Page 29

... ❑ Change engine oil and replace oil filter. ❑ Inspect tires for endplay and noise. Inspect wheel ends for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with dipstick. Multi-point inspection (recommended) Normal Schedule Cars & Minivans DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: Scheduled Maintenance 29 Normal Schedule Cars...
Scheduled Maintenance Guide 1st Printing - Page 32

... ❑ Change engine oil and replace oil filter. ❑ Inspect tires for endplay and noise. Inspect wheel ends for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with dipstick. Multi-point inspection (recommended) DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 50,000 miles ❑ Change engine oil and replace oil filter...
Scheduled Maintenance Guide 1st Printing - Page 34

...suspension and, if equipped, half shafts, driveshaft and U-joints. ❑ Replace cabin air filter, if equipped. ❑ Check air filter restriction gauge, replace filter as ❑ required (Focus only). Multi-point inspection (recommended) DEALER VALIDATION: RO#:...10065; Inspect tires for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with dipstick.
Scheduled Maintenance Guide 1st Printing - Page 37

... oil filter. ❑ Inspect tires for optimal tire life. Replace cabin air filter, if equipped. Rotation recommended for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with dipstick. Multi-point inspection (recommended) DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: Scheduled Maintenance 37 Normal Schedule Cars & Minivans Rotation recommended...
Scheduled Maintenance Guide 1st Printing - Page 39

... oil filter. ❑ Inspect tires for ❑ optimal tire life. Replace cabin air filter, if equipped. Rotation recommended for wear and rotate. ❑ Inspect automatic transmission fluid level, if equipped with dipstick.
Owner Guide 1st Printing - Page 256

... for fluid checks and changes. Do not add fluid if the level is warmed up (approximately 20 miles [30 km]). The fluid level will drop slowly as the brakes wear, and will be between the MIN/MAX or upper and lower lines. TRANSAXLE FLUID Checking 5-speed automatic transaxle fluid (If equipped) Refer to your vehicle has been 256 2007 Milan (mln...
Owner Guide 1st Printing - Page 257

... the fluid level is fully seated in between the notches if at normal operating temperature 149°F (65°C). 257 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus) The transmission fluid should be in the filler tube. 7. Latch the gearshift lever in the designated areas for about 30 minutes to allow fluid to cool before checking...
Owner Guide 1st Printing - Page 258

... is correct. An overfill condition of a non-approved automatic transmission fluid may cause shift and/or engagement concerns and/or possible damage. Use of transmission fluid may cause internal transaxle component damage. However, the fluid level should be removed by an overheating condition. The type of fluid leakage. 258 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus...
Owner Guide 1st Printing - Page 259

... temperature (140°F-158°F [60°C-70°C]) Automatic transmission fluid expands when warmed. Move the gearshift lever to engage (approximately 10-15 seconds in city traffic during hot weather or pulling a trailer, the vehicle should be re-checked at the proper fluid temperature. 259 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)
Owner Guide 1st Printing - Page 260

... all on the dipstick and also in the Maintenance product specifications and capacities section in damage to internal transaxle components. 260 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus) Adjusting automatic transmission fluid levels Before adding any fluid, make sure the correct type is correct. Do not use with the automatic 6-speed: Premium Automatic...
Owner Guide 1st Printing - Page 261

.... Remove the filler plug and inspect the fluid level. 6. Fluid level should be at bottom of vehicle damage and/or personal burn injuries do not remove it while the engine is running. 261 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus) Maintenance and Specifications Checking and adding manual transmission fluid (if equipped) 1. Engage the parking brake fully...
Owner Guide 1st Printing - Page 267

... mark. 3 Service refill capacity is determined by the indication on the dipstick's normal operating range. 5 The Power Transfer Unit is lubricated for fluid level checking or filling of transmission fluid and fluid level should be checked or changed unless a leak is not mandatory. Replace Power Transfer Unit lubricant with an in your authorized dealer for life with synthetic...

Similar Questions

Ask a New Question
Use the box below to post a new question about this Mercury automobile .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Mercury Manuals

Find free 2007 Mercury Milan manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Mercury Reviews

View thousands of Mercury user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Mercury customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Mercury customer service rankings, employee comments and much more from our sister site.

Mercury Recalls

Find comprehensive Mercury recall information updated hourly on RecallOwl.com.