2010 Mazda MAZDA3 Support Question
2010 Mazda MAZDA3 Support Question
Find answers below for this question about 2010 Mazda MAZDA3.Need a 2010 Mazda MAZDA3 manual? We have 1 online manual for this item!
Question posted by stephcote75 on December 14th, 2012
Mazda3 2010 Sedan Won't Start - Battery ??
Car won't start, no noise, no lights, no indicators. Tryed to recharge the battery, all internal lights flashed, but the engin still wouldn't start. Tryed boosting the car with a friend and the initial problem came back, no noise, no lights, no indicators...
How can such a recent model with less than 15000 km on the odometre can't start ??
Please advise,
Stephanie
Current Answers
Answer #1: Posted by doosaybee on January 21st, 2013 9:16 AM
doosaybee
Member since:
January 1st, 2013 Points: 367,830
Member since:
January 1st, 2013 Points: 367,830
It sounds like you need a new battery. I have a 2008 Mazda3 and the same thing happens all the time. Did you leave the lights on? The entire car dies if you do this and you unfortunately can't even move the car if it is in a hard spot to jump!! I would purchase a brand new battery and hopefully this will solve your problem. Good luck!
Related Manual Pages
Owner's Manual - Page 80
... key is near equipment such as you see the green KEY indicator light in the instrument cluster begin flashing for 30 seconds after turning off the engine, otherwise, you will not be obtained at certain gas stations. Ø The advanced key may consume battery power excessively if it may not function correctly under direct sunlight...
Owner's Manual - Page 81
... used batteries according to the following conditions indicate that the battery power is low: l The KEY indicator light (green) flashes in the instrument cluster for about 30 seconds after the engine is ... Start System
qAdvanced Key Maintenance
Replacing the battery at an Authorized Mazda Dealer is installed with the same type battery (CR2025 or equivalent). Ø Dispose of the battery using...
Owner's Manual - Page 88
...Mazda
Advanced Keyless Entry and Start System
Ignition positions Each time the push button start is pressed, the ignition switches in the battery going dead.
The indicator light (ACC) illuminates. NOTE... P (automatic transaxle) or to ACC, and the doors will operate. The engine starts by pressing the push button start has been pressed to 1st gear or R (manual transaxle) is in P ...
Owner's Manual - Page 90
... the operational range. (Forced engine starting system and the inability to start using these methods. The advanced key battery is depressed to start the engine, the engine may not start the engine or switch the ignition to ACC or ON. Press and hold the push button start indicator light (green) illuminate.
3-14 Press the push button start after the KEY indicator light (green) in the...
Owner's Manual - Page 91
... does not start indicator lights (ACC and ON) turn it in the key slot. After starting the engine, the push button start , have your vehicle inspected by an Authorized Mazda Dealer (page 7-17). Knowing Your Mazda
Advanced Keyless Entry and Start System
NOTE
l
l
l
After starting the engine, let it idle for reasons such as the advanced key battery is dead...
Owner's Manual - Page 92
...engine off . If the transmitter does not operate when pressing a button or the operational range becomes too small, the battery may vary due to about 2.5 m (8 ft) from ON, the KEY indicator light (green) flashes... when the push button start is open. To install a new battery, refer to the P position. 3.
The hazard warning lights will stop the engine while driving the vehicle....
Owner's Manual - Page 95
.... (Automatic transaxle) When carrying another advanced key, depress the brake pedal until the KEY indicator light (green) illuminates. Starting the engine The engine can be started with Key (page 3-31). To restore these functions, perform any one of a dead transmitter battery or malfunction. l While carrying an advanced key which has had its functions temporarily suspended. Advanced...
Owner's Manual - Page 96
... vehicle. (A beep sound will flash continuously when the push button start has not been switched off ...the KEY warning light (red) remains illuminated, do not continue to Starting the engine (page 3-11...car cannot be locked, and the battery power will be heard six times. Knowing Your Mazda
Advanced Keyless Entry and Start System Warning Lights and Beep Sounds
qSystem Malfunction Warning Light...
Owner's Manual - Page 97
... for a front door is pressed under the following conditions, the KEY warning light (red) flashes to inform the driver that the KEY indicator light (green) does not flash even if the battery power is low. qAdvanced Key Battery Dead Warning
When the push button start has not been switched to off from the luggage compartment/trunk may not...
