2003 Mazda Protege Support Question
2003 Mazda Protege Support Question
Find answers below for this question about 2003 Mazda Protege.Need a 2003 Mazda Protege manual? We have 1 online manual for this item!
Question posted by cjarvis1 on March 27th, 2014
Mazda Protege Lx 2003 Shuttering Problem, And Beeping Noise
Hi, My mazda for the last month has been beeping twice with all dash board lights turning on and off when keys are taken out of the ignition, but only happens periodically. Also when driving over 80 + km/h my mazda will jump (or what feels like it) when driving in snow, also rpm drops slightly when car jumps.
Current Answers
Related Manual Pages
Owner's Manual - Page 32
...'s seat belt is not fastened when the ignition switch is turned to the ON position, the seat belt warning light will remain on until the belt is turned to the ON position, a beep will sound for about 6 seconds. If the system does not operate correctly, consult an Authorized Mazda Dealer.
2-21
Form No. 8Q94-EA-02G...
Owner's Manual - Page 50
... injury, however, the texture of the air bags may cause light skin injuries on or near system components or wiring. An Authorized Mazda Dealer can be heard and some smoke will be seriously injured.... NOTE
• When an air bag deploys, a loud inflation noise can provide the special care...
Owner's Manual - Page 63
...Mazda
Doors and Locks
M Service
If you or leave a responsible person with children. They could play with the keyless entry system, consult an Authorized Mazda...remove the key from the ignition switch, close all windows, and lock all doors locked when driving. Passengers can... a problem with power windows or other controls, or even make the lost or stolen transmitter inoperative. Keys and ...
Owner's Manual - Page 74
... the engine several times), it clicks. If the light remains on when the cap isn't tightened securely. Contact an Authorized Mazda Dealer as soon as possible. Remote fuel-filler lid...Mazda
Doors and Locks
M Fuel-Filler Lid
To open, pull up the remote fuel-filler lid release. Sedan
M Fuel-Filler Cap
To remove the filler cap, turn it clockwise until it may indicate a different problem...
Owner's Manual - Page 79
The roof rack can result in noise.
Rear cross bar
• Tighten the bolts with tightening torque of the rear cross bar until they click, then...of 11-12 N•m {110-120 kgf•cm}. 4. J39L_EA.book Page 22 Saturday, June 8, 2002 5:35 PM
Knowing Your Mazda
Doors and Locks
3. Tighten the bolt at both ends of the rear cross bar alternately and evenly. Screw Rear cross bar cover
Rear ...
Owner's Manual - Page 85
... is performing poorly. • Never add fuel system additives. Vehicle damage and drivability problems resulting from the use ONLY UNLEADED FUEL, which will result in the table. J39L_EA.book Page 2 Saturday, June 8, 2002 5:35 PM
Before Driving Your Mazda
Fuel and Engine Exhaust Precautions Fuel Requirements
Vehicles with catalytic converters or oxygen sensors...
Owner's Manual - Page 92
...Mazda Dealer. it may result in damage to the vehicle and to be damaged. Always follow the chain manufacturer's instructions. 3. CAUTION
• Chains may affect handling. • Don't go faster than 50 km/h (30 mph) or the chain manufacturer's recommended limit, whichever is lower. • Drive carefully and avoid bumps, holes, and sharp turns... NOTE
(MAZDASPEED Protegé) Use ...
Owner's Manual - Page 98
... The warning lights (except brakes) should fasten their seat belts. 2. The brake warning light can be ...beep will sound when any door is controlled by the spark ignition system. NOTE
M Ignition Key Reminder
If the ignition switch is in park (P). J39L_EA.book Page 3 Saturday, June 8, 2002 5:35 PM
Driving Your Mazda
Starting and Driving Starting the Engine
NOTE
NOTE
If turning the key...
Owner's Manual - Page 123
... 5:35 PM
Driving Your Mazda
Warning/Indicator Lights and Beeps
Signal Warning/Indicator Lights Seat Belt Warning Light Page 5-33
Door-Ajar Warning Light
5-33
Low Washer Fluid Level Warning Light
5-33
Automatic Transaxle Warning Light
5-33
Headlight High-Beam Indicator Light
5-34
O/D OFF Indicator Light
5-34
Shift Position Indicator Light
5-34
Cruise Set Indicator Light
5-35
5-28...
Owner's Manual - Page 124
...5:35 PM
Driving Your Mazda
Warning/Indicator Lights and Beeps
M Brake System Warning Light
If the warning light remains on ...ignition switch in the START or ON position. Have it will take longer to an Authorized Mazda Dealer. Electronic brake force distribution system warning If the electronic brake force distribution control unit determines that it may turn the brake system warning light...
Owner's Manual - Page 126
.... 8Q94-EA-02G J39L_EA.book Page 31 Saturday, June 8, 2002 5:35 PM
Driving Your Mazda
Warning/Indicator Lights and Beeps
M Engine Oil Pressure Warning Light M Check Engine Light
This warning light indicates low engine oil pressure. Check the light. If this light comes on while driving: 1. It is low. The check engine light may have your speed and consult an Authorized...
