Maytag MVWC200XW Support Question
Maytag MVWC200XW Support Question
Find answers below for this question about Maytag MVWC200XW.Need a Maytag MVWC200XW manual? We have 3 online manuals for this item!
Question posted by bibfaqu on March 28th, 2014
High Pitch Sound From Whirlpool Washer Even When It Is Unplugged
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Maytag MVWC200XW Manual Pages
Installation Instructions - Page 2
..., space saving 90° elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with washer)
Adjustable or open end wrench 9/16" (14 mm)
4" min (102 mm)
Level
Wood block
Ruler...Part Number 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42"...
Installation Instructions - Page 3
...washer. DRAIN SYSTEM
Drain system can be at least 39" (990 mm) high; See "Washer Care" in your Use and Care Guide.
This washer has been tested for installation with maximum slope of laundry tub must be needed.)
Laundry... standpipe must be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Minimum carry-away capacity: 17 gal. (64 L) per minute. Top of...
Installation Instructions - Page 4
... the customer to install it is recommended that a qualified electrician determine that a separate circuit breaker serving only this time.
4 Tip washer back and place on floor behind washer. If your washer includes a sound shield, please refer to the instructions included with local codes and ordinances. ELECTRICAL REQUIREMENTS
INSTALLATION INSTRUCTIONS
Before you are not sure...
Installation Instructions - Page 5
... pliers and slide black elbow end of drain hose should be used.
5 Gently place power cord over side of washer.
4.5" (113 mm)
Place hose into standpipe or lay on elbow end of laundry tub. 3. For a floor drain, remove the preinstalled drain hose form as shown. do not force excess hose into standpipe...
Installation Instructions - Page 6
... for a few seconds through hoses into a laundry tub, drainpipe, or bucket to check for leaks
Turn on coupling by hand until clear.
10. Screw on water faucets to prevent clogs. Damage can result.
Repeat with flat washers (not provided). Check for leaks. 7. You may enter washer. HELPFUL TIP: Make note of water may...
Installation Instructions - Page 7
...to check levelness of front using lid, as needed.
Secure drain hose
Laundry Tub
Standpipe
Wall
14. If washer is level, skip to reduce excess noise and vibration.
13. Not Level... leveling feet tightly against washer cabinet. Use side seam as a guide to prop up front of washer about 1/2" (13 mm) from the washer cabinet. HELPFUL TIP: You may want to laundry tub leg, drain standpipe...
Installation Instructions - Page 8
... Instructions. Be sure you have correct electrical supply and recommended grounding method. q Check that washer is an extra part, go back through steps to complete full cycle.
8 q Read "Washer Use" in your washer, measure 1/2 of normal
recommended amount of washer.
Start washer and allow to see what was skipped. 16.
q Check that yellow shipping materials...
Owners Manual - Page 2
WASHER SAFETY
2
Owners Manual - Page 3
... are available on the lid lock mechanism. RINSE
You will hear the agitator moving the load. Items need to the washer. Select a wash temperature based on your laundry load. WASH
You will hear sounds similar to poor cleaning performance, and may change at the correct time in a cold and cool water wash, some...
Owners Manual - Page 4
...as sheets, small comforters, jackets
Normal Heavy
Hot Warm Cool Cold
High Use this light will unlock once the washer movement has stopped.
Large items such as sport shirts, blouses, ...casual business clothes, permanent
press, and blends.
SPIN
LID LOCKED
The washer spins the load at high speed. Remove the load promptly for heavy fabrics or special-care items washed by...
Owners Manual - Page 5
...because heat can pass under the agitator and become trapped, causing unexpected sounds.
• Sort items by recommended cycle, water temperature, and ...laundry boost product, add to the bottom of detergent to items during washing. Sort and prepare your garments.
Synthetics, knits, and corduroy fabrics will pick up lint from towels, rugs, and chenille fabrics. USING YOUR WASHER...
Owners Manual - Page 6
...Liquid Fabric Softener Manually to move freely for correct amount of the rim.
3. Load laundry into washer. Items need to Wash Load
During the final rinse, wait until liquid reaches the... see "Cycle Guide".
6
IMPORTANT: Fabric Softener option must be selected to "Yes" to pause the washer. For best results, do not pack the load tightly. Do not wrap large items such as sheets ...
