2006 Infiniti QX56 Support Question
2006 Infiniti QX56 Support Question
Find answers below for this question about 2006 Infiniti QX56.Need a 2006 Infiniti QX56 manual? We have 1 online manual for this item!
Question posted by Vroddy11 on December 16th, 2015
When Put In Reverse Takes A While To Move Engine Revs Then It Will Move
engine revs before moving in reve
Current Answers
Answer #1: Posted by kcmjr on December 17th, 2015 12:36 AM
kcmjr
Member since:
May 5th, 2011 Points: 4,254,255
Member since:
May 5th, 2011 Points: 4,254,255
Verify that the transmission fluid is filled to the proper level. There could be a number of causes but it will take a mechanic to validate them.
- There may be a vacuum leak
- The torque converter may be failing
- The transmission may need to be removed and serviced
- The fluid may be low (a very likely cause)
Licenses & Certifications: Microsoft, Cisco, VMware, Novell, FCC RF & Amateur Radio licensed.
Related Manual Pages
Owner's Manual - Page 19
... the switch. ● Do not operate the power seat switch for automatic drive positioner operation. This will move your body forward.
The reclining feature allows adjustment of the seatback for occupants of time when the engine is obtained. Safety-Seats, seat belts and supplemental restraint system 1-3 The seatback will discharge the battery...
Owner's Manual - Page 95
... temperature is over the normal range, stop the vehicle as soon as safely possible. CAUTION
When engine speed approaches the red zone, shift to decrease temperature. See "If your vehicle overheats" in the illustration.
Do not rev engine into the red zone 1 . Instruments and controls 2-5 CAUTION
If the gauge indicates coolant temperature near...
Owner's Manual - Page 96
... is high, the engine oil pressure is The located on . indicates that the fuel-filler door is also high. The gauge may come on the driver's side of fuel, malfunction indicator light the (MIL) may move slightly during braking, turning, acceleration, or going up or down hills. When it -yourself" section.)
2-6 Instruments...
Owner's Manual - Page 110
... the vehicle dynamic control off switch again or restart the engine and the system will turn off after about 2 seconds ...dynamic control system checked by an INFINITI dealer. Remove the key and take it makes a high pitched scraping sound when the vehicle is in ... shifting from one drive mode to the ON position.
You cannot move the transfer 4WD shift switch between 4H and 4LO, stop the ...
Owner's Manual - Page 214
... received, including interference that may adversely affect the engine control system and other than replacement close distances to... of cellular telephones while driving. ● If you to take notes, pull off the road to touch the battery terminal....When installing a CB, ham radio or car phone in a moving vehicle requires you must accept any reason other electronic parts. CAR...
Owner's Manual - Page 215
... so full attention may be given to vehicle operation. ● If a conversation in a moving vehicle requires you to take notes, pull off the road to a safe location and stop your vehicle in a safe ...ground wire from the electronic control system harnesses. WARNING
● Use a phone after starting the engine. Do not route the antenna wire next to any harness. ● Adjust the antenna standing-...
Owner's Manual - Page 236
... of a steep hill, never attempt to you or your engine stalls or you may roll over. ● Do not ...or backward.
5-6 Starting and driving If you and your passengers in R (Reverse) gear and apply brakes to control your speed. ● Heavy braking going... of the tires, even with your hands. Your vehicle could move suddenly and injure your fingers and thumbs on downhill grades as this...
Owner's Manual - Page 241
...do not hold the vehicle by warranty. Allow the engine to cool and return to R (Reverse), or L (Low). Failure to the engine almost immediately. CAUTION
● When stopping the vehicle ...depressing the accelerator pedal. Such damage is electronically controlled to move the shift selector lever into a forward or reverse gear before attempting to produce maximum power and smooth operation....
Owner's Manual - Page 242
..., then the key can be turned to LOCK.
R (Reverse):
CAUTION
Use this position for driving up . Do not downshift into the P (Park) position. P (Park): Use this selector position when the vehicle is parked or when starting the engine, fully depress the brake pedal and move the selector lever from P (Park), N (Neutral) or any...
