2004 Mazda MPV Support Question
2004 Mazda MPV Support Question
Find answers below for this question about 2004 Mazda MPV.Need a 2004 Mazda MPV manual? We have 1 online manual for this item!
Question posted by kozo9 on August 16th, 2011
Code:p0093
Please inform me about this code.
Because my car runs with no other problem except this.
(LIGHT ON).
I think that the problem is the fuel pressure sensor(RF TURBO).
THANKS
Current Answers
Related Manual Pages
Owner's Manual - Page 48
... for you and for another person or a different vehicle or seat is left connected, the seat belt warning light will not provide adequate protection and you could be only for you and for more information. Only use the extender when it in a different vehicle or seat. When not in use the extender...
Owner's Manual - Page 85
...in someone being badly injured or even killed. Don't leave the keys in the vehicle) for information regarding keys and engine starting on the plate attached to make the vehicle move. The keys ...operate all locks.
They could result in the vehicle. Key code number plate
3-2 If your key is lost, consult your vehicle with the key is dangerous. This...
Owner's Manual - Page 86
... Locks Keyless Entry System*
This system locks and unlocks the doors and the liftgate. Bring all transmitters to an Authorized Mazda Dealer when the electronic codes need to heat or sunlight.
*Some models.
3-3 Up to about 2.5 m (8 ft) from the center of local conditions. • The system doesn't operate when the ignition...
Owner's Manual - Page 90
... system fails to malfunction. CAUTION
Do not press any buttons when replacing the battery. CK LO
Slot
CK LO UN
3-7 Remove the battery. The electronic code could be altered and cause the keyless entry system to operate, contact an Authorized Mazda Dealer. 4.
Insert a small screwdriver into the slot and gently pry...
Owner's Manual - Page 107
...hood.
3-24 Always check that is not closed and securely locked is dangerous as possible. If the light remains on when the cap isn't tightened securely. Contact an Authorized Mazda Dealer as soon as it may... result in a serious accident. M Opening the Hood
1.
The check engine light may indicate a different problem.
Knowing Your Mazda
Doors and Locks Hood
CAUTION
Make sure the...
Owner's Manual - Page 113
If it .
Go to an Authorized Mazda Dealer and have a problem with your immobilizer system. They are only available through an Authorized Mazda Dealer. • Always ...not start , check the warning light. If it is turned to restart it .
3-30 If you shut off the engine. If you won't be able to the ON position, the engine will reset the electronic codes of your engine fails to it...
Owner's Manual - Page 115
...theftdeterrent system, consult an Authorized Mazda Dealer.
3-32
Knowing Your Mazda
Security System
3. The indicator light flashes once every 3 seconds to the ON position. NOTE
If you affix them to flash ...the front door windows. Mazda recommends that the system is turned off by any problem with a Theft-Deterrent System are in the glove box. M To Stop an Alarm
A ...
Owner's Manual - Page 141
... is turned to the ON position, the sound of the fuel pump motor operating near the fuel tank can be heard.
Remove the key only when the vehicle...light can be checked after the engine is started (page 5-24). LOCK The steering wheel locks to side. NOTE
WARNING
Removing the Key: It's dangerous to remove the key from side to protect against theft. ON This is the normal running...
Owner's Manual - Page 145
... You may go closer to the floor. Even if the light goes off the right-of the road and park off , have a brake problem. Drive to push or that some components are operating incorrectly,...add fluid as possible. Low brake fluid level warning/ Electronic brake force distribution system warning If the light stays on at the same time (page 5-29).
5-6 It goes off when the parking brake is...
Owner's Manual - Page 152
... climb a steep grade from overheating.
The transaxle will shift to a lower gear, depending on when the overdrive has been turned off indicator light flashes, the transaxle has an electrical problem. Shift to prevent them from a stopped position: 1. Descend slowly, using the brakes only occasionally to D or 2, depending on load weight and grade...
Owner's Manual - Page 153
M Cruise Main Indicator Light
This light comes on when the ON/OFF switch is pressed and the cruise control system is inoperable, you can set and...km/h (25 mph). Driving Your Mazda
Starting and Driving Power Steering
Power steering is only operable when the engine is running .
