2002 Mazda Protege5 Support Question
2002 Mazda Protege5 Support Question
Find answers below for this question about 2002 Mazda Protege5.Need a 2002 Mazda Protege5 manual? We have 1 online manual for this item!
Question posted by nsogulz on July 20th, 2014
Protege5 Don't Show Check Light When I Turn On D Ignition
The person who posted this question about this Mazda automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 6
... 5-20)
Hazard warning flasher switch
(page 5-38)
Light control / Turn signals
(page 5-33)
Audio system
(page 6-11) (page 2-35)
Fog light switch
(page 5-34)
Passenger-side air bag Glove...18)
Cup holder
(page 6-38)
Tilt wheel release lever
(page 3-24)
Lighter
(page 6-37)
Ignition switch
(page 5-2)
Rear window defroster switch
(page 5-37)
Cruise control switches
(page 5-13)
Climate control...
Owner's Manual - Page 27
...belt pretensioners will not work in an accident. A system malfunction is indicated when the warning light constantly flashes, stays on or doesn't come on the skin or in a moderate or ...Seat Belt Pretensioner Systems Warning Light
NOTE
• The pretensioner system will be replaced immediately, even if there was no effect on when the ignition switch is turned to the ON position or ...
Owner's Manual - Page 31
...-EA-01F J39L(02MY).book Page 21 Thursday, November 1, 2001 10:49 AM
Essential Safety Equipment
Seat Belt Systems Seat Belt Warning Light/ Beep
If the driver's seat belt is not fastened when the ignition switch is turned to the ON position, a beep will sound for about 6 seconds and the seat belt warning...
Owner's Manual - Page 55
... the ON position and continues while the vehicle is indicated when the warning light constantly flashes, stays on or doesn't come on . • The air bag system warning light stays off when the ignition switch is turned to the ON position or after the engine is dangerous. After about 6 seconds it goes out. This...
Owner's Manual - Page 73
...spray is released when there is removed too quickly. Before refueling, stop . It could be ignited by sparks or flames causing serious burns and injuries. Sedan
Remote fuel-filler lid relese
Hatchback
... a serious malfunction of the fuel and emission control systems. It may also cause the check engine light in the fuel tank and the fuel cap is pressure in the instrument cluster to stop...
Owner's Manual - Page 74
... AM
Knowing Your Mazda
Doors and Locks
M Fuel-Filler Cap
To remove the filler cap, turn it clockwise until it counterclockwise.
Pull the safety catch up and lift the hood.
3-18
... If the light remains on when the cap isn't tightened securely. To replace the filler cap, turn it clicks. Contact an Authorized Mazda Dealer as soon as possible.
2. The check engine light comes on (...
Owner's Manual - Page 87
...NOTE
After Getting In
• Are all warning lights when the ignition switch is turned to back up, make sure the parking brake warning light goes off. Engine oil, engine coolant, brake... belt fastened? • Do all the lights work? • Check all gauges. • Check all doors closed and locked? • Are the inside and outside lights are clean. • Inspect inflation pressures ...
Owner's Manual - Page 95
... Cruise Control ...5-13 Instrument Cluster and Indicators ...5-20 Meters and Gauges ...5-20 Warning/Indicator Lights and Beeps ...5-24 Warning/Indicator Lights ...5-24 Beeps ...5-32 Switches and Controls ...5-33 Lighting Control ...5-33 Turn and Lane-Change Signals ...5-34 Fog Lights ...5-34 Daytime Running Lights ...5-35 Windshield Wipers and Washer ...5-35 Rear Window Wiper and Washer (Hatchback...
Owner's Manual - Page 96
...Thursday, November 1, 2001 10:49 AM
Driving Your Mazda
Starting and Driving Ignition Switch
M Ignition Switch Positions
Automatic transaxle When turning the ignition switch to the LOCK position, keep the shift lever in this position can ...the key be removed. Manual transaxle When turning the ignition switch to the LOCK position, push the key in P (park)
LOCK ...
