Model Kscs25inbtoo Ice Maker Not Cycling But Bypassing Module Will But No Water

No water comes in

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on October 16th, 2022 9:38 AM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,648,060

1,100
points

steps: 1 Make sure the ice maker is plugged into a working outlet. 2 Turn off the power switch usually located near the front of the appliance. 3 Remove the ice tray from the freezer. 4 Place the ice tray back into the freezer. 5 Plug the power switch back on. 6 Press the button on the side of the ice maker to select "Ice" mode. 7 Wait until the ice maker cycles again. 8 Repeat step 6 if necessary. 9 Once the ice maker is cycling properly, remove the ice tray from the refrigerator. 10 Replace the ice tray into the refrigerator. 11 Press the button on top of the ice maker to return to normal operation. 12 Enjoy!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

KitchenAid Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Storing my Bottom freezer/French-door refrigerator
... filter bypass. Storing my Bottom freezer/French-door refrigerator What preparation should I take if I plan to avoid damage. Unplug refrigerator. Use a sturdy container to the ice maker at least one will drop below . If your refrigerator has an automatic ice maker: Shut off ) until water begins to a water source or replacing the water filter, flush the water system...
Water supply hookup - Bottom freezer/French door refrigerators
... seal. Turn off the ice maker. Place brass compression nut (A) and sleeve (B) on , 5 seconds off main water supply. Correct leaks if necessary. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on copper tube end as shown. Reverse-osmosis water filter. Non water-filter models To connect to clear line...
Water supply hookup - Bottom freezer/French door refrigerators
...operate the water dispenser and ice maker. Tighten the packing nut. Remove plastic cap from the system, water may crush ...into water supply line before the water line is clear. Check for cleaning. Non water-filter models To connect .... 4. Reverse-osmosis water supply The pressure of the water supply coming out of a reverse-osmosis system going to the water inlet valve of 4...