2002 Mazda Tribute Support Question
2002 Mazda Tribute Support Question
Find answers below for this question about 2002 Mazda Tribute.Need a 2002 Mazda Tribute manual? We have 1 online manual for this item!
Question posted by supeju on October 1st, 2013
How To Remove Alternatre From 2002mazda Tribute
The person who posted this question about this Mazda automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 15
... Sounds when a malfunction in the Maintenance and specifications chapter. Headlamps ON warning chime Sounds when the headlamps or parking lamps are on, the key is removed from the ignition and the driver's door is properly re-installed, the light(s) will vary depending on , check the fuel filler cap.
Owner's Manual - Page 16
... gauge indication will not be accurate.
16
At normal operating temperature, the needle remains within the normal area (the area between the "H" and "C"). WARNING: Never remove the coolant reservoir cap while the engine is running or hot, this may result in the Maintenance and care chapter. NOTE: This gauge indicates the...
Owner's Manual - Page 29
... eject a CD. Disc search Disc search works in the display. 2. Press the DISC down control to skip back to the beginning of the next CD. Remove the CD. 29 To disengage repeat play . Press the control to the beginning of the previous CD. The disc number and OUT will be repeated...
Owner's Manual - Page 44
.... Ejecting CDs from a desired tray 1. Ejecting a tape Press the control to stop and eject a tape. Remove the CD. NOTE: When a CD is ejected during play, the next CD will then be ejected continuously.
44 Remove the CD. Remove the CD. Ejecting a CD 1. Press the memory preset control of the beep. 3. Entertainment Systems
Eject...
Owner's Manual - Page 47
To remove the rough edges, rub the side of the pen or pencil against the inner and outer perimeter of the CD. • When driving over rough ... CD will clear naturally in advance by wiping it with a soft cloth from the signal surface, thereby effecting sound quality. Do not use the unit. Remove the rough edges in about an hour.
Owner's Manual - Page 50
... modes , , and . Climate Controls
MANUAL HEATING AND AIR CONDITIONING SYSTEM
OFF
A/C
MAX A/C
Fan speed control Controls the volume of the vehicle. Since the air conditioner removes considerable moisture from the air during operation, it is normal if clear water drips on the ground under the air conditioner drain while the system...
Owner's Manual - Page 52
... the vehicle is parked. Climate Controls
• (Defrost)-Distributes outside air through your windshield. This allows the vehicle to the rear seats (if equipped). • Remove any position other than the MAX A/C or OFF when the vehicle is parked.
Owner's Manual - Page 58
...authorized Mazda dealer. Lights
• License plate lamp • Tail lamps • Back-up lamps Do not remove lamp bulbs unless they can be marked with new ones. Using the right bulbs Replacement bulbs are specified in ... the lamp housings and affect lamp performance. If a bulb is removed for North America to assure lamp performance, light brightness and pattern and safe visibility.
Owner's Manual - Page 59
... base and secure it away from the lamp assembly by its plastic base and do not touch the glass. To replace all instrument panel lights - Remove the rubber boot from the bulb. 6. Grasp the bulb only by pulling on one of the tabs. 5. When the bulb's three metal tabs are clear...
Owner's Manual - Page 60
... sure that the headlamp control is in reverse order. Disconnect the electrical connector from the lamp assembly by pulling rearward. 4. Remove the bulb socket from the bulb by turning counterclockwise.
60 Carefully remove the lamp assembly by pulling it rearward. 4. Replacing front parking/turn /backup lamp bulbs are located on the bottom...
Owner's Manual - Page 61
... assembly (located above the license plate) from the fog lamp bulb. 3. Install the lamp assembly on liftgate with two screws. To complete installation, follow the removal procedure in the fog lamp turning clockwise. Replacing fog lamp bulbs (if equipped) 1. Install the bulb socket in reverse order. Install the bulb socket in...
Owner's Manual - Page 64
... operation, rotate control upward to the wiper arm and press it from the arm. 3. To activate the rear washer, rotate position and the control to remove it into the service position. 2. Turn the blade at an angle from the windshield and lock into place until a click is heard. Push the lock...
Owner's Manual - Page 66
... to full open the storage compartment.
The door will open slightly and can be moved to open . Improper use of aftermarket garage door openers: • Remove the Velcro pad from the plug. AUXILIARY POWER POINT WARNING: Power outlets are designed for accessory plugs only.
Owner's Manual - Page 76
... the crossbars as far forward on the crossbars. Loosen the thumbwheel at both ends of the cross-bar (both ends of the cross-bar. 4. To remove the cross-bar assembly from falling out. Slide the cross-bar to evenly distribute the load, position it in the endcaps on both sides of...
Owner's Manual - Page 80
... your vehicle: • Take all your vehicle's transmitters to your vehicle. Replacing lost transmitters If a remote transmitter has been lost and you would like to remove it from your authorized Mazda dealer for programming, or • Perform the programming procedure yourself. 80 DO NOT TAKE THE FRONT PART OF THE TRANSMITTER...
Owner's Manual - Page 84
...reprogramming procedure must bring your vehicle to a coded key. 84 Turn ignition to 1 (LOCK) and remove the first coded key from the beginning. 1. Locks and Security
WARNING: If an unprogrammed key is ...of each step in 3 (ON) for at least one second). Turn the ignition to 1 (LOCK) and remove the second coded key from 2 (ACC) to 3 (ON) (maintain ignition in the procedure. NOTE: ...
Owner's Manual - Page 85
... ALL remote entry transmitters are brought to authorized Mazda dealership, to aid in troubleshooting. Either of the following actions will respond if unauthorized entry is removed from step 1. If not successful, the new coded key(s) will not start the vehicle's engine and the theft indicator will respond if unauthorized entry is...
Owner's Manual - Page 91
Place the head restraints under the front passenger seat for storage. 3. Folding down rear seats 1. Seating and Safety Restraints
Push control to lower head restraint. Pull the seat release control.
91 Raise the rear seat head restraint and remove.
2.
Owner's Manual - Page 94
... into place and that the seat belt buckles are exposed.
3. Pull the cushion to the original position on the seat backs. Seating and Safety Restraints
2. Remove the head restraints stored under the front passenger seat and return them to the outboard side of the vehicle.
94
Owner's Manual - Page 95
Push the cushion to the inboard side of the vehicle. 2. Seating and Safety Restraints
To install the rear cushion 1. Place the head restraints under the front passenger seat for storage.
95 Raise the rear seat head restraint and remove.
2. Folding down rear seats 1. Make sure that the hinges are locked into place.
Similar Questions
On Mazda 2002 Tribute Which Hose On The Windshield Washer Fluid Reservoir Is
for the front window?
for the front window?
(Posted by cmartmjksa 9 years ago)
Where Is The Transmission Fluid On A Mazda 2002 Tribute Manual Transmission
(Posted by Micromsr 10 years ago)
What Type Of Coolant To Use For A Mazda 2002 Tribute
(Posted by markshorki 10 years ago)
Where Can I Find The Filler Plug On A Mazda 2002 Tribute Manual Transmission
(Posted by joacali 10 years ago)
