Makita MAC5200 Support Question
Makita MAC5200 Support Question
Find answers below for this question about Makita MAC5200.Need a Makita MAC5200 manual? We have 2 online manuals for this item!
Question posted by alpinedave on November 25th, 2020
Compressor Will Not Shut Off When It Reaches The Desired Psi Continues To Run To
The person who posted this question about this Makita product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by INIMITABLE on November 25th, 2020 2:56 PM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,069,620
Member since:
April 3rd, 2020 Points: 2,069,620
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Makita MAC5200 Manual Pages
Owners Manual - Page 1
... -Single Phase Motor RPM Amperage @ max pressure Tank Size CSA/US Listed
MAC5200 3 6.9 6.5
110 PSI 140 PSI 47 mm 44 mm
120 3420 13.8 5.2 Gallon Yes
Minimum Circuit Requirement: 15 AMPS *A circuit breaker is operated on. www.makitatools.com If the air compressor is connected to a circuit protected by fuses, use time delay fuses.
Owners Manual - Page 2
...SAFETY INSTRUCTIONS 3 Warning Chart 3
GLOSSARY 7 DUTY CYCLE 7 GENERAL INFORMATION ON-RECEIPT INSPECTION 7 STORAGE 8 DESCRIPTION OF OPERATION 8 INSTALLATION and BREAK-IN PROCEDURES 9
Location Of the Air Compressor 9 Lubrication and Oil 9 Initial Start Up Procedure 10 Extension Cords 10 Piping 10 Grounding Instruction 10 OPERATING PROCEDURES 11 Daily Start-up Checklist 11 MAINTENANCE...
Owners Manual - Page 3
... WARNINGS AND OPERATING INSTRUCTIONS BEFORE
USING THIS EQUIPMENT.
HAZARD
Risk of Unsafe Operation
WHAT CAN HAPPEN HOW TO PREVENT IT
Unsafe operation of your air compressor could lead to serious injury to you or others.
• Review and understand all times.
• Do not operate the product when fatigued or under...
Owners Manual - Page 4
Never use the compressor to the pressure switch, safety valve, or any other inflatables can cause them to explode...could result in serious injury to you and others.
Risk of Attachments and Accessories Bursting
Exceeding the pressure rating of air tools, spray guns, air operated accessories, tires AND other components, which control tank pressure.
• Follow the equipment ...
Owners Manual - Page 5
... serious injury to you are present.
Like any other components.
• Sprayed materials such as paint, paint
• Never inhale air from the compressor, either directly or from your compressor is powered by qualified service personnel or a licensed electrician, in a wet environment.
It is raining, or in accordance with good cross ventilation...
Owners Manual - Page 6
...
from the tank and any
attempt repair or
attachments before attempting maintenance, attaching tools or accessories.
Page 6
Risk of Burn
Contact with your specific application. damaged...the compressor.
Do not reach around protective shrouds or attempt maintenance until unit has been allowed to cool. HAZARD
WHAT CAN HAPPEN HOW TO PREVENT IT
Risk to Breathing (continued)
solvents...
Owners Manual - Page 7
... be used for operating paint spray guns, air tools, caulking guns, grease guns, air brushes, sandblaster...carefully tested and checked before the motor automatically shuts off , air tank pressure drops as you...compressor outfit is changed regularly, it begins to run, air pressure in transit and cause problems with compressor operation.
a unit of measure of air delivery. Now you continue...
Owners Manual - Page 8
...compressor or when compressor will shut off " position and wait for inspection of the pressure switch, is used to drain condensation at the air outlet. AIR COMPRESSOR... the air tank. 2. When the air compressor reaches "cut-out" pressure, the check valve ...run over). On the down in a clean and dry location. See "Maintenance". Store the air compressor in the cylinder.
Useable air...
Owners Manual - Page 9
SAFETY VALVE: If the pressure switch does not shut off the air compressor at its "cut-out" pressure setting, the safety valve will protect against...motor when the air tank pressure reaches the factory set pressure (slightly higher than desired pressure. LUBRICATION AND OIL CAUTION: Do not attempt to operate this air compressor without oil. The air compressor head and shroud are shipped without...
Owners Manual - Page 10
... restrict the flow of air. If an extension cord must be properly grounded.
This air compressor must be used in good condition. Regardless of its indicated pressure rating, plastic pipe can ...valve. 2.Plug power supply cord into
correct power source. 3.Run the compressor for use extra air hose instead of an extension cord. Your compressor is the same size, or larger than, the air tank...
Owners Manual - Page 11
...If drain cock valve is ready for air tools and accessories. The air compressor can then be stored. Page 11
Do not... use . DANGER: Improper grounding can result in well-ventilated areas; Motor will stop when tank pressure reaches... tank pressure to "OFF" and the air regulator or shut-off valve is closed. 2. Adjust the regulator to the...
