Home » Lincoln » Troubleshooting » 2009 Lincoln MKS

2009 Lincoln MKS Support Question

Find answers below for this question about 2009 Lincoln MKS.
Need a 2009 Lincoln MKS manual? We have 6 online manuals for this item!

Lincoln Overview Questions Manuals Reviews Videos Research

Question posted by TOPGUNN123 on June 9th, 2014

Engine Light On At 62k

the engine light just came on at 62k . What is the cause of that ?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by stephanie0001 on June 9th, 2014 9:37 AM

This answer was accepted by the poster of the original question.

stephanie0001

Member since:
March 25th, 2014

Points: 173,170

1,100
points

This should give you help on what the lights mean, you might need to scroll down a page or 2.

http://www.manualowl.com/am/Lincoln/2009-MKS/Manual/4244?page=9

This is probably the one you need to read about for further explanation. Scroll down a little to see.

http://www.manualowl.com/am/Lincoln/2009-MKS/Manual/4244?page=312

If my answer has helped you, you can help me a lot by selecting the "Acceptable Solution" button.

Related Manual Pages

Owner's Manual - Page 12

... times, it means that may illuminate when a problem exists with one of your vehicle to cause extensive repairs. If any light remains on after the engine is not ready for additional information. Refer to the respective system warning light for I /M) testing in the Maintenance and Specifications chapter. Solid illumination after starting the vehicle, refer...

Owner's Manual - Page 13

... this time, seek service immediately from your authorized dealer. WARNING: Driving a vehicle with the parking brake engaged can cause brake failure and the risk of personal injury. Driving extended distances with the brake system warning light on when the engine is dangerous. A significant decrease in braking performance may occur. Instrument Cluster WARNING: Under...

Owner's Manual - Page 14

...possible , switch off and the grade assist function has been turned on , it stays on while the engine is running or hot. Stop the vehicle as soon as possible. Have the system serviced immediately, refer... information. WARNING: Never remove the coolant reservoir cap while the engine is active. If the light remains on , refer to the Driving chapter. 14 If it indicates a Traction Control™ ...

Owner's Manual - Page 120

... Note: Large metallic objects, electronic devices that are too close to the key when starting the engine. If a problem occurs with the SecuriLock system, the indicator will not start it with the ...but may cause a momentary issue if they are used to purchase gasoline or similar items, or a second coded key on the key chain away from touching the coded key while starting the engine. Always...

Owner's Manual - Page 122

...; You must have two previously programmed coded keys (keys that already operate your vehicle's engine) and the new unprogrammed key(s) readily accessible. • If two previously programmed coded ...key(s), wait 20 seconds and then repeat this procedure from the ignition. 4. The theft indicator light may repeat Steps 1 through 8. Remove the newly programmed coded key from the ignition. 7. ...

Owner's Manual - Page 133

.... • There is running. Continue pressing to be replaced periodically. To operate the cooled seats: Press once to activate the high heat setting (three indicator lights). If the engine falls below 350 RPMs while the cooled seats are on , the feature will turn itself off and will only function when the...

Owner's Manual - Page 151

...after the safety belt warning light turns off. 3. The...warning light turns off , then followed by the safety belt warning light flashing...As confirmation, the safety belt warning light will flash four times per second...As confirmation, the safety belt warning light will enable the Belt-Minder feature ...it is designed to work in conjunction with the light off (approximately one minute). • Step ...

Owner's Manual - Page 215

.... 3. Warning lights illuminated. Starting your vehicle is normally reached after 10 minutes of radio noise. This system meets all Canadian interference-causing equipment standard requirements... regulating the impulse electrical field strength of moderate driving or idling. For more information on starting the engine. Off...

Owner's Manual - Page 217

Starting the engine Note: If your vehicle is in the Instrument Cluster chapter for starting. 1. Turn the key to 3 (on ) without turning the key to 4 (start system in this section for more information regarding the warning lights. Driving • Make sure the gearshift lever is equipped with a push button start system, refer to...

Owner's Manual - Page 218

... into gear and drive. After idling for up to 10 seconds or until the engine begins to right of the steering wheel. Note: If the engine does not start your vehicle, your vehicle's electrical system and the warning lights in the trunk. 1. This will power your Intelligent Access key (IA key) must be...

Owner's Manual - Page 219

To Start your vehicle's engine, press the START/STOP button (for at least one second. Note: The indicator light on the start your vehicle (see the NO FOB DETECTED message, ... immediately start the vehicle and you are in on mode, you must first switch the vehicle off the engine. If you move your audio speakers. There may be detected near the roof (between the driver or passenger...

Owner's Manual - Page 223

...resumes. P light in the Instrument Cluster chapter for concern. do not pump the brake pedal since this will use .4 to 1.0 kilowatt-hours of energy per hour of the engine block heater cord...ABS braking is attained after approximately three hours of the ABS and will increase your engine block heater will reduce the effectiveness of operation. Using ABS When hard braking is ...

Owner's Manual - Page 227

... a whoosh of the instrument panel. When the brakes have the system serviced by momentarily reducing engine power. Excessive wheel spin is a driver aid feature that is most active at low speeds....8226; A slight deceleration of the vehicle • The "sliding car" indicator light will use only engine power reduction or transfer to the wheel that helps your foot is not manually ...

Owner's Manual - Page 229

...Do not fill the power steering pump reservoir above the maximum level, as this may be caused by your authorized dealer. • Heavy or uneven steering efforts may result in the ... In R (Reverse), ABS and the Engine and Brake Traction Control features will illuminate steadily. Pressing the AdvanceTrac off button again will turn off the lighted button and the sliding car icon .

Owner's Manual - Page 230

...your vehicle until you cannot move the gearshift lever out of the 6-speed automatic transmission Your vehicle has been designed to the engine while decelerating. See your foot from P (Park) when the ignition is in the on and the brake pedal applied,... the vehicle's brake lamps are working properly. This fuel economy benefit may not be perceived as a light to your vehicle.

Owner's Manual - Page 241

...and slow down gradually before returning to the pavement. Press lightly on the accelerator in strong crosswinds which could cause the vehicle to slide sideways out of control or rollover...• If your vehicle goes off the highway. A lower gear operation will maximize the engine and transmission cooling capability. If your vehicle gets stuck If your speed. Under severe operating ...

Owner's Manual - Page 243

...cause the vehicle to become stuck to a lower gear and drive steadily through deep water may be required from another vehicle. Lower gear operation will maximize the engine... slowly and avoid spinning your vehicle slowly while applying light pressure on the most solid area of the trail.... always try to back out the way you came if you proceed with caution. After driving through ...

Owner's Manual - Page 244

...Lightly" is better to back down to avoid excessive brake application and brake overheating. A danger lies in the same gear you would use to climb up or straight down a hill or steep incline, you will cause the tires to climb the hill. Whenever driving on the engine... to help preserve our national forest and other side. Apply just enough power to the wheels to slip, spin or lose...

Owner's Manual - Page 249

Should your battery. WARNING: Failure to the engine. Ford Motor Company recommends that has the specified amperage rating. Using a fuse with ...run down your vehicle shut off after a collision due to this vehicle is equipped with a higher amperage rating can cause severe wire damage and could start button twice to the on position. Roadside Emergencies Note: With extended use, the ...

Owner's Manual - Page 301

... and may cause engine damage. • Decreased engine coolant concentrations below 40% will automatically switch to increase. 301 indicator will illuminate. How fail-safe cooling works If the engine begins to overheat: • The engine coolant temperature gauge will move to the red (hot) area. • The coolant temperature warning light • The service engine soon will...