KitchenAid KUDS30IXSS Support Question
KitchenAid KUDS30IXSS Support Question
Find answers below for this question about KitchenAid KUDS30IXSS.Need a KitchenAid KUDS30IXSS manual? We have 4 online manuals for this item!
Question posted by mcphibtinda on November 2nd, 2013
Cant Get Kitchen Aid Dishwasher Lower Spray Arm Back On
The person who posted this question about this KitchenAid product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related KitchenAid KUDS30IXSS Manual Pages
Dimension Guide - Page 1
...drain hose is supplied with the air gap installation instructions. ® Undercounter Dishwasher
PRODUCT MODEL NUMBERS
KUDC10FX KUDC10IX KUDE20FX KUDE20IX KUDE40FX KUDE50CX KUDE60FX KUDE60HX
KUDE60SX KUDE70FX.... For complete details, see Installation
our products, we reserve the right to house plumbing lower than 20"
Use ¹⁄₂" (1.3 cm) minimum I.D. Drain Requirements: A ...
Installation Guide - Page 2
...to :
• Slowly open door. Remove shipping materials, drain hose and lower rack. The dishwasher must be performed by a qualified service technician. All safety messages will tell ... Prepare and Route Water Line 8 Install Drain Hose 10 Install Moisture Barrier 11 Prepare Dishwasher 11 Make Power Supply Cord Connection 12 Determine Cabinet Opening 13
Installation Instructions (cont.)...
Installation Guide - Page 3
...line
See "Electrical Requirements" section.
If the wooden panel is recommended when installing a dishwasher under - 2 - See "Electrical Requirements" section. clamps (2)
Phillips-
INSTALLATION REQUIREMENTS
... Tools needed :
Cordless drill with any tools listed here. If parts are included in lower rack)
Make sure all these parts are not included, call 1-800-422-1230.
3...
Installation Guide - Page 6
...: ¹⁄₂" minimum plastic tubing is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher.
• Make sure to connect drain hose to house plumbing lower than 20" (50.8 cm) above subfloor or floor.
• Use ¹⁄₂" minimum I.D. Outlet must plug into a grounded 3 prong...
Installation Guide - Page 12
...
Using a ¹⁄₄" hex head socket, nut driver or Phillips screwdriver, remove 2 screws attaching access panel and lower panel to reduce the chance of dishwasher tub.
Strain relief is provided with a towel to lower part of damaging the power supply cord. Retain for later use.
4
Route cord so that it does not...
Installation Guide - Page 14
...[87.6 cm].) If the minimum cabinet opening height is higher than the cabinet opening , but the dishwasher will be removed for 4" (10.2 cm) toe kick. for toe kicks greater than
34" (86... the setscrews and hex key from "Dishwasher Height Adjustment Chart."
3 Built-up Floors-Add
shims as needed
(140."1 cm)
(52c"m)
(7 cm)
14
Built-up floors: If the kitchen floor is 33³⁄₄" ...
Installation Guide - Page 17
...Repeat this step for the other side.
Repeat this step for the other side of the dishwasher so that it keeps the bracket in back or other injury.
Score line
Break off the... install dishwasher. With another person holding the rear of the dishwasher
to keep screws from the package and place in the open dishwasher door and place
towel over pump assembly and spray arm of ...
Installation Guide - Page 18
... left side of opening and drain hose is near the center of the cabinet opening . Tilt dishwasher backward on wheels and move the tensioner to a lower-numbered hole and replace screw. With another person holding the dishwasher to keep it from the rear leg of 3 holes , , in the locations shown to prohibit them...
Installation Guide - Page 20
....com/drain under FAQ tab. Turn on wire connectors (not included) rated to connect your household wiring to "Secure Dishwasher in Cabinet Opening" section. Visit www.kitchenaid.com/watersupply under FAQ tab. Strain relief is connected, remove towel.
2...the new drain hose into terminal box
Route cable so that it does not touch dishwasher motor or lower part of the drain hose.
Installation Guide - Page 22
... of door does not contact screws, brackets or countertop.
Tighten bracket screws.
22 If spacing is opened.
4 Check door clearance
Open dishwasher door, remove lower dish rack, and place towel over pump assembly and lower spray arm of dishwasher. The dishwasher must be secured to side cabinet
NOTE: Do not drop screws into pump area when securing...
Installation Guide - Page 23
.... Make sure the vinyl pad is properly centered, replace plastic buttons.
7 Remove towel and replace
lower dishwasher rack
Bottom Sound Pad Installation (on some models)
Access panel
Lower panel
Insulation
Grounding clip
23 Remove towel from inside the dishwasher and take it will go, making sure lettering is facing up through the floor, you...
Installation Guide - Page 24
... not use an adapter.
Adjust if necessary.
4 Tighten screws
Plug into a grounded 3 prong outlet. Position the lower panel behind the insulation on the lower panel.
2 Reinstall access panels
Hold the 2 panels together and place them against dishwasher leg. Do not remove ground prong. Tighten access panel screws. 24 Reconnect Power
1 Reconnect power
Reconnect...
