Maytag MMV4203DB Support Question
Maytag MMV4203DB Support Question
Find answers below for this question about Maytag MMV4203DB - 2.0 cu. Ft. Combination Range Hood-Microwave.Need a Maytag MMV4203DB manual? We have 2 online manuals for this item!
Question posted by tenopaul on June 19th, 2011
Microwave Show Se And No Function Is Working. What Is The Issue?
recently on the display its showing SE and even if we unplugg and restart still showing SE and not functioning. Please help.
Current Answers
Related Maytag MMV4203DB Manual Pages
User Instructions - Page 1
... should not be heated in this section.
IMPORTANT SAFETY INSTRUCTIONS
When using the microwave oven.
are able to explode and should experience a problem not covered in accordance ... that can be followed, including the following:
WARNING: To reduce the risk of the microwave oven opening, behind the door.
for additional information.
These words mean:
You can happen if...
User Instructions - Page 2
.... Do not use the microwave oven near a swimming pool, or similar locations.
[] Do not immerse cord or plug in oven.
- m See door surface cleaning instructions in convection, combination, grill or "PAN BROWN...not use paper products when appliance is not working properly, or if it is in the microwave oven for its intended use above ranges with metal foil. THIS COULD RESULT IN VERY...
User Instructions - Page 3
... ordinances.
If the power supply cord is helpful when cooking with plates that are bigger than...microwave oven. or P.M., then touch Start control again.
24 hour mode: Touch CLOCK, enter time, then touch the Start control. Kitchen Timer
The kitchen timer can result in the display... independently during preset or sensor (on some models) functions.
3 Use the Control Setup to soil buildup, ...
User Instructions - Page 4
... time in pounds (0.1-6.0), and touch the Start control. to start the microwave oven at the top front of the microwave oven opening, behind the door.
For list of the number pad "1" subtracts...needed, then touch the Start control. Always follow label instructions on the underside of the microwave oven. Touch SNACK MENU, select food item (Nachos, Chicken Wings, Potato Skins or Cheese...
User Instructions - Page 5
... clock.
• A letter followed by a number is off . It may experience static or noise while microwave oven is on cavity walls, microwave inlet cover, cooking rack supports, and area where the door touches the frame can cause arcing. Display shows messages • A scrolling prompt to heat 1 cup (250 mL) of cold water for contact and...
User Instructions - Page 6
... original model/serial numbers that is
contrary to the Internet and you need further assistance, you on the upper or lower front facing of the microwave oven opening, behind the door. SOME STATES AND PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR LIMITATIONS ON THE DURATION...
Installation Instructions - Page 1
...alerts you to Wall 7.
These installation instructions cover different models. Install the Microwave Oven 8. Location Requirements 2.. Attach Mounting Plate to potential hazards that can be ... mean:
You can happen if the instructions are very important. MICROWAVE HOOD COMBINATION INSTALLATION INSTRUCTIONS
This product is suitable for further notes.
Electrical Requirements...
Installation Instructions - Page 2
... or plaster/lath within cabinet opening where the microwave oven will not discolor, delaminate or sustain other types of wall structures, be combined.
Check with any obstructions so that the materials...piece, the
3" (7.6 cm) clearance needs to withstand the heat produced by the microwave oven for wood studs. See "Installation
Dimensions" illustration. Materials needed
• Standard ...
Installation Instructions - Page 3
...electrical short circuit, grounding reduces the risk of range/cooktop below. WARNING: Improper use an adapter.
or 20-amp electrical supply
with a grounding plug.
A
B
H iI H iI
66" (167.6 crn) rnin.
12" (30.5 crn) rnin.
:z: :r: : : :
€
A. 2" x 4" wall stud B.
Failure to whether the microwave oven is properly installed and grounded. SAVETHESEINSTRUCTIONS Do not...
Installation Instructions - Page 4
... at the perforations.
-
Remove any remaining contents from the back of the microwave oven, then remove mounting plate and set for recirculation installation. Remove the 2 screws that attach the mounting plate to top of microwave oven
3. NOTE: To avoid damage to the work surface, cover the work surface.
1. Perforations C. Blower motor B.
Blower motor screw
3. Mounting plate...
Installation Instructions - Page 5
... Make sure the assembly is oriented correctly, with the top blower motor screw removed in Step 1 of the microwave oven (as shown), performance will be poor. A
i
B
A. Reinsert blower motor screw removed in Step 2 ... in Step 2. Attach damper assembly to damper plate by sliding it into microwave oven.
