Home » Mazda » Technical Support » 2003 Mazda Tribute

2003 Mazda Tribute Support Question

Find answers below for this question about 2003 Mazda Tribute.
Need a 2003 Mazda Tribute manual? We have 1 online manual for this item!

Mazda Overview Questions Manuals Reviews Videos Research

Question posted by Conwayd936 on April 22nd, 2021

2003 Mazda Tribute Started Ran Roughly Had To Put Your Foot To The Floor And Wou

2003 mazda tribute ran roughly then would stall replaced the rocket cover gasket and spark plugs fuel filter just about runs with aerostart then stops again

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on April 26th, 2021 5:42 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,680

1,100
points

See https://tinyurl.com/yhfkeyva, Good luck!

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Manual Pages

Owner's Manual - Page 2

...Fuel information Air filter(s) Refill capacities Engine data 187 192 200 203 207 214 228 234 236 Accessories Index 239 240 All rights reserved. Mazda may change the contents without notice and without written authorization from Mazda... obligation. Copyright © 2002 Mazda Motor Corporation 2 Table of Contents Driving Starting Brakes Transmission operation Vehicle loading Trailer...

Owner's Manual - Page 12

...decrease in braking performance may take you longer to stop the vehicle. Anti-lock brake system (ABS)... ON position when the engine is not running, or in the Maintenance and specifications chapter...Mazda dealer. Brake system warning light: To confirm the brake system warning ! Instrument Cluster It may occur. For more information, refer to Fuel filler cap in a position between ON and START...

Owner's Manual - Page 40

...M is pressed), and the clock control is above 60°C (140°F). Press the CLOCK control to start the clock. If your changer does not work, it may be that: • A disc is already loaded...minutes. 4. Allow the player to alternate between the clock and the audio. Press AUTO-M on a rough road, playing badly scratched discs or the disc may be dirty. If the clock's current time setting ...

Owner's Manual - Page 41

...cold, the CD or optical components (prism and lens) in the unit. Remove the rough edges in Mazda CD players. Ball point pens may peel and cause the CD to play commercially pressed...8226; A new CD may jump. • The CD player has been designed to become clouded with rough edges is inserted. Entertainment Systems • A disc with homemade paper (adhesive) labels should never be...

Owner's Manual - Page 73

...from the beginning. The doors will need to start the procedure over again. 73 Snap the two halves back together. Note: Replacement of the battery will not cause the remote ...will lock, then unlock, to 3 (ON). Note: The eighth turn must have your authorized Mazda dealer for the correct orientation of four) available before beginning this procedure. To reprogram the remote ...

Owner's Manual - Page 74

...SECURILOCK PASSIVE ANTI-THEFT SYSTEM SecuriLock passive anti-theft system is not compatible with non-Mazda aftermarket remote start systems. Use of illumination. This system is designed to prevent the engine from your...will not turn off the interior lights if: • the ignition switch is turned to the RUN position, or • the remote transmitter lock control is used to the 1 (LOCK) ...

Owner's Manual - Page 75

..., turn off , remove all objects on the same key chain may cause vehicle starting issues. Theft indicator The theft indicator is located in the instrument cluster. •...coded key on the key chain away from touching the coded key while starting the engine. If this occurs, the vehicle should be taken to an authorized Mazda dealer for 3 seconds, then turn the ignition off , to indicate...

Owner's Manual - Page 76

.... Please read and understand the entire procedure before you will need to be programmed. Replacement keys If your own coded keys to a dealership. Please visit an authorized Mazda dealer to help prevent any inconveniences. Store an extra programmed key away from your authorized...spare keys You can be erased from the vehicle in the ignition it will cause a "no start" condition.

Owner's Manual - Page 77

... your vehicle to your vehicle's engine and the theft indicator light will not start the vehicle's engine and the theft indicator light will illuminate for each additional ... ignition. 2. Locks and Security 1. If the key was not successfully programmed, it will start your authorized Mazda dealer to the 3 (ON) position. To program additional new unprogrammed key(s), repeat this procedure...

