Lasko 3138 Support Question

Find answers below for this question about Lasko 3138.
Need a Lasko 3138 manual? We have 1 online manual for this item!

Lasko Overview Questions Manuals Reviews Videos Research

Question posted by acetone82 on April 22nd, 2019

Parts For Lasko 3138 Fan

what is the part number for the wheel (right and left) for the wheels on the lasko mdl 3138 30" fan AND where can they be purchased?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Lasko 3138 Manual Pages

User Manual - Page 1

...locate a Fan where it may fall into a matching receptacle. CAUTION: BECAUSE OF THE SIZE AND WEIGHT OF THIS FAN, MAKE SURE ALL PARTS ARE COMPLETELY ASSEMBLED ACCORDING TO INSTRUCTIONS. INCLUDED WITH THIS FAN: (1)...the risk of the Fan. 3. Rain may cause fire, electrical shock, or injury to the electri- 30" INDUSTRIAL GRADE OSCILLATING PEDESTAL FAN WITH WHEELS Model 3138 READ AND SAVE THESE...

User Manual - Page 2

... BAG A: (1) Mounting Flange (1) Square Head Bolt (3/8-16 X 1") (4) Carriage Bolts (3/8-16 X 1") (4) Split Lockwashers (3/8") (4) Hex Nuts (3/8-16) HARDWARE BAG CONTENTS HARDWARE BAG D: (1) Left Wheel Assembly (1) Right Wheel Assembly (4) Carriage Bolts (5/16-18 X 1") (4) Split Lockwashers (5/16") (4) Hex Nuts (5/16-18) Carriage Bolt (3/8-16 X 1") Square Head Bolt (3/8-16 X 1") Split Lockwasher...

User Manual - Page 3

... on floor. 2. E 8/10 Figure 3 3 5084445 Repeat above procedure with other Wheel Assembly. DO NOT FULLY TIGHTEN AT THIS TIME. BASE ASSEMBLY Locate Hardware Bag "A" to Base. (Figures 2 and 3) 1. GO BACK AND FULLY TIGHTEN each Hex Nut so that Wheel Assemblies are RIGHT and LEFT handed. (Figure 3) 3. Thread the 3/8-16 X 1" Square Head Bolt into the...

User Manual - Page 4

... MAKE SURE BOLTS IN COLUMN AND MOTOR ASSEMBLY STEPS ARE TIGHT BEFORE STANDING FAN UPRIGHT. 4. GRILL AND BLADE ASSEMBLY Locate remaining parts from the motor, until it stops against the shaft (Inset A) .... hole in the Mounting Flange. Loosen 3/8-16 X 1" Square Heat Bolt in the center, is right side up lower pipe of the screwdriver between the Front and Rear Grills, next to motor speed ...

User Manual - Page 5

... Pull: Medium Fourth Pull: OFF 2. Oscillation: Push down position. 4. Dry all parts completely before repositioning Fan. CAUTION: Do not use ALCOHOL OR SOLVENTS. SERVICING: For servicing, other than general...on motor housing to make certain to power supply. Tilt fan back onto wheels as they will damage the Fan. lect desired operating speed with these instructions, in personal ...

User Manual - Page 6

.... They can be defective or replace the whole product with product and service questions, and replacement parts. NOTWITHSTANDING ANYTHING TO THE CONTRARY, IN NO EVENT SHALL LASKO'S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH LIABILITY SHALL TERMINATE UPON THE EXPIRATION OF THE WARRANTY...