Installation Guide - Page 25
... be used , replace inlet hose after 5 years to reduce the risk of the dishwasher tub. Rinse Aid is necessary for good drying results: This dishwasher is closed tightly and latched? • Has the cycle been set correctly to start the
dishwasher? • Is the water turned on the hose for future reference.
25
Start...
Use & Care Guide - Page 4
...
Lower spray arm
...spray arm
Parts and Features
ProScrub® (on some models) powerful jets target water toward pots, pans, or casserole dishes loaded in the back of the dishwasher... to grind food particles, which are flushed out the drain at the end of each cycle. Upper level wash
Water feed tube Model and serial number label Water inlet opening
Heating element Rinse aid...
Use & Care Guide - Page 5
...
USE RINSE AID FOR Full
BETTER DRYING
Lock
with the soiled surface of the dish toward the ProScrub® spray jets in your dishwasher. Efficient dishwashers run longer to pre-rinse dishes; Place these dishes with the Heat Dry option will
provide best drying and avoid Refill
Add
excessive moisture in the lower rack may...
Use & Care Guide - Page 6
... dishes to use detergent.
■ Use automatic dishwasher detergent only. Pre-Wash section
■ The amount of the water - Hard Water Soft Water
Hard Water Soft Water
C
PRE- Main Wash section C. Spray cannot reach nested items.
Upper rack
Lower rack
■ Make sure nothing keeps spray arm(s) from spinning freely.
Soft to the level shown...
Use & Care Guide - Page 8
... this cycle.
The energy-usage label is the approximate cycle time obtained with normal amounts of the
lower rack.
85
0 - 1.6
(0 - 6)
Raises the main wash
Heavy Duty
Raises the main
45...tough food soil
Normal Wash
ProScrub® spray
to eliminate the need fast results, the 1 Hour Wash will add time to items at the dishwasher. Your dishwasher may not have all the cycles and ...
Use & Care Guide - Page 11
... rack may also have some or all of the surfaces. NOTE: Spin the spray arms while the bottom rack is inside the dishwasher to be sure items in the basket do not interfere with the soiled surfaces ...wash.
in the back of the lower dish rack with the water feed tube, spray arms, or ProScrub® spray jets. ■ Keep the last tine row in the back of the lower rack in the 60°
angled ...
Use & Care Guide - Page 14
...with the wash arms. Readjust the dishware and resume the cycle. The dishwasher may help: Use a commercial cleaner designed for dishwashers once per month... pause in between blinks. Do not use a rinse aid. Be sure the dishwasher is at least 120°F (49ºC). Scrape ...THE TUB/WILL NOT DRAIN" in the lower rack. See "Will Not Fill" in the "Dishwasher Use" section. If the sanitized light ...
Use & Care Guide - Page 15
... water temperature is needed in the lower rack.
Measure the detergent accurately and use only detergents designed for drying and to reduce spotting. ■ Use the correct amount of detergent and rinse aid. (See "HARD WATER [WHITE RESIDUE ON DISHWASHER INTERIOR OR GLASSWARE] in a dishwasher. To avoid rinse aid leaking from using the High Temp...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dishwasher Wash System
...spray arm, remove the food particles from redepositing on the clean dishes. Answers others found helpful Food soil left on the dishes in my dishwasher FAQs Knowledgebase search tips When to change the water filter Options on the strainer. Dishwasher... the coarse strainer and remove any objects on my dishwasher My dishwasher is noisy or vibrates A coarse strainer prevents bones,... -
Food soil left on the dishes in my dishwasher
... reduce washing performance. Older detergent exposed to your model number. Remove any obstructions blocking the wash or spray arms. Make sure the spray arms can turn on the hot-water faucet nearest the dishwasher and let it run ? To check the incoming water temperature, turn freely. Large plates, wooden spoons, and other similar... -
ProScrub® feature
... all of the lower level rack. The ProScrub wash option provides a concentrated wash action to pans, casserole dishes, etc., with the water feed tube or mid-spray arm. Position the tines in the tine holder. Upper rack features Filming on glasses Filming or etching on glasses FAQs Knowledgebase search tips Dishwasher Wash System...
Similar Questions
How To Remove Lower Spray Arm?
How do I remove the spray arm assembly at the bottom of the dishwasher?
How do I remove the spray arm assembly at the bottom of the dishwasher?
(Posted by bmoore6970 2 years ago)
Kitchen Aid Dishwasher Lower Panel Won't Go Back On
(Posted by Krisdlave 9 years ago)
Cant Get Kitchen Aid Dishwasher Spray Arm Back On
(Posted by dracCatz 9 years ago)
My Kitchen Aid Dishwasher Kuds30ixss Wont Work
(Posted by hoastuar 10 years ago)
Kitchenaid Kuds30ixbl 2 Dishwasher How To Remove Lower Spray Arm
(Posted by EKOAGSoCal 10 years ago)