Owners Manual - Page 7
... will add a low amount of water for load unbalance. This is the temperature from your previous washer provided.
You will be cooler than what your faucet. Filling is left open the lid to filling... load balance is very cold, warm water may take several minutes if the load was spinning at high speed. Then close lid and press START/ Pause/Unlock again to move freely.
8. Select WATER ...
Owners Manual - Page 8
... damaging product over time.
3. Shut off water supply to washer, to avoid flooding due to cancel the cycle.
IMPORTANT: To avoid damaging the washer's finish, do not use abrasive products.
8 Unplug washer or disconnect power. Unplug or disconnect power to ensure bleach has been rinsed from washer. IMPORTANT: Do not add detergent. If cycle must be...
Owners Manual - Page 9
... drain hose from drain system and drain any remaining water into a pan or bucket. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again:
1. Reconnect water inlet hoses. Disconnect drain from back of washer.
4. Unplug power cord.
5. Run washer through the following recommended procedure:
To use , vacation, winter storage, or moving .
3. Turn on both...
Owners Manual - Page 10
... is normal to inlet valve. Gurgling or humming
Washer may be attached and have water flowing to hear the pump making a continuous humming sound with periodic gurgling or surging as metal snaps, ...with the floor and locked. See "Level the Washer" in inlet hoses, which can cause basket to be level to fill appropriately)
Check for leaks (laundry tubs, drain pipe, water pipes, and faucets...
Owners Manual - Page 11
....
Lid must be tightly packed or unbalanced. Do not interrupt cycle. You may be closed for small items. Use a cycle with high spin speeds. Do not add more than 96" (2.4 m) above the floor. See "Using Your Washer" for correct drain hose installation.
Use only HE detergent. Do not add detergent.
11
The...
Owners Manual - Page 12
..." to the selected cycle. Load garments in the inlet hose. Not cleaning or removing stains
Washer not loaded as recommended.
This washer uses cooler wash and rinse water temperatures than those using a higher speed spin.
The high spin speeds combined with air flow during the final spin. Load garments in loose heaps evenly...
Owners Manual - Page 13
.../Pause button. Use dispensers to improve cleaning. Load dispensers before washing to match your Washer" section.
Use only liquid chlorine bleach in loose heaps evenly around the basket wall...Cycle Guide" to possibly avoid the cost of bleach dispenser when loading and unloading washer.
Do not add products directly onto load.
Always follow the manufacturer's directions.
...
Owners Manual - Page 14
...also may not apply to you on major appliances with the product, Maytag brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter "Maytag") will need repair service, first see the "Troubleshooting"...book and your authorized Maytag dealer to determine if another warranty applies. MAYTAG® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Can I use Affresh washer cleaner in my traditional top-load washer?
... signs of residue buildup as HE machines, but will also benefit from my Top-loading HE washer? Can I use Affresh washer cleaner? If you undertake a regular maintenance routine to make sure that you have a high-efficiency washer, (top-load or front-load) it is recommended that it continues to purchase Affresh... -
How do I remove odors from my Top-loading HE washer? Top-load HE with Dispensing Drawer
.... Press Start. - Always do I remove odors from my Bravos High Efficiency washer? See also Why is recommended that all remaining washer cleaner or bleach is damp, use a dehumidifier. If the procedure does not sufficiently improve washer freshness, evaluate your laundry room is rinsed from developing in combination with Dispenser Drawer The fabric... -
Not draining, not spinning out water, wet loads - Top-load HE washer with Dispenser Drawer - video
... started. Add only 1 or 2 garments after washing. My Bravos TM High Efficiency washer isn't draining or spinning out enough water. Top-load washer Washer not draining, not spinning out water; Top-load HE washer with Dispensers in the drain pipe. Secure the drain hose. Do not tape over the...
Similar Questions
How To Disable My Whirlpool Washer Lock
(Posted by XfRo 10 years ago)
High Pitched Whinning Noise
Hi, I get a real high pitched, whinning noise when my washer goes into the last 5-6 minutes of the s...
Hi, I get a real high pitched, whinning noise when my washer goes into the last 5-6 minutes of the s...
(Posted by vcarchy 13 years ago)