Owner's Manual - Page 97
... Starting the Engine
NOTE
NOTE
If turning the key is started in this ...started . The warning lights (except brakes) should fasten their seat belts. 2. Occupants should be checked after the engine is ...started (page 5-24).
then it returns to side. NOTE
The starter will sound when any door is not in park (P). NOTE
M Ignition Key Reminder
If the ignition...
Owner's Manual - Page 98
...or after the vehicle has stood idle several days, let the engine warm up to stop . Turn the ignition switch to stop will cause longer stopping distances or even an accident. CAUTION
Don't try the starter...: Driving with the Engine Off: Continuing to drive when the engine is stalled or turned off is stalled or turned off, find a safe place to the START position and hold (up without use ...
Owner's Manual - Page 100
...that some components are operating incorrectly, the control unit may turn the brake system warning light on. Electronic brake force distribution system warning If the ...check the light again. Have it will take longer to have the brakes inspected immediately. WARNING
Brake Warning Light: Driving with this light remains on at any time. Don't drive with the brake system warning light...
Owner's Manual - Page 101
... the same time is turned to stop than under these conditions because the tires will function normally as possible. WARNING
ABS: The ABS cannot compensate for safe driving. When both lights on loose surfaces (snow or gravel, for a few seconds when the ignition switch is dangerous. A vehicle with both lights are on for example...
Owner's Manual - Page 120
... If the electronic brake force distribution control unit determines that it may turn the brake system warning light on. It goes off the right-of-way. Have it will ...ignition switch in the START or ON position. Low brake fluid level warning/ Electronic brake force distribution system warning If the light stays on when the parking brake is fully released. With the engine stopped, check...
Owner's Manual - Page 127
...
To prevent discharging the battery, don't leave the lights on the end of the control lever.
High beams
M Headlights
To turn on the lights, turn the knob on while the engine is off.
5-...2001 10:49 AM
Driving Your Mazda
Switches and Controls Lighting Control
M Lights-On Reminder
If lights are on and the key is removed from the ignition switch, a beep will return to the normal position ...
Owner's Manual - Page 150
... to the right to increase volume, to the left to turn the audio system off.
J39L(02MY).book Page 18 Thursday, November 1, 2001 10:49 AM
Interior Comfort
Audio System
M Power/Volume/Sound Controls
Display
Power/Volume knob
Audio control knob
Power ON/OFF Turn the ignition switch to turn the power/ volume knob.
Owner's Manual - Page 169
...out within 30 seconds, remove it in the ACC or ON position. OFF
ON
OFF ON
Light off Light on when the liftgate is open
CAUTION
• Don't touch the metal part of the lighter... Page 37 Thursday, November 1, 2001 10:49 AM
Interior Comfort
Interior Equipment
M Luggage Compartment Light
Lighter
The ignition switch must be in and release it. Press it to prevent overheating.
6-37
Form No...
Owner's Manual - Page 185
... transaxle in park (P), a manual transaxle in the radiator hoses and connections, heater hoses and connections, radiator, and water pump. Then turn the ignition switch to cool the engine.
Apply the parking brake. 3. Check the coolant level. If steam is still leaking, stop the engine and let it cools. If you find a leak or...
Owner's Manual - Page 187
... and injuries. Follow this procedure: 1. An exploding battery can damage a 12 V starter, ignition system, and other electrical parts beyond repair with a low fluid level.
If the engine starts... Hydrogen gas, produced during normal battery operation, could ignite and cause the battery to start , crank it there. 2. Turn the ignition switch to the START position and hold it without ...
Owner's Manual - Page 201
... read the separate Mazda Warranty statement provided with the engine running . Turn the ignition switch off and remove the key from the ignition switch when you 're unsure about any servicing or maintenance procedure, have... it done by a qualified service technician with the ignition switch in problems. This section gives instructions only for items easy to do ...
Similar Questions
How Do You Check The Clutch Fluid Level On A 2002 Mazda Protege5
(Posted by frsza 9 years ago)
How To Reset Airbag Light On A 2002 Mazda Protege5
(Posted by rrierKA 10 years ago)