Cruise Control*
With cruise control, you to the extreme left or right for more than 5 seconds with the engine...
Owner's Manual - Page 165
..., the control unit may turn the brake system warning light on when the parking brake is fully released. Even if the light goes off, have a brake problem. Drive to stop the vehicle. 1. After adding fluid, check the light again. In this case, the ABS warning light comes on , or if the brakes do not operate...
Owner's Manual - Page 167
.... • The engine's electrical system has a problem. • The emission control system has a problem. • The fuel-filler cap is missing or not tightened securely. Driving Your Mazda
Warning/Indicator Lights and Beep Sounds
M Engine Oil Pressure Warning Light M Check Engine Light
This warning light indicates low engine oil pressure. If the check engine light remains on and consult an...
Owner's Manual - Page 169
...System Warning/ Security Indicator Light*
M Low Fuel Warning Light
Low fuel warning light
Immobilizer system warning light When the key is completed. This warning light in the ignition switch, this light serves as the immobilizer system warning light. This could accidentally activate or become disabled. This warning light comes on until the belt is dangerous. The light will go out when...
Owner's Manual - Page 170
... in the ignition switch, and the theft-deterrent system has been armed, the light will come from the engine. If the light stays on when the overdrive has been turned off indicator light flashes, the transaxle has an electrical problem. This light comes on , the TCS may not operate correctly.
Consult an Authorized Mazda Dealer...
Owner's Manual - Page 174
... to flash after the turn on the dashboard show which signal is completed. NOTE
If an indicator light stays on during daytime operation.
Right turn
The running lights automatically turn is working. Lane-change signals Move the lever slightly toward the direction of the change Left turn , manually return the lever to the...
Owner's Manual - Page 194
...FM wave AM wave
FM characteristics An FM broadcast range is possible to beams of light because they can reach longer distances than monaural (non-stereo) FM. Because of ... cannot be picked up on the same frequency at the same time. This problem may sometimes be received at the same time.
Because of extra coding needed to the transmitter.
40-50 km (25-30 miles)
Reflected wave Direct...
Owner's Manual - Page 265
... engine while working under the hood with the engine running . You could come on unexpectedly even when the engine isn't running is dangerous. Maintenance and Care
Owner Maintenance Owner Maintenance Precautions
Improper or incomplete service may result in problems. This section gives instructions only for items that are strict environmental laws regarding the...
Owner's Manual - Page 268
...are for leaks. 7. Please act responsibly-protect the environment and take used engine oil is running , the engine oil becomes very hot. Changing engine oil
6. Tighten Loosen
WARNING
Handling ...check or change the engine oil when the engine is dangerous. Warm up the engine for information. 2. When adding or changing oil, verify the engine oil level with new oil to Scheduled...
Owner's Manual - Page 304
...with Wet Brakes: Driving with lukewarm or cold water at the end of such underbody parts as fuel lines, frame, floor pan, and exhaust system, even though these areas because they will do this...sure to one side when braking could result in an automatic car wash that should not be coated with lukewarm or cold water. Light braking will cause rusting. It will speed up rusting and ...
Similar Questions
My 93' Mpv Won't Even Turn Over No Lights No Anything?
I ran down my battery and I tried to get a jumpstart and then nothing no lights nothing. What's the ...
I ran down my battery and I tried to get a jumpstart and then nothing no lights nothing. What's the ...
(Posted by ntty1ne 2 years ago)
What Is The Problem When The Shift Position Indicator Light Doesn't Turn In
Mazda mpv 2005
Mazda mpv 2005
(Posted by blavdawod 9 years ago)
Why Does The 2004 Mazda Mpv Run Better With The O/d Off
(Posted by muscobfran 10 years ago)
Why The Immobilizer System Warning/security Indicatior Light On My Mazda Mpv
stays on
stays on
(Posted by budsuare 10 years ago)
My Abs Light Is On, Brakes Light Is On, Tcs Light Is On, My Door Light Is On And
My ABS light is on, brakes light is on, TCS light is on, my door light is on and none of the lights ...
My ABS light is on, brakes light is on, TCS light is on, my door light is on and none of the lights ...
(Posted by praternv0804 11 years ago)