2000 Land Rover Discovery Series II Support Question
Find answers below for this question about 2000 Land Rover Discovery Series II.Question posted by poppyhdesign on February 15th, 2012
Where Is The Crank Shaft Sensor Located For 2000 Landrover Discovery Series 2
The person who posted this question about this Land Rover automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by rjontheroll on December 5th, 2013 2:11 AM
Under the engine, driver side, just above the exhaust which has three 1/2 bolts, there is a grey (covered in oil) circular cap with two 8mm bolts and a six inch wire going up toward the back of he engine. After you remove this cap the sensor is there held in with two 7mm bolts and two spacers, the six inch wire has a clip which you will have to remove. I suggest doing this after you have remove the two 7mm bolt holding it in, this way you can use a slotted screwdriver to release the clip while you hold the sensor with your other hand.To replace doeverything in reverse. Getting the clip off and on are the hardest parts, very little space.Note:Do not over tighten the 7mm bolts when you replace! this may break your new sensor.Good Luck
Supporting Image
You can click the image below to enlargeSimilar Questions
Where Is The Crankshaft Sensor Located On A 2001 Land Rover Discovery 2
(Posted by emyna 9 years ago)
What Does The Crank Sensor Do On A 2000 Discovery 2
(Posted by Arramla 9 years ago)
Where Is The Crank Sensor Located On The 2002 Land Rover Discovery
(Posted by mlnahippi 9 years ago)
Help Gas Is Leaking From The Gas Line Fuel Injecter To Gas Tank?????
My mechanic said one out of two lines is leaking gas from the fuel injecter to the gas pump? What is...
My mechanic said one out of two lines is leaking gas from the fuel injecter to the gas pump? What is...
(Posted by b8blah 13 years ago)