Owners Manual - Page 12
... ISO 68 ISO 100
Page 12 BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, UNPLUG THE COMPRESSOR AND BLEED OFF ALL AIR PRESSURE. Drain water from the air tank, any unusual...1. PERSONAL INJURIES CAN OCCUR. correct as necessary. Inspect air filter, replace if necessary.
5.
Compressor units in the
middle of operation and the working environment operating on a daily basis. If ...
Owners Manual - Page 13
...air filter removed. • A dirty air filter will shut off frequently, check for any reason, the overload protector will not allow the compressor to the check valve threads. Unscrew the check valve (...turn clockwise). 8. Do not operate the compressor with the recommended oil to be sure it is clean. • If it is running. Apply sealant to operate at all air pressure...
Owners Manual - Page 14
...or dirty check valve. A defective check valve results in the tank and the compressor is shut off.
WARNING DO NOT DRILL INTO, WELD OR OTHERWISE MODIFY AIR TANK OR... switch. DO NOT OVER TIGHTEN. Contact a trained service technician. PRIOR TO ATTEMPTING ANY REPAIRS, UNPLUG THE COMPRESSOR
AND BLEED OFF TANK AIR PRESSURE. CORRECTION
• Move the pressure switch lever to see if the pin...
Owners Manual - Page 15
...when accessory is used, adjust the regulator following the instructions.
Do not operate the air compressor in the paint spray area.
• Plug unit into "live" electrical outlet.
&#... or replace.
• Tighten fittings. (See Air Leaks section of pressure switch. Motor will not run.
• Motor overload protection switch has tripped.
• Tank pressure exceeds pressure switch "cutin"...
Owners Manual - Page 16
Regulator knob has continuous air leak. If necessary, reset circuit breaker.
Replace regulator.
Do not operate the compressor in the paint spray area.
Do not use ... fuse and replace. Dirty or damaged regulator internal parts. PROBLEM CAUSE
Motor will not shut off " position; Page 16 Regulator will not run. (con't)
• Check valve is stuck open , replace it. See flammable vapor...
Owners Manual - Page 17
... Factory Service Centers listed, or to one of the carton detailing the problem with your tool. Page 17 Suite 809 Farmers Branch, TX 75234 (972) 243-1150
12701 Directors Drive...108th Street West Allis, WI 53227 (414) 541-4776
Customer Record
When you need service: Send complete tool (prepaid) to an Authorized Makita Service Center.
Broadway Road, Suite 6
Phoenix, AZ 85040
(602) ...
Owners Manual - Page 18
...well ventilated area, and work .
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita tool is warranted to be free of defects from workmanship and materials for the period of ... caused by others;
• repairs are required because of normal wear and tear;
• the tool has been abused, misused or improperly maintained;
• alterations have been made or attempted by defective...
Owners Manual - Page 19
...
Size
Power
Price
Other (
)
Makita Brand
DATE PURCHASED
MONTH
DAY
YEAR
INTL. SERIAL NO. This product was purchased from:
Home Center
Other (
Hardware/Lumber Store
Tool Distributor
Industrial Supply
Construction Supply
2.Use of the product is intended for:
Construction Trade
Industrial Maintenance
Home Maintenance
Hobby
Other (
)
5.
Parts Breakdown - Page 1
...breather Electric motor / Crankcase
Makita Air Compressor Part Breakdown - Model MAC5200
Part #
Qty
455015-E 2
181122... Plug Manifold block Rubber cup Tool box lock Folding handle lock set (L&R) Tool box Wiring harness (motor -pr...lock Start Capacitor Run Capacitor Overload Switch Centrifugal Switch Bolt
Part #
Qty Item Description
402015-E 2
74 Capacitor Cover
217001-E 1
Compressor oil (1 ...
Similar Questions
I Need The Torque Specs For The Mac 5200 Compressor Head Bolts
Makita mac5200. Compressor head bolt torque specs
Makita mac5200. Compressor head bolt torque specs
(Posted by landgcustomtrim 4 years ago)
Low Air Volume & Running Constantly
It Constantly runs & not enough air to drive framing guns. Only get enough for about five nails ...
It Constantly runs & not enough air to drive framing guns. Only get enough for about five nails ...
(Posted by Hblevinsh 6 years ago)
Where Is The Reset Button Located On A 5200 Compressor
where is the reset button located on a 5200 compressor
where is the reset button located on a 5200 compressor
(Posted by jrkaval 8 years ago)
Makita Air Compressor Mac5200
I've got a Makita mac 5200 air compressor that is suddenly leaking air out the pressure regulator kn...
I've got a Makita mac 5200 air compressor that is suddenly leaking air out the pressure regulator kn...
(Posted by dklilja 8 years ago)
I Accidently Ran The Makita Compressor With Out Adding The Airfilter..
Hi; I ran the air compressure with out removing and adding the airfilter I ran it with and with out ...
Hi; I ran the air compressure with out removing and adding the airfilter I ran it with and with out ...
(Posted by dverkuyl 11 years ago)