Lower blower motor back into the lower locking tabs.
Damper plate C.
Secure...
Installation Instructions - Page 6
...:fenmowicarollswtuadvoseevxeins.wt ithinthecabineotpeningd,onot Seeillustrationins"PossibWlealSl tudConfigurations." 1. Ma_'< Rea_'
The microwave oven must be done. Using measuring tape, find and clearly mark the vertical
centerline of 1 lag screw, preferably 2. 1. Possible Wall Stud Configurations
These depictions show examples of the vertical centerline (see illustration). One Wall Stud...
Installation Instructions - Page 8
... guides.
4. Make sure the 83/4'' (22.2 cm) dimension from upper cabinet.
3. Handle the microwave oven gently. 1. A. These are for the power supply cord.
A
A. Make sure the template centerline ... needs to be against the upper cabinet bottom. IMPORTANT: The control side of the microwave oven. NOTE: If upper cabinet is maintained. Metal cabinet B. Support tabs 4. Damper assembly...
Installation Instructions - Page 9
... surface.
8. Upper cabinet bottom B. A
B
E
A. Do not remove ground prong. Failure to provide) may require bolts longer or shorter than 31/4'' (8.3 cm).
Check the operation of microwave oven by operating the vent fan. 5. 6.
Hanging front edge D. Replace the fuse or reset the circuit breaker.
Longer or shorter bolts are available at least one...
Installation Instructions - Page 10
...cm) of clearance between the top of the microwave oven and the transition piece. Roof cap: 3 ¼" x 10" = 24 ft (8.3 x 25.4 cm = 7.3 m) C. 90 ° elbow: 3¼" x 10" = 25 ft (8.3 x 25.4 cm = 7.6 m) D. 90 ° elbow: 6" = 10 ft (15.2 cm = 3 m) E.
Wall cap... not installing 2 elbows together, for optimal hood performance
If venting through the roof, and rectangular to round transition is used,...
Installation Instructions - Page 11
... the damper from your model number located on the front facing of the microwave oven.
One 3 ¼" x 10" (8.3 x 25.4 cm) 90 ° elbow = 25 ft (7.6 m) B. 1 waft cap = 40 ft (12.2 m) C. 2 ft (0.6 m) + 6 ft (1.8 m) straight = 8 ft (2.4 m)
6" (15.2 cm) vent system = 73 ft (22.2 m) total
B
6 It (I .8 m)
C
D
A. ASSISTANCE
Call your authorized dealer or service center for details...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Food characteristics and cooking results - Microwave oven
...issues, but does not solve my problem The answer needs updating and/or additional information The answer could be improved Thank you Not Helpful Helpful Answers others found helpful FAQs Knowledgebase search tips Best cooking results - When microwave...answer helpful? Microwave oven How do characteristics of food Composition and density Foods high in my microwave oven? ... -
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
...your Bravos washer functions. How the washer...conventional top-load washers? Straighten the hoses. Some cycles use an extension cord. Display shows an error code - The wash action turns on . For best results, ...after the selected hours of the basket) should seem low because this washer work differently than the washer provides. Is the power cord plugged into a ... -
Display shows an error code - Top-load washer with Dispensers in Corners
... does not work: Re-select the cycle and press Start/Pause. Enter Model Number How do I find my model number? Top-load washer Display shows HC - Top-load washer The following answers for error-code related issues you can correct: Display shows Sd - Top-load washer with Dispensers in Corners Display shows LF - Top-load washer Display shows LF...
Similar Questions
Microwave Does Not Work But The Light Inside Comes On. Fuse?
(Posted by juliedesignmark 11 years ago)
How To Get Fan Turn Off On Maytage Microwave-range Hood Combination Mmv4203dq
(Posted by Anonymous-79210 11 years ago)
What Does 'se' Or '5e' Mean On The Display Of My Maytag Microwave?
I cannot get the microwave control panel to do anything. It only displays "SE" or "5E" on the face o...
I cannot get the microwave control panel to do anything. It only displays "SE" or "5E" on the face o...
(Posted by pamelakwg 11 years ago)
Microwave Oven Won't Heat
My microwave oven, 2 years old, not used that much has stopped heating up water.
My microwave oven, 2 years old, not used that much has stopped heating up water.
(Posted by MarjorieChowning 11 years ago)