2005 Mazda MPV Support Question
2005 Mazda MPV Support Question
Find answers below for this question about 2005 Mazda MPV.Need a 2005 Mazda MPV manual? We have 1 online manual for this item!
Question posted by kflocker on November 3rd, 2012
Front Bumper Polystyrene Foam
How do I replace the support polystyrene foam type support for the front bumper?
Current Answers
Related Manual Pages
Owner's Manual - Page 13
... Seats) ...2-8 Second-Row Seats ...2-12 Third-Row Seat ...2-20 Flat Folding ...2-28 Seat Belt Systems ...Seat Belt Precautions ...3-Point Type Seat Belt ...Front Seat Belt Pretensioner and Load Limiting Systems ...2-Point Type Seat Belt ...Seat Belt Extender ...Seat Belt Warning Light ...Seat Belt Warning Beep ...Child Restraint ...Child Restraint Precautions ...Installing Child...
Owner's Manual - Page 15
... the supplemental restraint system. In a sudden stop or collision, the seat or seatback could lose control of the Front Seats: Modifying or replacing the front seats such as replacing the upholstery or loosening any need to remove or reinstall the front seats. Such modifications could damage the supplemental restraint system and result...
Owner's Manual - Page 16
...important role in your protection in a reclined position while the vehicle is moving is dangerous because you support the seatback while operating the seatback lever. Mazda MPV_8T50-EA-04G_Edition1 Page16 Monday, June 28 2004 ...Make sure the lever returns to its original position and the seatback is not supported, it will flip forward suddenly and could cause injury.
2-4
Form No.8T50-EA-04G
...
Owner's Manual - Page 17
Front of seat bottom
qLumber Support Adjustment (Driver's Seat) í
The amount of seat bottom
qHead Restraint
WARNING
Up
Down
Head...with the head restraints adjusted too low or removed is dangerous. Up
Down
Rear of lumber support can be adjusted by rotating dial. With no support behind your head, your neck could be adjusted by rotating the dial.
Mazda MPV_8T50-EA-04G_Edition1...
Owner's Manual - Page 25
... returns to its original position and the seat is locked in place by attempting to push it can allow a passenger to its original position, also replace the seat belt to sit or stand on the folded seatback is dangerous as a bench seat.
NOTE
Make sure the lever returns to its original...
Owner's Manual - Page 26
... hit and injure the occupants in a reclined position while the vehicle is moving is not supported, it forward and backward. Don't recline the second-row seatback when the thirdrow seat is...collision. To change the seatback angle, lean forward slightly while raising the lever.
With no support behind your head, your neck could be seriously injured in place by attempting to push it...
Owner's Manual - Page 27
...-row seat belt over the armrest is parallel with the top of a second-row seat belt over the armrest.
2-15
Form No.8T50-EA-04G Type A
Type B
Adjust the head restraint so that the top is dangerous as it up on the head restraint. To lower the head restraint, press the stopcatch...
Owner's Manual - Page 38
...No.8T50-EA-04G
During sudden braking or a collision, passengers could be securely closed. Without the support of the seatback when it is folded down a driveway or with the third-row seat facing ... seatback rearward onto the rear bumper. Clear away all cargo from the seat well area before placing the third-row seat in serious injury or death. Support Bar: Sitting in injury. ...
Owner's Manual - Page 86
... children will not find or play with power windows or other controls, or even make a replacement key. They could result in a place where your Authorized Mazda Dealer with the code number ready...another safe and handy place, but not in the vehicle. The keys operate all locks. Type A
Retractable type key
Key code number plate
3-2
Form No.8T50-EA-04G Mazda MPV_8T50-EA-04G_Edition1 Page86...
Owner's Manual - Page 90
...the plus and minus terminals of explosion if the battery is installed with the same type battery (CR1620 or equivalent).
When replacing the battery, be careful not to get oil on the alarm Pressing the panic ...instructions. CAUTION
l
l
Make sure the battery is not correctly replaced. There is the danger of the battery using cellophane or equivalent tape. Never deform or crush.
Owner's Manual - Page 125
... handling.
Drive carefully and avoid bumps, holes, and sharp turns. it necessary to replace them with all year around. Inspect the battery and its cables. Use washer fluid ...roads. l
l l
CAUTION
Check local regulations before using studded tires. Use only the same size and type tires (snow, radial, or nonradial) on a temporary spare tire; Mazda MPV_8T50-EA-04G_Edition1 Page125 Monday,...