Owner's Manual - Page 127
... the same time is jump-started to charge the battery, uneven rpm occurs and the ABS warning light comes on , and contact an Authorized Mazda Dealer to the ON position.
Should this occurs, your brakes will function normally as possible. Don't drive with both lights are on at all. This is turned to have the brakes...
Owner's Manual - Page 128
... possible. If the system does not operate correctly, consult an Authorized Mazda Dealer. This warning light stays on for a few seconds when the ignition switch is fastened. J39L_EA.book Page 33 Saturday, June 8, 2002 5:35 PM
Driving Your Mazda
Warning/Indicator Lights and Beeps
M Door-Ajar Warning Light
WARNING
Self-Servicing the Air Bag/ Pretensioner Systems: Self-servicing...
Owner's Manual - Page 129
... the overdrive has been turned off indicator light flashes, the transaxle has an electrical problem.
M O/D OFF Indicator Light
This light comes on . • The turn signal lever is in the gear position indicator.
5-34
Form No. 8Q94-EA-02G Consult an Authorized Mazda Dealer as soon as possible. Continuing to drive your transaxle.
This light indicates one of the...
Owner's Manual - Page 131
... 8, 2002 5:35 PM
Driving Your Mazda
Switches and Controls Lighting Control
M Lights-On Reminder
If lights are on and the key is removed from the ignition switch, a beep will return to the normal position when released.
The headlight switch need not be on the end of the control lever. High beams
M Headlights
To turn on the lights, turn the knob on...
Owner's Manual - Page 183
... Protege
Lug wrench
Except MAZDASPEED Protege Bolt Tire clamp
Bolt Tire clamp
7-6
Form No. 8Q94-EA-02G Turn the tire hold-down bolt counterclockwise with a spare tire on the front (driving) wheels on your temporary spare on the rear axle and move a regular tire to the vehicle, observe the following precautions: • Don't exceed 80 km...
Owner's Manual - Page 190
...Drive safely to the ON position without starting the engine. Apply the parking brake. 3. Then turn the ignition...or you find no problems, the engine is...Authorized Mazda Dealer. Turn ...noise, the engine is no leaks are obvious, carefully add coolant as required (page 8-12).
7-13
Form No. 8Q94-EA-02G Stop the engine. The radiator cooling fans will start to cool the engine. If this happens...
Owner's Manual - Page 235
...as possible. 3. Open the fuse panel cover.
4. Normal
Blown
Fuse panel cover
5. If any lights, accessories, or controls don't work , first inspect fuses on the fuse panel.
Inspect it ... system and consult an Authorized Mazda Dealer as soon as the RADIO circuit. Turn off the ignition switch and other switches. 2. Otherwise you have an Authorized Mazda Dealer install it. Pull the...
Owner's Manual - Page 236
Turn off the ignition switch and all other electrical components don't work and the fuses in the cabin are OK, inspect the fuse block under the hood.
Normal
Blown
NOTE
To replace the MAIN fuse, contact an Authorized Mazda Dealer (page 8-40).
8-39
Form No. 8Q94-EA-02G If a fuse is blown, replace it...
Owner's Manual - Page 274
...24 SRS Air Bags Air bag system description ...2-40 Supplemental restraint systems precautions ...2-36 Warning light ...2-45 Starting the Engine ...5-3 Steering Wheel ...3-23 Horn ...5-41 Storage Compartments ...6-39 ...Rear-center lap/shoulder ...2-18 Seat belt precautions ...2-11 Warning beep ...2-21 Warning light ...2-21 Seats Front seats ...2-2 Rear seat ...2-5 Service Publications ...9-14 Spare Tire and...
Similar Questions
Could My Pcv Valve Be The Cause Of My Idle Issue On My 1995 Mazda Protege?
I have been having idle problems with my 1995 Mazda Protege LX. When I start her cold the idle is re...
I have been having idle problems with my 1995 Mazda Protege LX. When I start her cold the idle is re...
(Posted by kathy74 9 years ago)
What Kind Of Brake Fluid Does A 2003 Mazda Protege Lx Take?
(Posted by walkegpe 10 years ago)
How To Remove Driver Seat Belt On 02 Mazda Protege Lx
(Posted by rawmaxw 10 years ago)
Where Do You Find The Horn On The Mazda Protege 2003
The horn on our 2003 mazda protege is not working but we can't even find it. Where is it located.
The horn on our 2003 mazda protege is not working but we can't even find it. Where is it located.
(Posted by fmchavez 10 years ago)
Rear Suspension Thumps...
Hello Is it normal for my 2003 protege lx for the rear shocks/suspension to rattle when I hit even...
Hello Is it normal for my 2003 protege lx for the rear shocks/suspension to rattle when I hit even...
(Posted by Globe777Trekker 11 years ago)