Owner's Manual - Page 121

.... • Make sure the gearshift is in order to the Seating and safety restraints chapter. 2. If starting the vehicle: 1. Make sure the headlamps and vehicle accessories are off. When the engine starts, the idle RPM runs higher than normal in P (Park). For more information on safety belts and their safety belts. Do not...

Owner's Manual - Page 122

..., release the key as soon as the engine starts. BRAKE CHECK FUEL CAP O/D OFF Make sure the corresponding lights illuminate or illuminate briefly. Driving If starting a vehicle with a manual transmission: • Make sure the parking brake is fastened, the illuminate. If a light fails to the floor. 3. Turn the key to 3 (ON) without turning the...

Owner's Manual - Page 123

...10 seconds and try again. After idling for longer than three hours will return to floor and hold. Take precautions to START position. 4. If the temperature is strongly recommended if you live in a region where... dangerous effects. 123 The key will not harm the engine, so the heater can be plugged in exhaust fumes. Using the heater for a few seconds, apply the brake, shift into...

Owner's Manual - Page 125

...from the hydraulic pump motor and pulsation in front of you start the engine and begin to apply the brakes or always reduce stopping distance. If a "metal-to a non-ABS equipped ...by detecting the onset of wheel lockup during this tendency. The ABS operates by an authorized Mazda dealership. Pedal pulsation coupled with noise while braking under panic conditions or on bottom) to...

Owner's Manual - Page 126

...warning lamp illuminates, have your vehicle serviced immediately by an authorized Mazda dealership.) Using four wheel ABS (if equipped) • In...will enable you to avoid obstacles and bring the vehicle to stop . Parking brake Apply the parking brake whenever the vehicle is... be serviced. If the light does not illuminate momentarily at start up as far as possible. 126 Driving ABS warning lamp ...

Owner's Manual - Page 143

Mazda Motor Corporation joins the U.S. This reduces strain on hilly or sloping terrain Although natural obstacles may damage the transmission. It is an educational program designed to increase public awareness of an observer. Apply just enough power to the wheels to a lower gear from a higher gear once the ascent has started... or hill, start in loss of stalling. Avoid driving ...

Owner's Manual - Page 197

...enclosed space, unless you are sure you service your vehicle. If the engine has been running in your vehicle: • We highlight do-it-yourself items in 1 (First). 2....wheels. 197 Use only recommended fuels, lubricants, fluids and service parts conforming to P (Park). 2. Turn off the engine and remove the key. 3. Genuine Mazda parts are covered. PRECAUTIONS WHEN SERVICING YOUR VEHICLE...

Owner's Manual - Page 217

... aftermarket products to your fuel supplier about gasolines that meet the World-wide Fuel Charter. However, if it may not be covered by your authorized Mazda dealer. Gasolines that meet the World-wide Fuel Charter should not be necessary to add any engine damage. 87 Fuel quality NOTE: If you are experiencing starting, rough idle or hesitation driveability...

Owner's Manual - Page 219

... NOT accurate as a measure of fuel remaining in possible personal injury. Replace the fuel filter with an authorized Mazda part. The advertised capacity is the small amount of fuel economy. WARNING: If you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Maintenance and Specifications WARNING: The fuel system may be void for changing...

Owner's Manual - Page 236

Maintenance and Specifications For further information on plug 10.0:1 VEHICLE DIMENSIONS Dimensions (1) Vehicle height/ Maximum height* (2) Front track / rear (3)...Tire 215/70R16 17x4T 135/90R17 235/70R16 17x4T 145/90R17 ENGINE SPECIFICATIONS Engine Cubic inches Required fuel Firing order Spark plug gap Ignition system Compression ratio 2.0L DOHC I4 Zetec engine 121 87 octane 1-3-4-2 1.22-1....

Owner's Manual - Page 244

...197 Spare tire (see Changing the Tire) ...163-164 Spark plugs, specifications ...236 Special notice ambulance conversions ...5 Specification chart, lubricants ...236 Speed control ...62 Starting your vehicle ...120-122 jump starting ...169 Steering wheel tilting ...58 T Tires ...229-231 changing ...163-165 checking the pressure ...231 replacing ...232 rotating ...231 snow tires and chains ...233...