Get support for 2008 Jeep Commander

2008 Jeep Commander Support Question

2008 Jeep Commander Support Question

Find answers below for this question about 2008 Jeep Commander.
Need a 2008 Jeep Commander manual? We have 1 online manual for this item!
Question posted by gholmKathyl on April 18th, 2014

2008 Commander Where Add Brake Fluid

The person who posted this question about this Jeep automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner Manual - Page 106

106 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Primary zero one two three four five six seven eight nine star (*) plus (+) pound (#) add location all Espanol Francais help home continue delete dial download edit emergency English erase all Voice Commands Alternate(s) Voice Commands Primary Alternate(s) call cancel confirmation prompts.
Owner Manual - Page 187

... you to turn signals on, a chime will remain on longer, it indicates a possible brake hydraulic system malfunction or low fluid level. Malfunction Indicator Light This light is part of the vehicle in the ON position before 4 Brake Warning Light The BRAKE warning light will flash with the turn the signals off , it may be...
Owner Manual - Page 198

... • LIFTGLASS/DOORS OPEN (with graphic) • LIFTGLASS/HOOD OPEN (with graphic) • WASHER FLUID LOW (with graphic) • COOLANT LOW (with graphic) • OIL CHANGE REQUIRED • OIL ... SHIFT PROCEDURE • SERVICE 4WD SYSTEM • 4WD SYSTEM IN NEUTRAL • LOW BRAKE FLUID LEVEL • WARNING! LIMIT SPEED • CHECK GASCAP • ESP OFF • IOD FUSE OUT...
Owner Manual - Page 286

...controlled Overdrive (5th gear for 3.7L engine, 4th and 5th gears for maximum deceleration (engine braking), move the shift lever to a suitable level. This feature improves the warm up time ... cold temperature operation you may not shift into Overdrive and will resume when the transmission fluid temperature has risen to the left "D(-)" and hold it there. If the transmission temperature...
Owner Manual - Page 289

... that the transmission is due to "Electronic Brake Control System" in several days, the first few seconds of this manual. Refer to the fluid partially draining from Park into gear may lead... 4 (direct gear) and 5/D (Overdrive gear) positions will not engage until the transmission fluid and engine coolant are warm [usually after shifting the transmission into any other gear position. NOTE...
Owner Manual - Page 305

...travel are considered normal and do not indicate that there is due to the cold, thick fluid in cold weather, the power steering pump may become wet, resulting in steering effort, especially... assist is lost. The system will observe a substantial increase in decreased performance and unpredictable braking action. Under these conditions, you good vehicle response and increased ease of time. This ...
Owner Manual - Page 358

... up. NOTE: Check the automatic transmission fluid level before towing. Towing Tips - Cooling...fluid and filter should be changed if you can be selected when towing. Towing Tips - 358 STARTING AND OPERATING Towing Tips - NOTE: Using the "Tow/Haul" mode (if equipped) or a lower gear range while operating the vehicle under heavy operating conditions will also provide better engine braking...
Owner Manual - Page 363

... of the airbag system and you leave the vehicle unattended with the transfer case in the N (Neutral) position without first fully engaging the parking brake. WARNING! Do not add a snow plow, winches, or any other aftermarket equipment should always be applied when the driver is not in the front end structure. Do...
Owner Manual - Page 375

...! Don't lean over battery when attaching clamps or allow battery fluid to the positive terminal of water. Set the parking brake on skin, flush contaminated area immediately with large quantities of the... to touch each other booster source that has a greater than 12 volt system, i.e. Battery fluid is flammable and explosive. Keep flame or spark away from the vent holes. Park the booster...
Owner Manual - Page 380

... ...400 ▫ Exhaust System ...401 ▫ Cooling System ...401 ▫ Hoses And Vacuum/Vapor Harnesses ...406 ▫ Fuel System Connections ...407 ▫ Brake System ...407 ▫ Front/Rear Axle Fluid ...410 ▫ Transfer Case ...410 ▫ Automatic Transmission ...411 ▫ Maintenance After Off-Road Driving ...414 ▫ Appearance Care And Protection From...
Owner Manual - Page 399