Owner's Manual - Page 99
.... Check whether the push button start has been switched off . Replace the When the KEY indicator light (green) flashes in the instrument cluster. Authorized Mazda...battery with a new one.
instrument cluster. Park the vehicle in the instrument cluster flashes.
Warning When a door is low. When a door is heard 6 times, and the KEY warning light (red) in When the KEY warning light...
Owner's Manual - Page 115
...it 's closed. qTrunk Light
The trunk light is on the trunk lid...long period when the engine is not running.
3-39 Knowing Your Mazda
Doors and Locks
Opening the trunk lid with keys and locking their cars, parents should be aware... that children may be tempted to play around vehicles and use the trunk as a hiding place.
NOTE
To prevent the battery from ...
Owner's Manual - Page 131
... the push button start .
Close and lock all doors. The security indicator light in the key slot, remove it. 2. The hazard warning lights will also arm the theft-deterrent system: Close the hood and the liftgate/trunk lid . If the system is triggered again, the lights and horn will flash when the battery is opened with the...
Owner's Manual - Page 153
...ACC with the key inserted, a continuous beep sound will be inspected before the engine is started . The warning lights (except brakes) should be heard when the driver's door is important to switch... systems and run the battery down . This does not indicate an abnormality. Leaving the key in this position.
NOTE
When the ignition switch is started in any position but ...
Owner's Manual - Page 158
... does not indicate a malfunction. The problem is jump-started to charge the battery, uneven rpm occurs and the ABS warning light may illuminate the brake system warning light and the ABS warning light on for example) which usually have an accident.
The warning light stays on simultaneously. The sound of surface layer when the wheels skid. Recharge the battery.
qElectronic...
Owner's Manual - Page 182
... pressure sensor is not installed to the vehicle, especially around the wheels. qSystem Error Activation
When the TPMS warning light flashes, there may be a tire puncture.
Driving Your Mazda
Starting and Driving
If the warning light illuminates again even after the tire pressures are adjusted, there may be a system malfunction. Changing tires and wheels...
Owner's Manual - Page 192
... the result of the weak battery and does not indicate an ABS malfunction. If the electronic brake force distribution control unit determines that some components are operating incorrectly, the control unit may illuminate. NOTE
When the engine is jump-started to charge the battery, uneven rpm occurs and the ABS warning light may illuminate the brake...
Owner's Manual - Page 199
... drive the vehicle with the KEY warning light illuminated: If the KEY warning light remains illuminated, do not continue to ACC even if it illuminates momentarily and then turns off . The advanced key battery is pressed ON, it is being used.
l l l l
l
When the push button start will flash continuously while the temporary spare tire is...
Owner's Manual - Page 200
... with a metal object or it is inside the vehicle: The push button start has not been pressed off to notify the driver that the KEY indicator light (green) does not flash even if the battery power is armed.
5-50
í
Some models.
KEY Indicator Light (Green) When illuminated When the brake pedal is depressed with an automatic...
Owner's Manual - Page 325
... BRAKE Advanced Keyless Entry System related KEY BATTERY IS LOW ADVANCED KEY NOT FOUND MOVE SHIFT LEVER TO P STEERING WHEEL LOCK NOT RELEASED TURN WHEEL LEFT AND RIGHT DEPRESS BRAKE PEDAL TO START ENGINE DEPRESS CLUTCH PEDAL TO START ENGINE USE AUXILIARY KEY
l l l l l l l
NOTE 4. qSettings
The following warning indicators are displayed according to turn off (TIRE...
Owner's Manual - Page 475
...deactivated. The method for the advanced keyless entry system can be adjusted. Initial Setting Deactivated After Setting Change Activated
Activated High High
Deactivated Low/Deactivated Low... carrying the key can be activated.
The advanced key's remaining battery level warning light in the instrument cluster can be deactivated. The advanced key function...start can be selected.
Similar Questions
How To Start 2010 Mazda 3 With Battery Dead On Advance Key
(Posted by Machiel 9 years ago)
2010 Mazda 3 Won't Start Gauges Moving Door Light Flashing
(Posted by Chrirudyva 9 years ago)
2010 Mazda 3 Security Light Stays On And Car Won't Start
(Posted by jceohtani 10 years ago)