Invacare M51P Support Question
Find answers below for this question about Invacare M51P.Need a Invacare M51P manual? We have 1 online manual for this item!
Question posted by vseal47 on September 21st, 2013
Pronto M51 Troubleshooting
If the chair will only go forward and backward, but will not turn, what could be wrong with it?
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Invacare M51P Manual Pages
Owners Manual - Page 3
Backward ...22 SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING 23 Safety Inspection Checklists...23 Troubleshooting Guide ...25 Checking Battery Charge Level...28 SECTION 5-WHEELCHAIR OPERATION 29 Operating the Wheelchair... the Seat Positioning Strap ...43
Part No 1125085
3
Pronto® M51™and M61™with SureStep® Forward 21 Reaching and Bending - TABLE OF CONTENTS
TABLE OF...
Owners Manual - Page 6
... healthcare provider before attempting active use on sloped surfaces. Pronto® M51™and M61™with optimum traction and stability when driving forward over transitions and thresholds of corrosion (water exposure, incontinence, etc.). Wheelchairs that provides the chair with SureStep®
6
Part No 1125085 Wheelchairs should be examined during maintenance for signs of up...
Owners Manual - Page 9
...:
BATTERIES:
WEIGHT LIMITATION:
107 lbs 154 lbs 40 lbs 64 lbs 44 lbs 48 lbs
Adjustable Width, Angle, Heights and Depth
U1 - Part No 1125085
9
Pronto® M51™and M61™with the battery discharge indicator on page 67 for this product.
Owners Manual - Page 10
..., incontinence, etc.). Incorrect settings could cause injury to the driver, bystanders, damage to the chair and to the equipment could occur if improperly set ‐up of the healthcare field or ...
Pronto® M51™and M61™with this warning can cause the wheelchair to tip over and may tip over . After the wheelchair has been set ‐up , check to make sharp turns in...
Owners Manual - Page 11
... over and cause bodily harm or damage to the chair.
When determining the depth of moving parts to the wheelchair. Otherwise damage to property may result.
DO NOT ...wheelchair, make sure the rear of the tube before operating the wheelchair. DO NOT attempt to turn over curbs or obstacles. Part No 1125085
11
Pronto® M51™and M61™with the movement of the wheelchair...
Owners Manual - Page 13
... cracked, replace immediately. Part No 1125085
13
Pronto® M51™and M61™with or for Invacare products.
DO NOT use the wheelchair if the joystick boot is void. Some devices...to excessive rain or dampness may cause the chair to malfunction electrically and mechanically, may cause the chair to remove his /her power wheelchair from any plug used with SureStep® Weight...
Owners Manual - Page 16
... the following pages have been used successfully by many. Pronto® M51™and M61™with "safety" as you must at all times maintain proper balance. Use this may encounter, however all . Individual wheelchair users often develop skills to accommodate one individual occupies the wheelchair this information only as the assistant. Stability and...
Owners Manual - Page 17
... positions will be used in. Part No 1125085
17
Pronto® M51™and M61™with caution.
Continue forward and then turn around the home, the provider should determine whether this information, refer to FIGURE 3.1. To determine and establish your center of the wheelchair. While the wheelchair is suitable for your safety. When reaching, leaning...
Owners Manual - Page 20
... To and From Other Seats
ƽ WARNING
ALWAYS turn the wheelchair power Off and engage the Motor Release Levers to reduce...No 1125085 Ensure that were removed in or out of the wheelchair tipping forward. Reinstall the seat.
Rear Frame
Front Fork (Front Edge...back as hand hold supports, transfer the wheelchair base to transport it. 1. Pronto® M51™and M61™with the object...
Owners Manual - Page 21
... away from the floor by reaching down between your knees. Minimum Gap Distance
1.
FIGURE 3.6 Reaching, Leaning and Bending -
SECTION 3-SAFETY/HANDLING OF WHEELCHAIRS
NOTE: This activity may be beneath you.
Forward
Part No 1125085
21
Pronto® M51™and M61™with transfer.
Refer to Engaging/Disengaging Motor Release Lever on side of...
Owners Manual - Page 23
...if wheel wobbles noticeably or binds to wheelchair frame. ❑ Ensure seat release latch is spun. SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING
SECTION 4-SAFETY INSPECTION/ TROUBLESHOOTING
NOTE: Every six months or as necessary...and servicing. To operate properly and safely, your wheelchair. Part No 1125085
23
Pronto® M51™and M61™with any other vehicle. Regular cleaning ...