Owner's Manual - Page 131
... accident. Don't load and unload vehicle while adjusting hitch. This action will reduce the bumper's performance.
Trailer tire size, load rating, and inflation pressures should conform to the recommended... make no exhaust gas leaks into the passenger compartment if any that stiffens the bumper as it causes greater trailer sway from crosswinds, rough roads or other foreign elements...
Owner's Manual - Page 256
... 28 2004 4:0 PM
Black plate (256,1)
In Case of "recreational towing" is not designed for towing.
They are designed ONLY for towing will damage the bumper. Using them for tying down the vehicle when it's being transported.
Owner's Manual - Page 260
... I
ENGINE Engine oil Engine oil filter Drive belts PCV valve*1 IGNITION SYSTEM Spark plugs (Platinum tipped type) FUEL SYSTEM Air filter Fuel lines and hoses*1 COOLING SYSTEM Cooling system Engine coolant CHASSIS and BODY ...) or 60 months L L L L L L L L Replace every 40,000 km (25,000 miles) or 24 months
I Replace at the recommended time or mileage/kilometer period to perform maintenance on...
Owner's Manual - Page 261
... 24 32 40 48 56 64 72 80 88 ×1000 5 10 15 20 25 30 35 40 45 50 55 miles Puerto Rico Others Replace every 5,000 km (3,000 miles) or 3 months R R R R R R R R R R R R R R R R R ...R I I I
Hoses and tubes for emission (Puerto Rico) IGNITION SYSTEM Spark plugs (Platinum tipped type) FUEL SYSTEM Air filter Fuel lines and hoses*1 COOLING SYSTEM Cooling system Engine coolant Engine coolant level ...
Owner's Manual - Page 273
... at idle without first depressing the brake pedal is applied before shifting the shift lever. 4. Make sure the brake pedal is dangerous. Overfilling can cause foaming, loss of fluid changes with the temperature. Fluid cold scale B When the engine has not been running and the outside temperature is at normal operating...
Owner's Manual - Page 277
...car washers have been known to affect the wiper's ability to expose the plastic locking clip. Metal support
CAUTION
To prevent damage to the wiper blades, don't use gasoline, kerosene, paint thinner, or... washes. To prevent damage to the wiper arms and other solvents on it off the arm. Replace them .
1. Raise the wiper arm and turn the blade assembly to clean windows. Compress the...
Owner's Manual - Page 285
...Wheel and bearing life Ground clearance Snow-chain clearance Speedometer calibration Headlight aim Bumper height
l
l
qReplacing a Wheel
When replacing a wheel, make sure the new one is dangerous. Proper tire balancing ...000 km (3,000 miles), depending on your temporary spare tire rim with the same type of -balance tires can cause vibration and uneven wear, such as the original factory...
Owner's Manual - Page 326
... June 28 2004 4:1 PM
Black plate (326,1)
Specifications Specifications
qEngine
Item Type Bore × Stroke Displacement Compression ratio Classification DOHC-24V 60°V, 6-... or FMVSS116 DOT-3
qCapacities
(Approximate Quantities) Item With oil filter replacement Engine oil Without oil filter replacement With rear heater Coolant Without rear heater Automatic transaxle fluid With 4-Seasons...
Owner's Manual - Page 328
...W5W ― ― W5W ―
qTires
NOTE
The tires have been optimally matched with the chassis of the same type originally fitted to Tire Inflation Pressure on page 8-27.
10-6
í
Some models. Check the tire pressure label for ...; #168 ― ― #7443 #168 #168 #921 ―
*1 Bulb replacement is not possible because it is built into the unit.
Refer to your vehicle.
Similar Questions
Neutral Safety Switch Gone I Replaced It Still Has Same Problem
my neutral safety switch went bad I replaced it and it's still doing the same thing is there somethi...
my neutral safety switch went bad I replaced it and it's still doing the same thing is there somethi...
(Posted by Kb34blackwell 8 years ago)
How Do You Replace Ignition Coil On 2001 Mazda Mpv V6?
(Posted by Anonymous-74629 11 years ago)
How To Replace Remote Fuel Door Release Cable? Also, Does It Open Lid Door?
Do I need another part to open the fuel lid door or is it on the cable? There is a little ball on on...
Do I need another part to open the fuel lid door or is it on the cable? There is a little ball on on...
(Posted by cargirl 12 years ago)