Maytag MHWZ600TW Support Question
Maytag MHWZ600TW Support Question
Find answers below for this question about Maytag MHWZ600TW - Epic Z Front Load Washer.Need a Maytag MHWZ600TW manual? We have 1 online manual for this item!
Question posted by kim21023 on March 21st, 2012
Power Turns Off After Rinse Cycle, Thus Skipping The Final Spin Cycle.
The power turns completely off after the rinse cycle, skipping the final spin cycle. The water pump is clear of debris. The clean cycle doesn't run properly- no water fills and it just spins. As I'm testing a load right now on quick wash, it didn't even get to the final spin cause it's only been 10 min and it turned off. Some clothes are wet while others seem barely touched, so I'm guessing the water isn't filling all the way now. :(
Current Answers
Related Maytag MHWZ600TW Manual Pages
Use and Care Guide - Page 5
...Part Number 8572546.
5 The pedestal will add to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
Overhead sewer
Standard 20...
2 longer water fill hoses: 6 ft (1.8 m) Part Number 76314 10 ft (3.0 m) Part Number 350008
Options
Pedestal
You have the option of purchasing pedestals of the washer. Ask for this washer. Beaded strap...
Use and Care Guide - Page 6
... Requirements."
„ Hot and cold water faucets located within 6 ft (1.8 m) of where the power cord is not reversible. Installation clearances „ The location must be large enough to allow the washer door to the washer.
„ A grounded electrical outlet located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi...
Use and Care Guide - Page 10
... wrench.
2. On the back of particles in the rear panel of its final location.
Clear water lines
„ Run water through the opening of the rear panel and close the hole with the attached cap.
4. IMPORTANT: Position the washer so that the rear of the washer is seated on the valve. There are 4 transport bolts in the...
Use and Care Guide - Page 12
... to its final location.
2. Level the Washer
Properly leveling your washer avoids excessive noise and vibration. Slide the washer to adjust back feet.
4. Repeat steps 1-3 until washer is against a wall, move the washer out slightly before tipping back. 3. A
B
A. Make sure all four feet are in the laundry tub or standpipe as shown. If the drain hose moves, water may...
Use and Care Guide - Page 13
.... Check for a medium-size load. 5. Complete Installation
1. IMPORTANT: All four feet must be tightened. Select NORMAL, and then select START. Use only HE High Efficiency detergent.
13 WARNING
Electrical Shock Hazard Plug into a grounded 3 prong outlet.
8. Failure to complete one whole cycle. To test and to see which step was skipped.
3. Check that you have...
Use and Care Guide - Page 14
... steel drum eliminates corrosion and enables higher spin speeds for this option is powerful enough to drive an average clothes load up to reduce drying time. The time of all wash cycles except Rinse & Spin, Spin Only, and Clean Washer. In addition, if the Dynamic Balance system detects off -balance" conditions, your water and energy bills. You are three common...
Use and Care Guide - Page 15
... Laundry
Before washing clothes for a medium-size load. WARNING: To reduce the risk of your washer. This initial cycle serves to using your model. WASHER USE
NOTE: The panel shown above may also result in washer errors, longer cycle times, and reduced rinsing performance.
The following is a guide to ensure the interior is normal during the final installation step...
Use and Care Guide - Page 16
... is complete. If desired, select the CYCLE SIGNAL.
To load washer Open the washer door by selecting POWER. Sort laundry according to the detergent, bleach, or fabric softener compartments. Overloading can cause poor cleaning. „ The washer can be filled with a regular non-HE detergent. NOTE: Use only HE High Efficiency detergent.
4. Place a load of fabric. Turn on the washer by...
Use and Care Guide - Page 17
..., and Modifiers can be automatically dispensed in the final rinse or in this compartment. Select desired cycle. 4.
The washer powers down, the door unlocks, and clothes can be removed. If the modifier or option are available with all Cycles. Items can be removed from the washer.
17 Liquid chlorine bleach compartment D. NOTE: Overfilling could cause garment damage...
Use and Care Guide - Page 18
...PAUSE/CANCEL and POWER. To add items 1.
Clean The Clean light comes on your water pressure, water temperature, detergent, and clothes load.
The CONTROLS LOCKED status light illuminates.
NOTE: To add garments after the ADD A GARMENT period is selected. The cycle time will stay on until this feature except Rinse & Spin, Spin Only, and Clean Washer. If a large load of fabric and...
Use and Care Guide - Page 19
...
Cold
Low
Spin Only
:14
N/A
High
Rinse & Spin
:26
Cold
High
Clean Washer
:56
N/A
High
*The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load.
Preset Cycle Settings
Each cycle has a preset Cycle Time, Water Temp, and Spin Speed.
Spin Only
Use this cycle to drain your washer or to drain and spin your hot...
Use and Care Guide - Page 20
... soiled items that need pretreatment. „ Add detergent to a load using the fabric softener dispenser.
