Maytag MED9800TK Support Question
Maytag MED9800TK Support Question
Find answers below for this question about Maytag MED9800TK - 27" Electric Dryer.Need a Maytag MED9800TK manual? We have 1 online manual for this item!
Question posted by cherimitchell on November 12th, 2013
User Manual Model # Med9800tqo
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by BusterDoogen on November 12th, 2013 10:34 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Go to this page to view or download the mnaual.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Maytag MED9800TK Manual Pages
Use and Care Guide - Page 3
...You can kill or hurt you understand and have provided many important safety messages in this manual and on or in , or spotted with controls.
[] Do not repair or replace ...published user-repair instructions that have been previously cleaned in, washed in, soaked in the dryer. IMPORTANT SAFETY iNSTRUCTiONS
WARNING: To reduce the risk of the dryer or attempt any part of fire, electric shock...
Use and Care Guide - Page 4
...; The pedestal will need to the "Assistance or Service" section. See "Electrical Requirements" and "Venting Requirements" before starting installation. Optlonal pedestal f 1_._ /39.4 cm] model shown)
The pedestals are included.
4 ',eveling leg_
NOTE: Do not use leveling legs if installing the dryer on a pedestal? For further information, please refer to place the 15...
Use and Care Guide - Page 5
...the bottom of the dryer. See "Venting Requirements." • A separate 30-amp circuit. • If you will need 18" (46 cm) to open fully.
38,,/ (96.52 Cm)
/
{80crn)
_/
\_
27"
(68.6 cm)...are using a power supply cord, a grounded electrical outlet located within 2 ft (61
cm) of either side of the dryer. At lower temperatures, the dryer might be exposed to reduce noise transfer.
...
Use and Care Guide - Page 6
..." m_ )A_,
_fff_
(9366.5"2mcimn).W'
_
4,
1"* ---_tt.,_--27"_
(2.5cm) n (69.6era)
_- 1"*
2.6cm)
*Required spacing Closet installation -
Recommended
installation spacing for cabinet installation
• For cabinet installation, with vents
*Required spacing **For side or bottom venting, 0" (0 cm) spacing is allowed. Dryer only
t
A. C}oset door with a door, minimum ventilation...
Use and Care Guide - Page 7
...--_
(2.5 cm)
-_- 27"_
68.6 cm
2.5 cm
Mobile home - lo supply the required _ or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (ore or4 wire, 120/208 volt electrical supply, if specified on ... be made in conformance with a 3-wire electrical supply connection. that a qualified
Electrical Connection
[b properly install your dryer, you will be removed from : National ...
Use and Care Guide - Page 8
... a UI. If your outlet looks like this :
3-wir_' r_,ceptacl_, (lO-30R)
Then choose a 3-wire power supply cord with clothes dryers. SAVE THESE INSTRUCTIONS
8 listed power supply cord kit marked for electric current. The kit should be
type SRD or SRDT and be run with the circuit conductors and
connected to the...
Use and Care Guide - Page 9
... Blvd., toronto, ON M9W 1 R3 CANADA.
• [b supply the required 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply on a separate 30-amp circuit, fused on both sides of dryer's final location. Connect to do so can result in length. Be sure wall receptacle is equipped with the Canadian...
Use and Care Guide - Page 11
... from a %" (1.9 cm) U[.
listed strain relief (UI. Put the threaded section of electrical connection:
Electrical Connection Options
If your home has:
4-wire receptacle (NEMA Type 14-30R)
And you will...strain relief through the strain relief. ]he strain relief should have a tight fit with the dryer cabinet and be connecting to:
A UL listed, 120/240volt minimum,
Go to Section
4-wire...
Use and Care Guide - Page 12
...dryer can be moved if needed.
12
Remove neutral ground wire from external ground conductor screw. Tighten screws.
!! !!
Fxte'rnal ground conductor scre'w - B. Neutral wire" (white or center wire') E. You have 5 ft (1.52 m) of power supply cord to center silvercolored terminal block screw. Direct wire cable must have completed your electrical... wire) of dryer rear paneh Secure...
Use and Care Guide - Page 13
... hooked ends together.
!! !! of the terminal block. down screw.
7. You have completed your electrical connection. Tighten strain relief screw. 6.
Strip 5" (12.7 cm) of outer covering from 3 ...hooks facing right). Neutral wire twhite or cente'r wire)
cable
Place the hooked ends of dryer rear panel.
Strip insulation
1"
ground wire at 5" back 1" (2.5 cm). Shape
Connect ground...
Use and Care Guide - Page 14
... with outer covering. Connect the other wires to neutral wire. A. Shape ends of wires into slot of extra length so dryer can be moved if needed. Neutral ground wir_" C. Tighten screws.
!! !I
4. Strip insulation back 1" (2.5 cm). ...Direct wire cable must have completed your electrical connection. A ....... You have 5 ft (1.52 rn) of dryer rear paneh Secure cover with hold-
Use and Care Guide - Page 15
... to outer terminal
!! Neutral ground wire C. (o_'nter silver-colored terminal block screw D. Insert tab of terminal block cover into slot of dryer rear panel. You have completed your electrical connection.
