JVC FS-V30 Support Question

Find answers below for this question about JVC FS-V30.
Need a JVC FS-V30 manual? We have 1 online manual for this item!

JVC Overview Questions Manuals Reviews Videos Research

Question posted by marcellinidaniel08 on June 19th, 2021

Fm Antenna Where To Get A Replacement?

I bought a jvc fs-v30 home stereo from someone. It sounds great but I never found an fm antenna so I can receive fm signals. Anyone know where I can get one?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by hzplj9 on June 19th, 2021 12:10 PM

This answer was accepted by the poster of the original question.

hzplj9

Member since:
June 25th, 2012

Points: 4,875,670

1,100
points

Page 3 of the user guide available here:

https://www.manualslib.com/manual/83780/Jvc-Fs-V30.html?keyword=

explains how to attach an FM aerial. It needs to be an outside aerial connected via a coaxial connector. There is an alternative to this by buying an FM dipole type cable but this would need an adapter to fit the socket. Depending on how near to an FM transmitter you are, you may get away with a single wire of about 2 metres long connected to the centre of the connector and receive a signal although it is not an acceptable solution.

Hope that helps.

Answer #2: Posted by SonuKumar on June 19th, 2021 11:02 PM

SonuKumar

Member since:
May 9th, 2021

Points: 16,652,140

100
points

https://www.manualslib.com/manual/83780/Jvc-Fs-V30.html?keyword=

https://www.amazon.in/FM-Radio-Antenna-Mile-Range/dp/B000VB5MU6

How do I fix my FM antenna?

Try outdoor antennas.

Make sure it is outdoors, roof mounted, or in the attic.

Most roof antennas will give you radio reception similar to a car radio, or often better.

Try repurposing a TV antenna you already have; use an FM splitter to use it on your radio. ...

Consider an omnidirectional radio antenna.

Why?

How can you make a simple antenna improve the reception of an FM receiver?

How to Make a Simple Antenna to Improve the Reception of an FM Radio Receiver

Measure 28-3/4 inches from one end of your wire. Wrap several turns of electrical tape at that point. ...

Split the wire from the end to the tape. ...

Attach each exposed end to one of two screw terminals on your receiver marked for the FM antenna.

How can I make an FM antenna booster?

How to Build a Simple FM Booster

Wind the metal wire into a wreath. ...

Connect one end of the alligator clip wire to an end of the wreathed wire. ...

Place the wire wreath on or near your radio's antenna.

Attach the other end of the alligator clip wire to your radio's antenna.

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Related JVC FS-V30 Manual Pages

Instructions - Page 1

... TAPE TUNER CD BAND VOLUME AUTO TAPE SELECTOR AUTO REVERSE TAPE COMPACT DIGITAL AUDIO VERTICAL DISC LOADING MECHANISM COMPACT COMPONENT SYSTEM FS-V30 STANDBY/ON POWER MD/ AUX REC REV. MODE PHONES TAPE DOWN FM/AM CD MULTI CONTROL UP AHB PRO TIMER VOLUME CLOCK CD OPEN/CLOSE INSTRUCTIONS MANUEL D'INSTRUCTIONS For Customer Use...

Instructions - Page 2

... accordance with the limits for help. Increase the separation between the equipment and receiver. PRODUIT LASER CLASSE 1 2. For U.S.A. Connect the equipment into an outlet on... may cause harmful interference to the presence of the following measures: Reorient or relocate the receiving antenna. Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de...

Instructions - Page 4

... liquids are not likely to qualified service personnel. For example, this appliance should be sure the antenna system is illustrated in the operating instructions. The precautions that described in here. If this appliance. 7) Polarization - EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE GROUND CLAMP ELECTRIC SERVICE EQUIPMENT NEC - Instructions for safe use...

Instructions - Page 5

...illuminations on the System and automatically start the Radio, Cassette deck or CD Player with wet hands! • Some power is connected to faithfully reproduce low frequency sounds. s You... for purchasing the JVC Compact Component System. Table of the things that make them very easy to use the system. If you have been designed to make your new stereo system. s Timer functions...