See "Cleaning Your Washer" in stain removal.
Prewash
Use this cycle with the same water temperature as the Normal rinse.
Not all modifiers are available with all options and cycles.
„ See the "Laundry Guide" section for an overview of possible options for...
Use and Care Guide - Page 21
...Spin
All loads
✔
✔
Clean Washer
No clothes, use AFFRESH® washer cleaner tablet or chlorine bleach
Extra Rinse
✔
Cycle Signal
✔
✔ ✔
✔
✔
21
Warm rinses leave the loads dryer than 60°F (15.6°C), detergents do not dissolve well. Laundry Guide
Refer to the right are washing. The ATC is automatically turned...
Use and Care Guide - Page 22
...,
snaps, and buckles may also result in washer errors, longer cycle times, and reduced rinsing performance. Metal objects such as 2x or higher will create too much sudsing with equal amounts of your garments. „ Use only High Efficiency detergents. To create a balanced load
it is completed. The package for this type of the tub...
Use and Care Guide - Page 24
..., using the procedure that uses higher water volumes in the washer, it will not immediately stop the cycle. Cleaning the exterior
24 Inspect the colored seal/bellow between the door opening and the basket for proper use. A
A. This will rotate while the washer runs a short sensing cycle. IMPORTANT: „ Wear rubber gloves when cleaning for prolonged periods. „ Refer...
Use and Care Guide - Page 25
...-size load, to the
rear panel of time, you will be removed for easy cleaning. 1.
Cleaning the dispenser drawer
The dispenser drawer can result in Dispenser
Illustration, see "Using the Dispenser").
Put 1 qt (1 L) of replacement. Turn on a Drain & Spin cycle.
2. Do not remove ground prong. Do not use washer again:
1. Plug in the drum. Run washer on both water faucets...
Use and Care Guide - Page 26
.... Use only HE (High Efficiency) detergents. „ "F--E--" Variables (Washer Problem) Press POWER to cancel the cycle. Noisy, vibrating, off the inside of the door, when the door is drained from the rear of the washer.
„ Are the fill hoses tight?
„ Are the fill hose gaskets properly seated? Water can result in firm contact with metal snaps...
Use and Care Guide - Page 27
...; Are the laundry products in the washer. To avoid odors leave the door open to allow the washer to lock/unlock controls.
27 Door won 't power up all of the water drain out of the drain.
„ Is the door locked and is locked, run the Clean Washer with AFFRESH™ Cycle lately? The washer door will unlock. Washer won 't unlock...
Use and Care Guide - Page 28
... the same time in water source. Washer won 't dispense
„ Is the washer level? HE detergent is used.
„ Is the load balanced? Allow the cycle to provide good cleaning results. Not enough water/Not enough suds
„ Low water? HE detergent is responding. Washer won 't run
„ Is the washer in a normal pause in washer or reconnect power. „ Are the touch...
Use and Care Guide - Page 29
... and cold water hoses reversed? Do not add detergent to remove soil and hold it stops.
„ Did you select will start a Rinse/Drain & Spin cycle. Follow manufacturer's recommendations for load, use Small Load on the Small Load cycle? If safe for the type of dye, unload the washer as soon as it in a load. Select a cycle with this cycle, wash time...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I remove odors from my Top-loading HE washer?
... about your laundry room is rinsed from the washer. 1. Use warm or hot water in your washing machine unless the fabric you allow for other causes. How do I remove odors from my Top-loading HE washer? Turn the cycle control knob to allow the Clean Washer cycle to complete without interruptions. If necessary, the Clean Washer cycle may be run a Rinse or Rinse & Spin cycle to ... -
How do I remove odors from my Top-loading HE washer? Top-load HE with Dispensing Drawer
... completely before beginning the cleaning process. The Clean Washer cycle uses higher water volumes in the washer for washers with Dispenser Drawer - Using the Affresh washer cleaner (recommended): Do not add detergent or load to Clean Washer cycle. Always do I remove odors from my Top-loading HE washer? Close the lid. Press Power. Turn... -
Dry fabric after washing - Top-load HE washer with Dispenser Drawer
...with Dispenser Drawer Loads are tangling and twisting - Top-load HE washer with Dispenser Drawer Why are tangling and twisting - sound clips Sounds during wash - Vibration - Small loads or the fabric at the top of the laundry dry after the cycle completes? Dry fabric after the final spin. The load has been washed and rinsed, but the final spin removes enough water from the...
Similar Questions
Washer Stopped In Rinse Cycle. Will Nor Run. I Performed A Diagnostic Test
I took clothes out there was no water left in machine. I tried diagnostic test but it stops at first...
I took clothes out there was no water left in machine. I tried diagnostic test but it stops at first...
(Posted by dwaters5 5 years ago)
Maytag Epic Z Washer Turns Off When Wash Cycle Starts
(Posted by daphi 10 years ago)
