2004 Mazda MAZDA6 Support Question
2004 Mazda MAZDA6 Support Question
Find answers below for this question about 2004 Mazda MAZDA6.Need a 2004 Mazda MAZDA6 manual? We have 1 online manual for this item!
Question posted by lsspll on August 15th, 2012
Both Remotes Do Not Work On My 2004 Mazda 6s....plz Hlp!!
The person who posted this question about this Mazda automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 27
The seat belt pretensioner system will not work again and both must be replaced immediately.
The seat belt pretensioners will increase. Always have an Authorized Mazda Dealer inspect the seat belt pretensioners and air bags after any collision. After they are expended, they will only activate when a front seat belt is ...
Owner's Manual - Page 29
...Bag/ Pretensioner Systems: Self-servicing or tampering with the systems and always have an Authorized Mazda Dealer performs all when the ignition switch is turned to the ON position or after the engine is... cranked. The system may not work in an accident. Slowly pull out the lap/shoulder belt. 3. This could accidentally activate or...
Owner's Manual - Page 36
...restraint system from the rear seat before you or your child touches them before operating the remote handle levers for attachment of specially designed LATCH child-restraint systems in a closed vehicle ...air bags, the impact of inflation could cause serious injury or death to the person. NOTE
Your Mazda is in a child-restraint system. To avoid burning yourself or a child, check them . ...
Owner's Manual - Page 37
...'s seat is clearly the worst choice for belt routing instructions. 2. In your Mazda, tethered child-restraint systems can only be installed on the seats that a child...restraint system with tethers and therefore must be accommodated in the rear seat. WARNING
Tethered Child-Restraint Systems Work Only on the rear seat. Depending on the childrestraint system for any child under 12, and with...
Owner's Manual - Page 52
...offset impact. Gases are produced to the inflators. Only an Authorized Mazda Dealer can replace the systems.
The front air bags will not work again and must be replaced.
The air bags will deploy only..., June 24, 2003 6:29 PM
Essential Safety Equipment
SRS Air Bags
M How the Air Bags Work
When air bag crash sensors detect a frontal or side impact of greater than moderate force, an ...
Owner's Manual - Page 57
...Bag/ Pretensioner Systems: Self-servicing or tampering with the systems and always have an Authorized Mazda Dealer performs all when the ignition switch is turned to the ON position. A system malfunction...turned to the ON position and continues while the vehicle is cranked. The system may not work in an accident.
This could accidentally activate or become disabled. After about 6 seconds it...
Owner's Manual - Page 63
... 3-11). J56J_8S11-EA-03G_Edition1.book Page 5 Tuesday, June 24, 2003 6:29 PM
Knowing Your Mazda
Doors and Locks
Trunk button To open or closed.
NOTE
• Make sure the battery is installed.../or water. • Never deform or crush. Turning on the alarm Pressing the button once will work whether any button on the transmitter.
3-5
Form No. 8S11-EA-03G
Turning off the alarm Press ...
Owner's Manual - Page 69
...slam it is secure.
OFF position
ON position
With the switch in the OFF position, the remote trunk lid release cannot be opened by operating the keyless entry system transmitter, refer to push the....book Page 11 Tuesday, June 24, 2003 6:29 PM
Knowing Your Mazda
Doors and Locks
Opening the trunk lid with the remote release button Push the release button. Opening the trunk lid with the ...
Owner's Manual - Page 74
... neck. Fuel Vapor: Fuel vapor is dangerous. Additionally, use only a genuine Mazda fuel cap or an approved equivalent, available at Authorized Mazda Dealers. Remote fuel-filler lid release
M Fuel-Filler Cap
To remove the filler cap, turn...03G_Edition1.book Page 16 Tuesday, June 24, 2003 6:29 PM
Knowing Your Mazda
Doors and Locks Fuel-Filler Lid and Cap
M Fuel-Filler Lid
To open, pull up the...
Owner's Manual - Page 91
....book Page 5 Tuesday, June 24, 2003 6:29 PM
Before Driving Your Mazda
Before Starting the Engine Before Getting In
• Be sure the windows, outside mirrors, and outside mirrors adjusted? • Is everyone's seat belt fastened? • Do all the lights work? • Check all gauges. • Check all warning lights when...
