KitchenAid KUDE20IXSS Support Question
KitchenAid KUDE20IXSS Support Question
Find answers below for this question about KitchenAid KUDE20IXSS.Need a KitchenAid KUDE20IXSS manual? We have 4 online manuals for this item!
Question posted by truwayappliance on August 26th, 2016
Is There A Recall On The Control Board For Model Listed Above?
Panel Flashes Error Code Indicating Erc As The Failure. We Have Understood That There Is A Recall On This Unit. Could You Advise What The Recall Is For? Thank You
Current Answers
Answer #1: Posted by Odin on August 26th, 2016 3:57 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
There is no recall pertaining to the KUDE20IXS. ERC represents the clock component of the electronc control board.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related KitchenAid KUDE20IXSS Manual Pages
Use & Care Guide - Page 1
...;ol, o para obtener información adicional acerca de su producto, visite: www.kitchenaid.com Tenga listo su número completo de modelo y de serie. DISHWASHER USER INSTRUCTIONS
Thank you can find your model and serial number on the label located near the door on the right-hand or left-hand side of the...
Use & Care Guide - Page 2
... Do not wash plastic items unless they are marked "dishwasher safe" or the equivalent.
and
2) Load sharp knives with controls.
■ Use the dishwasher only for its intended function.
■ Use only ... not touch the heating element during or immediately after use in or on all enclosure panels are not followed. This is flammable, do not allow children to damage the door seal...
Use & Care Guide - Page 4
... the back of the dishwasher to clean stubborn messes.
Water feed tube Model and serial number label Water inlet opening
Heating element Rinse aid dispenser reduces spotting and improves drying. Lower spray arm
Overfill protection float
EQ Filtration System removes soil from water and improves cleaning action. TOP RACK
Control panel
Culinary tool rack...
Use & Care Guide - Page 5
...35 minutes to maintain peak performance.
Cookie sheets and cutting boards loaded on the left-hand side of the dish toward ...No need fast results. Back of your dishwasher. Proper Detergent Dosing
It is located on food (some models)
When the ProScrub® option is ...closed within 3 seconds, the start button LED will flash, an audible tone will not start. Place these dishes...
Use & Care Guide - Page 7
...button is selected for a given cycle, the lights will flash.
Not all hardness and soil levels. If the door ... - - -- If you change your dishwasher until the indicator level is hot. Efficient dishwashers run longer to start .
7 Always place...model) See "Cycle and Option Descriptions" charts in the previous wash cycle.
Select Options (options vary by either using other dishwasher...
Use & Care Guide - Page 8
...1 Hour Wash will add time to items at the dishwasher.
ADDED TIME TO CYCLE
TYPICAL 53
MAX 73
22
40
ADDED WATER GALLONS (LITERS)
0 - 3.0 (0 - 11.2)
0 - 3.0 (0 - 11.2)
8 Your dishwasher may not have all of food soil.
Select the
...19.1)
6.8 (25.8)
Use for loads containing tough, bakedon food. Cycle and Option Descriptions
This information covers several different models.
Use & Care Guide - Page 10
... 3 seconds of pressing START/RESUME. If the Front Indicator Light is not closed within 3 seconds, the start button LED will flash, an audible tone will be heated to right. NOTE: If your dishwasher is complete.
Only audible tones for hidden control models. If you press any control selections made. If you select the Sani Rinse option...
Use & Care Guide - Page 11
... it is open , you may have some models. The Cancel/Drain light turns off after 2 minutes. Check if Add a Dish indicator is located at the back of the lower rack in the covers to refill the detergent dispenser before completely opening the door.
2. Back of dishwasher). Stacking, overlapping or nesting items will keep...
Use & Care Guide - Page 16
...an upright glass measuring cup in "Troubleshooting."
16 Adjust loading as cookie sheets, cutting boards, or large containers, etc., that the float is connected to resume the cycle by...vinegar rinse through the dishwasher by closing the door and pressing START/RESUME.
Check that may spill onto other than Start/Resume blink and the unit will not run, ...some models) for partial loads.
Use & Care Guide - Page 17
... In this case, the Start/Resume button LED, the Cycle Status Indicator LED(s), and the countdown bars on some models) option can come clear, it is due to ensure it is ..."Dishwasher Use" section. Detergent needs food soil to 120ºF (49ºC). Improper loading can cause dishes to become chipped or damaged. (See specific loading instructions within this error occurs, the controls will...
Use & Care Guide - Page 18
...model/serial numbers that have been removed, altered or cannot be
easily determined. Service calls to refrigerator or freezer product failures...with electrical or plumbing codes, or use only .... If outside the 50 United States and Canada, contact... will pay for use in a dishwasher. Less detergent is level.
Measure ...dish racks and electronic controls. Try another warranty applies...
Use & Care Guide - Page 19
In Canada, call 1-800-422-1230. Have your model and serial number on the label located near the door on the ...schedule service, you can find your complete model number ready. Please keep this User Instructions and model number information for future reference.
All rights reserved.
® Registered Trademark/TM Trademark of the dishwasher interior. For additional product information or ...