C_ulter silver-colored tenTlinal block screw
C. Tighten screws.
!!
4, lighten strain relief screws. 5. Connect a separate copper ground wire from external ground conductor...
Use and Care Guide - Page 17
...) Contact your local dealer to follow these instructions can result in death, fire, electrical shock, or serious injury. Other installations are shown here.
(10.2 cm) A. B
J
•.... Dryer B. Hbow C. Exhaust outlet
metal vent to connect
elbows
Optional exhaust installations This dryer can cause moisture and lint to collect indoors, which may contact your local...
Use and Care Guide - Page 19
...(7.6 m)
17 ft (5.2 m)
4
Rigid metal
27 ft (8.2 m)
21 ft (6.4 m)
Flexible metal
23 ft (7 m)
15 ft (4.6 m)
1. Slide the dryer on the cardboard. Once the exhaust vent connection ...models) Check that extend into the leg holes by hand. Use clanlps to
existing vent, make sure the vent is made, remove the corner posts and cardboard. Screw the legs into the interior of the 2 dryer...
Use and Care Guide - Page 21
...dryer...dryer...Dryer door is an extra part, go away. See "level Dryer...dryer door and feel heat, turn on the dryer. 8. Remove the plug strip or label.
Check the dryer... dryer is...dryer has been running or "On" position, • Start button has been pushed firmly. • Dryer...Dryer door B. Read "Dryer Use." 9. If there is first heated. Close the door and check that the dryer...dryer...dryer...
Use and Care Guide - Page 22
... instructions or fire.
This manual covers several different models.
Clean lint screen before operating this manual for more detailed information.
...electric shock, or injury to
lock / unlock control
Pause
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer. can completely remove oil. Follow these instructions explosion, or fire. Place laundry...
Use and Care Guide - Page 23
...
Less
O
DRYNESS LEVEL
NOTE: Time is extracted from where the cycle was interrupted if you can change by 1-minute intervals. or +) buttons until dryer starts.
......
DRY TIME
NOTE: The Manual Dry Time feature can 't be changed.
• Press the EXTRA CARE feature button if this option is interrupted for 3 seconds to select...
Use and Care Guide - Page 25
... (-
Manual preset cycle settings
Manual Cycles Load Type
TIMED DrY
Heavyweight, work clothes, sheets CASUAL Permanent press, synthetics DELICATE lingerie, blouses, washable woolens SUPEr DELICATE Exercise wear, sheer curtains, lace
Temp. High Medium High
Default Time (Minutes) 40
20
27
Extra care Feature When you do not select the Extra Clare feature, the dryer...
Use and Care Guide - Page 28
...WetanylonbrushwithhotwatearndliquiddetergeSntc.rublintscreewniththebrustho removreesidubeuildup. Use masking tape to do so can result in death or electrical
shock.
1. Make a paste with a 10-watt appliance bulb only. Tumble ...until all parts and panels before servicing. OR
laundry
detergent and very warm water. Dry unstable dye items inside the dryer drum when you should be done by a ...
Use and Care Guide - Page 29
...qualified electrician.
• Was a regular fuse used for the dryer. When balled up ? Failure to vibrate.
Electric dryers fuses or circuit breakers. continues, call an electrician.
• Is the correct...hood to side? I.arge loads may not have not tripped. Electric dryers require 240-volt power supply. The dryer may vibrate if not properly installed. Check with lint? Check ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dryer does not heat - Electric dryer
... the fuses or reset the circuit breakers. Enter Model Number How do I find my model number? Dryer Did you recently install a power supply cord on... be incorrectly installed. Review the Installation Instructions to the dryer. Electric dryers use 2 household fuses or circuit breakers. Gas dryer FAQs Knowledgebase search tips My dryer will not start Damp loads or long drying times - The... -
Loads are damp; dryer does not dry
... the dryer is running. Electric Dryer Dryer does not heat - Dryer Poor drying performance - There are consistently not as dry as you would like, you selected will become your satisfaction. Check the following links for all Sensor Dry cycles. Dryers Electronic controls with digital displays: Changing the Preset Dryness Level Settings (available on some models... -
My dryer or load has an odor
... in surrounding room air to avoid odors. The odor is on the load because the dryer pulls in the washer or dryer for the first time? (Electric dryers) A new electric heating element may have an odor. Is the dryer being used for a long time will begin to grow mildew, which will be gone after...
Similar Questions
Manual For Electric Dryer
need a care and use manual for Maytag electric dryer MEDB755DW
need a care and use manual for Maytag electric dryer MEDB755DW
(Posted by leoladillon 7 years ago)
Dryer Showed F 1 Yesterday
dryer showed f 1 yesterday. today only the light inside will light up, but controls do not light up....
dryer showed f 1 yesterday. today only the light inside will light up, but controls do not light up....
(Posted by leaseresidential 8 years ago)
Maytag Dryer Model Med9800tq0 Won't Start
(Posted by bop27jtom 9 years ago)
Maytag Med9800tqo Dryer
The time display is blank, there is a light on the normal setting and on the damp, and will not resp...
The time display is blank, there is a light on the normal setting and on the damp, and will not resp...
(Posted by 4c36b27f 10 years ago)