Owner's Manual - Page 103
...34). Don't drive with both lights are operating incorrectly, the control unit may not work at all or that the parking brake is dangerous.
Electronic brake force distribution system ...under normal circumstances. When both lights on , and contact an Authorized Mazda Dealer to an Authorized Mazda Dealer. Even if the light goes off, have the brakes inspected immediately. ...
Owner's Manual - Page 128
... brake system warning light on is dangerous. If this light on, and contact an Authorized Mazda Dealer to have the brakes inspected as soon as possible. This warning light comes on when... Mazda
Warning/Indicator Lights and Beep Sounds
M Charging System Warning Light
WARNING
Brake Warning Light: Driving with both lights are on at any time. It indicates that your brakes may not work at...
Owner's Manual - Page 130
... . Don't drive with both lights are on , and contact an Authorized Mazda Dealer to the ON position. If any of these occur, consult an Authorized Mazda Dealer as soon as if the vehicle had no ABS. The system may not work in an emergency stop than under normal circumstances. The warning light stays...
Owner's Manual - Page 137
NOTE
If an indicator light stays on when the ignition switch is working. It will self-cancel after a turn on without flashing or if it there.... turn ) to the ON position. J56J_8S11-EA-03G_Edition1.book Page 41 Tuesday, June 24, 2003 6:29 PM
Driving Your Mazda
Switches and Controls
M Daytime Running Lights (Canada)
In Canada, vehicles must be burned out.
5-41
Form No. 8S11-...
Owner's Manual - Page 139
M Windshield Washer
Pull the lever toward you and hold it 's OK, consult an Authorized Mazda Dealer.
5-43
Form No. 8S11-EA-03G INT - Intermittent 1 - Normal 2 ...until the lever is released. J56J_8S11-EA-03G_Edition1.book Page 43 Tuesday, June 24, 2003 6:29 PM
Driving Your Mazda
Switches and Controls
M Windshield Wipers
One-touch wipers For a single wiping cycle, push the lever up to spray ...
Owner's Manual - Page 141
... flash at once. Hazard warning flasher
Depress the hazard warning flasher and all four turn signals don't work when the hazard warning lights are on or near it .
5-45
Form No. 8S11-EA-03G ...a roadway. J56J_8S11-EA-03G_Edition1.book Page 45 Tuesday, June 24, 2003 6:29 PM
Driving Your Mazda
Switches and Controls Horn
To sound the horn, press around the mark of hazard warning lights while ...
Owner's Manual - Page 143
... begins to replace this Programming Step 3 with FCC rules part 15. Operation is a remote control transmitter available for the device you would like to program. • Disconnect the ... J56J_8S11-EA-03G_Edition1.book Page 47 Tuesday, June 24, 2003 6:29 PM
Driving Your Mazda
Switches and Controls
M Programming the HomeLink System
NOTE
FCC ID: NZLSTDHL3 CANADA:4112104541A This device...
Owner's Manual - Page 222
... using this expertise and the parts that have a reliable and qualified service shop perform the work, preferably an Authorized Mazda Dealer. For expert advice and quality service, consult an Authorized Mazda Dealer. The owner should retain evidence that it describes, we recommend that proper maintenance has been performed as opposed to have been...
Owner's Manual - Page 228
... getting near the engine or cooling fan which may affect warranty coverage. You could come on unexpectedly. WARNING
Maintenance Procedures: Performing maintenance work , have it done by an Authorized Mazda Dealer. Either can become entangled in moving parts and result in the ON position is dangerous. Please dispose of waste oil and...
Owner's Manual - Page 232
... and inspect around the drain plug for general reference purposes only. Check the oil level and fill to retighten the filter, an Authorized Mazda Dealer should do the work.
8-12
Form No. 8S11-EA-03G Remove the drain plug and drain the oil into a suitable container. 3. Changing oil filter
Drain plug
Because...
Similar Questions
Charging Point Not Working
my mazda 2004 charging point is not working i have recently buyyed this second hand car,would like t...
my mazda 2004 charging point is not working i have recently buyyed this second hand car,would like t...
(Posted by ask4alnawaz 7 years ago)
What Type Of Antenna Does A 2004 Mazda 6s Have? Type 1 Or 2
(Posted by chrisni 10 years ago)
Is There Cell Phone Charger Option In Mazda 6s 2004
(Posted by bodkckar 10 years ago)