Instructions - Page 6

... Power Cord (1) AM Loop Antenna (1) Remote Control (1) Batteries (2) FM Wire Antenna (1) If any of the following items, which are missing, contact your dealer immediately. R6(SUM-3)/AA(15F) CAUTION: Handle batteries properly. AUTO TAPE SELECTOR AUTO REVERSE TAPE Remote sensor COMPACT DIGITAL AUDIO VERTICAL DISC LOADING MECHANISM FS-V30 COMPACT COMPONENT SYSTEM STANDBY/ON POWER MD...

Instructions - Page 7

... IN If reception is poor, connect the outdoor antenna. ANTENNA AM EXT AM LOOP FM (75Ω) COAXIAL CAUTION: To avoid noise, keep antennas away from the System, the connecting cord and the AC power Turn the loop until you have the best reception. Connecting the FM Antenna Rear Panel of the Unit Coaxial cable Note: Before...

Instructions - Page 9

...Unit CD #/8 button FM/AM button TAPE @ # button MD/AUX button On the Remote Control CD #8 button TUNER BAND button TAPE @ # button MD/AUX button AUTOMATIC POWER ON The System automatically turns on and...System, the CD cover will automatically close if it is open. AC IN AC power cord CAUTIONS: • ONLY USE JVC POWER CORD PROVIDED WITH THIS SYSTEM TO AVOID MALFUNCTION OR DAMAGE TO THE SYSTEM....

Instructions - Page 10

... REMOTE CONTROL RM-RXFSV5 DIMMER SLEEP POWER DISPLAY FM MODE MD/AUX AUTO AHB PRO PRESET CD ...sound could damage your hearing, speakers and/or headphones when you cannot adjust the volume level while the Unit is turned off (called Standby Mode). Be sure to another source. If you wish, you were listening to the Tuner last, the Tuner comes on headphones. 6 Turning the System off the System...

Instructions - Page 11

... up on the Remote Control to adjust the treble level. The BASS indicator goes out. When the System is turned on, you need to set the clock beforehand. (See "Setting the Clock" on page.... 2 Press the UP or DOWN button on the display. English Reinforcing the Bass Sound (AHB PRO) You can reinforce the bass sound to the previous mode, press the same button again. To cancel the effect, press...

Instructions - Page 12

...3 Press the SET button. s Before listening to the radio: • Make sure that both the FM and AM antennas are shown here. After 1 second the display will flash for one set to factory test frequencies prior ... CLOCK CD OPEN/CLOSE FM/AM ¢ 4 MONO STEREO FM mode indicators When the System is in use, the display shows other sound source to the radio by pressing the FM/AM button on the ...

Instructions - Page 13

...again. Reception improves, but you can automatically preset 30 FM and 15 AM stations. CAUTION: Even if the system is unplugged or if a power failure occurs, the preset... FM stereo broadcast is held down, the preset number changes rapidly. 5 Press the SET button within 5 seconds to receive or noisy, you can select Monaural mode. FM MODE STEREO MONO To restore the stereo effect, press the FM ...

Instructions - Page 14

...; When you can place an 8 cm (3 in this section are the basic things you need to know to another source. Be careful not to close the CD cover. • To close the CD cover... CD 0 REPEAT CANCEL UP > DOWN CD #8 ¢ 7 COMPACT COMPONENT SYSTEM FS-V30 STANDBY/ON POWER MD/ AUX REC REV MODE PHONES TAPE DOWN FM/AM CD MULTI CONTROL UP AHB PRO TIMER VOLUME CLOCK CD OPEN/CLOSE CD OPEN...

Instructions - Page 15

... CD Player is held down, the track number changes rapidly. 6 Press the SET button. The System enters the programing mode and the PROGRAM indicator lights up to program the 21st track, "FULL" appears... Insert a CD. 2 Press the CD #/8 button. 3 Press the 7 button to 7. 11 The System plays the tracks in the track you have programed them. To confirm the programed tracks while the CD player...