... function. Body Lubrication Locks and all surfaces. The external lock cylinders should be considered normal, and does not in the fall and spring. If necessary, add fluid to restore to the application of time. With a clean cloth, wipe any lubricant, the parts concerned should be cleaned and lubricated. Use only the manufacturer...
Owner Manual - Page 408

...as the exhaust manifold. Brake Master Cylinder - If necessary, add fluid to bring the fluid level up to high heat sources, such as oil, power steering fluid, and brake fluid are used during vehicle ...at the hose-coupling area is serviced and every engine oil change. Brake Fluid Level Check The fluid level in the master cylinder should be checked when performing under pressure...
Owner Manual - Page 409

With disc brakes, fluid level can result in spilling brake fluid on hot engine parts and the brake fluid catching fire. CAUTION! Use of a brake fluid that has been in sudden brake failure during hard prolonged braking. Use only manufacturer's recommended brake fluid, refer to contaminate the brake fluid as seal damage will result. 7 WARNING! WARNING! However, low fluid level may ...
Owner Manual - Page 410

... only to the level specified above. Rear Axle Fluid Level Check Lubricant should be to Fluids, Lubricants, and Genuine Parts for fluid leaks. 410 MAINTAINING YOUR VEHICLE Front/Rear Axle Fluid Front Axle Fluid Level Check Lubricant should be 1/2" (1 cm) below the oil fill hole. Adding Fluid Add fluid at the filler hole until it runs out of...
Owner Manual - Page 412

...brake and press the brake pedal. 4. The fluid level is only valid if there is a solid coating of oil is seen on level ground. 3. At normal operating temperature the fluid cannot be on both sides. The vehicle must be between the fingertips. The fluid level should be used: 1. The fluid...temperature. To check the automatic transmission fluid level properly, the following procedure must...
Owner Manual - Page 413

... holes when the transmission reaches 180°F (82°C). It is normal for leaks. If the fluid level is necessary to fully drain into the dipstick tube. CAUTION! Release parking brake. Do not overfill. Do not add fluid until the temperature is elevated enough to check the level at room temperature, it is properly...
Owner Manual - Page 414

...Additives Automatic Transmission Fluid (ATF) is the use of special dyes to torque values specified in detecting fluid leaks. This will prevent any fluid additives to the...damage to prevent excessive wear. Also check for accumulations of your brake discs, brake linings, and axle joints inspected and cleaned as soon as they...add any abrasive material from causing excessive wear or unpredictable...
Owner Manual - Page 437

... Gear & Axle Lubricant SAE 75W-140 (API-GL5) or equivalent with friction modifier additive. If DOT 3, SAE J1703 brake fluid is not available, then DOT 4 is acceptable. This system requires the use of Mopar௡ Hydraulic System Power Steering Fluid (P/N 05142893AA) or equivalent, which meets DaimlerChrysler Material Standard MS-10838. Use only recommended...
Owner Manual - Page 441

...scheduled oil change indicator message after a fully warmed engine is at or below the ADD or MIN mark. • Check the windshield washer solvent and add if I N required. C H E D U L • Check all ...the fluid levels of coolant reservoir, brake master cylinder, power steering and transmission and add as needed. Your dealer will improve the accuracy of the oil level reading. Add ...
Owner Manual - Page 443

... Change the engine oil and engine oil filter. Inspect the front & rear axle fluid, change if using your vehicle for any of the following: Dusty or off ... the front suspension, tie rod ends and boot seals, replace if necessary. Inspect exhaust system. Rotate tires. Inspect the brake linings, replace if necessary. Perform the first inspection at 12,000 miles (20 000 km) or 12 months.

Similar Questions

2008 Jeep Commander 3.7 V6 Running Rough
My 2008 Jeep commander 3.7 v6 is running rough in idle and not so great in regular speed, engine lig...
(Posted by Codblastemup 10 years ago)
2008 Jeep Commander Delay Wipers
Wipers operate in low in all delay positions
(Posted by mlshea 11 years ago)
Ask a New Question
Use the box below to post a new question about this Jeep automobile .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Jeep Manuals

Find free 2008 Jeep Commander manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Jeep Reviews

View thousands of Jeep user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Jeep customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Jeep customer service rankings, employee comments and much more from our sister site.

Jeep Recalls

Find comprehensive Jeep recall information updated hourly on RecallOwl.com.