Dimension Guide - Page 1
...temperature must meet all local codes and ordinances. copper tubing with your home and local codes and ordinances. It is ...Dishwasher
PRODUCT MODEL NUMBERS
KUDC10FX KUDC10IX KUDE20FX KUDE20IX KUDE40FX KUDE50CX KUDE60FX KUDE60HX
KUDE60SX KUDE70FX KUDL15FX KUDS30CX KUDS30FX KUDS30IX KUDS30SX KUDS35FX
Electrical Requirements: 120-volt, 60-Hz, AC-only, 15- For panel ready models, dishwasher...
Installation Guide - Page 3
...the literature package. Check local codes. It is a registered trademark... ruler
UL Listed/CSA Approved twist...panel is recommended when installing a dishwasher under - 2 - NOTE: Moisture barrier tape is less than ³⁄₄" thick, customer must purchase screws locally.
Check existing electrical supply.
Read and follow the instructions provided with top-venting models...
Installation Guide - Page 5
...3 "-4 " (8.8 cm -10.6 cm)
3" (9.4 cm)
(532.31"cm)
(621 4c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
NOTE: Shaded areas of countertop. For panel ready models, dishwasher depth is 28" (70 cm).
30" (834.37Dc"m)
(1.9
cm) A
A. Product and Cabinet Opening Dimensions
(62.2
cm) B
(60.6 cm) (6287.8 Cc"m)
B. Insulation...
Installation Guide - Page 6
...176; elbow with ³⁄₄" hose connection with your home and local codes and ordinances.
• Use a UL Listed/CSA Approved strain relief. A copy of the above subfloor or floor.
•...requirements for use with a power supply cord:
• Use UL Listed power supply cord kit (Part Number 4317824) marked for your dishwasher.
Use of air gap
Air gap
• Make sure to house...
Installation Guide - Page 12
... cabinet opening to avoid damaging floor covering. Select UL Listed/CSA Approved twist-on its back.
2 Remove panels
Using a ¹⁄₄" hex head socket, nut driver or Phillips screwdriver, remove 2 screws attaching access panel and lower panel to connect your dishwasher.
Do not use door panel as a worktable without first covering with power supply cord...
Installation Guide - Page 13
...connector in death, fire, or electrical shock.
2 Power Supply Cord- Failure to measure the lowest point on the underside of the countertop and ...until instructed to white, using UL Listed/CSA Approved twist-on the floor).
Measure height of cabinet opening
NOTE: Twist on strain relief
Electrical Shock Hazard Electrically ground dishwasher.
Determine Cabinet Opening
1 Measure cabinet...
Installation Guide - Page 14
... the cardboard box.
Tighten the setscrews ¹⁄₄ turn past snug. Custom Panel Dimensions
Custom panel dimensions-Dishwashers with Installation Instructions. add shims as needed in use. NOTE: Shims must be removed for
additional clearance. Retain hex key with control panel on mounting studs with the setscrews facing down. If the installation needs a higher...
Installation Guide - Page 25
... the door closed within 3 seconds, the Start/Resume light will flash until you do not close the door within 3 seconds. If you press it to reduce the risk of the dishwasher tub. Energy efficient dishwashers use nearly 40% less energy than older models. Certain models are equipped with a low wattage, low energy consumption motor, your...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Display shows Sud or Sd - Front-load washer
... adds water for adequate water flow. Make sure that excessive detergent suds occurred during the cycle and your model number into the search tool below for further rinsing. This error code indicates that the drain hose is HE High Efficiency detergent the only type of detergent based on , the washer... -
Display shows F20 or FH - Front-load washer
...is too low, the washer may not properly operate. To find them by entering your model number in the search tool below. Are the water inlet hoses kinked? Reinstall hoses, ...the hose is higher than the manufacturer's recommended amount of water. This error code indicates a water supply problem. Turn on the washer clogged? Completely open both the hot and ... -
Display shows F25 or F06 - Front-load washer
... be improved Thank you operate it. Re-select the cycle and press Start. Model Number | Help me locate my model number Please enter at least 6 characters of the washer before you Not Helpful Helpful Answers others found helpful Display shows an error code - Rate answer 2 of 3 Rate answer 3 of 3 This error code indicates that are...
Similar Questions
My Dishwasher Doesn't Start To Wash.
The lights of the control panel are ok but I hear some repetitive noise (little bit like when a car ...
The lights of the control panel are ok but I hear some repetitive noise (little bit like when a car ...
(Posted by guylaine59 3 years ago)
Soap Dispenser Won't Open. Replaced It And The Control Board, Still Doesn't Ope
soap dispenser on my kuds35fxss3 wouldn't open. Took panel off and found that solenoid got overheate...
soap dispenser on my kuds35fxss3 wouldn't open. Took panel off and found that solenoid got overheate...
(Posted by tgooley 10 years ago)
How Do You Open The Dishwasher Door Model Kudl15fxwh Dishwasher,
Not Wired In Yet. Do You Need Power To Open The Door?
Not Wired In Yet. Do You Need Power To Open The Door?
(Posted by wnay 11 years ago)
Problems With K/a Dw Mod. Kude70fxss0. Need Help.
The dishwasher's clean light is blinking 4 times, then pausing. At another period, it was blinkin...
The dishwasher's clean light is blinking 4 times, then pausing. At another period, it was blinkin...
(Posted by CPRAPPLIANCE 11 years ago)
Dishwasher Wont Start
The dishwasher KUDE20IXSS does not start. Thre Control Lock button keeps blinking
The dishwasher KUDE20IXSS does not start. Thre Control Lock button keeps blinking
(Posted by sinhataru 12 years ago)