Owners Manual - Page 24
.... ❑ Ensure seat and/or back upholstery have no rips and do not sag. Pronto® M51™and M61™with SureStep®
24
Part No 1125085 Replace if necessary. ❑...seat release latch is functional.
SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING
Inspect/Adjust Weekly ❑ Seat is secured to wheelchair frame. ❑ Seat and/or back upholstery have no rips and ...
Owners Manual - Page 25
...❑ Make sure elevate systems drive with reduced speed when seat is in elevated position. Troubleshooting Guide
NOTE: For additional troubleshooting information and explanation of charge time between use. PROBABLE CAUSE
Batteries not charged long enough.
.... Replace batteries. Contact Dealer/Invacare. Part No 1125085
25
Pronto® M51™and M61™with each wheelchair.
Owners Manual - Page 26
.../TROUBLESHOOTING
SYMPTOM
Wheelchair ...on.
Only one drive wheel turns.
One motor lock is correct.
Engage motor lock. When a fault is detected, the wheelchair may flash in .
Batteries require... will not drive.
Reprogram controller (Refer to commands. Pronto® M51™and M61™with wheelchair). SOLUTIONS
Engage motor release levers. Reset circuit breaker....
Owners Manual - Page 28
... this manual when selecting a battery or charger.
Pronto® M51™and M61™with tools. Spread clamps wider if necessary.
Don't make it a habit to discharge batteries to Elevating the Seat on the terminals.
SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING
Additional Troubleshooting Information for M61 Wheelchairs
SYMPTOM
Wheelchair slows or stops while driving and the...
Owners Manual - Page 30
... On. Refer to start and stop . Maneuver the joystick in the speedometer will light. Turn LEFT
Move joystick toward the right side of the wheelchair. To Move Left
To Move Forward
To Move Backward
Front of Wheelchair
To Move Right
Rear of the wheelchair.
Perform one of the following :
1.
ii. This exercise will help you to...
Owners Manual - Page 32
... the Seat
Lower the Seat
FIGURE 5.5 Elevating the Seat
Pronto® M51™and M61™with a circle around it. 3. NOTE: This procedure applies to elevate mode. SECTION 5-WHEELCHAIR OPERATION
NOTE: For this procedure, refer to FIGURE 5.5 on a level surface. 2. Move the joystick:
• Forward ‐ Elevates the seat. • Backward ‐ Lowers the seat.
Owners Manual - Page 45
... Off position. If the user's feet are allowed to rest off the side of the wheelchair, make sure that all attaching hardware is in injury. SECTION 8-FOOTBOARD ASSEMBLY
SECTION 8-FOOTBOARD ...switch on the footboard while operating the chair. otherwise injury or damage may occur when rotating the footboard assembly.
Part No 1125085
45
Pronto® M51™and M61™with the ...
Owners Manual - Page 51
...Refer to achieve the desired depth as shown in FIGURE 9.6.
• Replacing ‐
i.
Part No 1125085
51
Pronto® M51™and M61™with the caster wheel rotation. Perform one of the following :
• Raising ‐ Pull...Align the appropriate mounting hole of the chair facing away from the wheelchair frame in the seat frame tubes to 2 inches from the seat frame.
1.
Owners Manual - Page 53
...of the wheelchair when locked in FIGURE 9.7. Insert the new telescoping front rigging support into the seat frame. Part No 1125085
53
Pronto® M51™...wheelchair frame.
iii. NOTE: The footplate will be extended up to the seat frame as shown in FIGURE 9.7.
• Replacing ‐
i. Remove the two socket bolts and locknuts that the hinge pins are on the inside of the chair...
Similar Questions
Where Can I Order The Key Pad For Pronto M61 Wheelchair. Thx
(Posted by sla52 2 years ago)
M51 9 Flashes On Wrench Icon
I have a m51 that has sat for many years and is now i need again i originally figured it would need ...
I have a m51 that has sat for many years and is now i need again i originally figured it would need ...
(Posted by Thejordans 6 years ago)
What Does It Mean When Chair Blinks 1 Red Light And 4 Green Lights On Joy Stick
chair has stopped working
chair has stopped working
(Posted by jonesgloria3 8 years ago)
My M94 Won't Turn On
I have a pronto sure step m94 and the joystick will not turn on or display led lights but in the bac...
I have a pronto sure step m94 and the joystick will not turn on or display led lights but in the bac...
(Posted by jeffcraig425 9 years ago)