Owner's Manual - Page 265
... or avoidance device. WARNING
The Brake Assist is only an aid to take: If the warning light comes on , it applies the brake prepressure before...engine, resume driving and then perform the setting again. Automatic cancellation
A buzzer sounds under normal conditions, have the vehicle checked at approximately 20 MPH (32 km/h) or less. Starting and driving 5-35 Although the vehicle is moving...
Owner's Manual - Page 267
... or install an accessory near the sensor. Turn the engine off, restart the engine and resume driving. Do not touch or disassemble the screw...; When the Preview Function operates, the brake pedal may move slightly and may indicate that the Preview Function is malfunctioning ...not a system malfunction. LSD0125
hicle is operative).
Action to take If the warning light comes on, park the vehicle in...
Owner's Manual - Page 270
...the N position. Otherwise gears may blink. indicator light will indicate transfer shift position engaged. Move the automatic transmission selector lever to 4LO or 4H with the brake pedal depressed. The ...be ON and the vehicle's engine must be on when 4LO is required (for a while. Otherwise, the shift will not take place and for a shift to take place and no indicator lights will...
Owner's Manual - Page 271
...four types of 4LO. Speeds over 62.5 MPH (100 km/h) in the P position. Use the engine brake and low automatic transmission gears (D1 or D2) for a while you can change the 4WD ... ● The 4H position provides greater traction. INFINITI recommends driving in to move the 4WD shift switch when making a turn or reversing. ● Do not shift the 4WD shift switch (between each mode, 2WD...
Owner's Manual - Page 272
...engine braking. ● Do not operate the 4WD shift switch with the engine running at high speeds as this may cause malfunction. Tires will sink deep into the mud, making a turn or reversing...AUTO position, distribution of a malfunction. CAUTION
● Do not spin the tires excessively. Do not move the 4WD shift switch when making a turn, accelerating or decelerating or if the key switch is ...
Owner's Manual - Page 273
... Be especially careful when starting or driving on slippery surfaces with the 4WD shift switch set in reverse, then shift the 4WD shift switch. ● If the 4WD warning light comes on , ...display. While the engine is turned to the AUTO position at low ambient temperatures, the 2WD mode may show 4H. drive the vehicle straight, accelerate or decelerate or move the vehicle in AUTO...
Owner's Manual - Page 277
...you start the engine and move the vehicle at a low speed in forward or reverse. The brake... system then operates normally, but it down. Starting and driving 5-47 It can be performed by noise usually occurs while the ABS system is operating.
Such vibration and noise encountered during the self-test or while driving, take...
Owner's Manual - Page 278
...) system is canceled. The computer has a built in the brake pedal. When accelerating or driving on in reverse at a slow speed. See "Slip indicator light", and "Vehicle dynamic control (VDC) off . When the...normal and is working properly. When the self-test occurs, you start the engine and move the vehicle forward or in the instrument panel. - If the 4WD transfer case is operating, you...
Owner's Manual - Page 280
... The RSS detects obstacles up to the obstacle, the rate of the RSS.
As you move closer to 6 feet (1.8 m) from snow, ice and large accumulations of obstacles near the...may not detect objects at the outer corners of this manual. For details, see ''Engine cooling system'' in R (Reverse). Once the system detects an object approaching, the tone will not detect small objects below...
Owner's Manual - Page 292
... is coming out. PUSH STARTING
IF YOUR VEHICLE OVERHEATS
3. Get out of emergency If your vehicle is coming from the engine, stand clear to P (Park). take the following steps. 1. Open all the windows, move the shift lever to prevent getting burned. 5. WARNING
Be careful not to come into contact with, or get caught...
Owner's Manual - Page 307
.... ● Always wear eye protection whenever you work on your vehicle, always take care to prevent serious accidental injury to yourself or damage to work with safety stands. ● Keep smoking materials, flame and sparks away from moving. Turn the engine off . This "Maintenance and do -it -yourself" section gives instructions regarding only...
Similar Questions
What Is The Pest Engine Oil To Use For 06 Infiniti Qx56
(Posted by dungsAbi 9 years ago)
What Type Of Motor Oil Does A 2006 Infiniti Qx56 Take
(Posted by supengs 10 years ago)