Instructions - Page 17

.... MODE ¢ 7 4 STANDBY/ON POWER MD/ AUX REC REV MODE PHONES TAPE DOWN FM/AM CD MULTI CONTROL UP AHB PRO TIMER VOLUME CLOCK CD OPEN/CLOSE TAPE @ # ¢...Tape Direction indicator Reverse Mode indicator AUTO TAPE SELECTOR AUTO REVERSE TAPE Cassette holder TAPE 0 When the System is pressed. : The Cassette Deck automatically stops after playing one side of a tape, both ...

Instructions - Page 18

...Tape Direction indicator is not affected by adjusting the sound effects. Things to know before you want to record onto both sides of...sound source to record. MODE TAPE @ # 7 CD #8 STANDBY/ON POWER MD/ AUX REC REV MODE PHONES TAPE DOWN FM/AM CD MULTI CONTROL UP AHB PRO TIMER VOLUME CLOCK CD OPEN/CLOSE CD #/8 Tape Direction indicator REC indicator REC When the System...

Instructions - Page 20

... mode, select another source. It is not affected by any sound effect, either. s First make sure that the external equipment is properly connected to the System. (See page 4.) 1 Set the VOLUME control to external ... MD/AUX TREBLE MD/AUX STANDBY/ON POWER MD/ AUX REC REV MODE PHONES TAPE DOWN FM/AM CD MULTI CONTROL UP AHB PRO TIMER VOLUME CLOCK CD OPEN/CLOSE AHB PRO VOLUME +,...

Instructions - Page 21

... be repeated from the beginning. • The clock must be correctly set the clock whether the System is unplugged, or a power failure occurs, the timer setting will be activated. The CLOCK indicator ...moves it backwards. English Using the Timers SLEEP REMOTE CONTROL RM-RXFSV5 DIMMER SLEEP POWER DISPLAY FM MODE MD/AUX AUTO AHB PRO PRESET CD PROGRAM RANDOM REPEAT BASS TREBLE CANCEL UP SET ...

Instructions - Page 25

... sound is upside down. Unable to record. The built-in . • Remove the obstruction. • Replace the batteries. 21 Clean or replace the CD. Operations are disconnected. • The AM Loop Antenna is too close . Plug the AC power cord. Cover the holes on the Unit is not properly extended and positioned. Unplug the System...

Instructions - Page 26

... Power Consumption AC 120 V , 60 Hz 50 W (power on mode) 3.7 W (in . English Specifications FS-V30 (CA-FSV30 and SP-UXV30) Amplifier Output Power Input Sensitivity/Impedance (1 kHz) LINE IN (AUX) Output Sensitivity/Impedance... kHz 50 Hz - 15 kHz 0.15% (WRMS) CD Player Signal-To-Noise Ratio 90 dB Wow And Flutter Immeasurable Tuner FM Tuner Tuning Range AM Tuner Tuning Range 87.5 MHz - 108.0 ...

Instructions - Page 50

... in shipment, due to act of the cabinet. Signal reception problems and failures due to be defective, JVC will be rendered by JVC during normal business hours at no express warranties except...to state. For your JVC Product, please contact our Customer Relations Department. Products which will repair or replace defective parts at JVC authorized service centers. JVC SHALL NOT BE LIABLE ...

JVC Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

FAQ - Televisions/HD-ILA Projection
...can I replace the lamp? In that your remote control is working there is no need for example. To get sound, either ...page). Where is possible. If your source to send out only stereo signal or connect analog RCA cables to be found on the screen if... and the surrounding walls/enclosures. When using an antenna. Space is normal. With JVC receivers in phenomenon? I use . I test my ...
FAQ - Televisions/LCD
... instructions to HDMI cable. To avoid this date only analog (NTSC) over the air antenna signals while QAM is no video appears and the power LED at the lower left Blue Power LED ...there may have black bars on JVC TV remote. Only the blue power LED will still receive channels as cable/satellite companies decides what channels can be used by pressing and holding those...
FAQ - Televisions/HD-ILA Projection
... any requirements in 2009? My TV has no sound even with a camera (cell phone or video ... that your source to send out only stereo signal or connect analog RCA cables to cool... using an antenna. Where can be an image burn in but when viewing it receive TV signals after transition to... is recommended to make sure that can I replace the lamp? LT37XM48 LT42XM48 HD58S998 HD65S998 The above...