Image Fitness Renew 716 Support Question
Image Fitness Renew 716 Support Question
Find answers below for this question about Image Fitness Renew 716.Need a Image Fitness Renew 716 manual? We have 1 online manual for this item!
Question posted by Barrysutton9373 on May 4th, 2021
Spa Console Oh Flashing
What do I need to get the spa to come onit is flashing O
Current Answers
Answer #1: Posted by Odin on May 4th, 2021 12:17 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See https://www.manualslib.com/manual/582954/Image-Renew-716.html?page=16#manual. Of these SYMPTOMs, consider first number 6.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/image%20fitness/customer-service.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/image%20fitness/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Image Fitness Renew 716 Manual Pages
User Manual - Page 1
.... CUSTOMER HOT LINE:
1-877-897-7493
Mon.-Fri., 8 a.m.-5 p.m. Model No. Access Panel
QUESTIONS? USER'S MANUAL
Visit our website at www.workoutwarehouse.com
new products, prizes, fitness tips, and much more! The technicians on a sign behind the access panel. Save this equipment. The serial number is on our customer hot line will...
User Manual - Page 2
... described above. IMAGE is moved, the sign must be posted on a wall or fence where it will be moved and reposted near the spa. Whenever the spa is a registered trademark of ICON Health & Fitness, Inc.
2 Table of Contents
Posting the Warning Sign 2 Important Safety Instructions 3 Before You Begin 6 Choosing a Location for the Hydrotherapy...
User Manual - Page 3
...spa is missing or broken. The spa should shut off. If the spa continues to do so may have been in the water;
The hydrotherapy spa is intended for the spa will weigh approximately 3,300 pounds when it is damaged. If you need to the hydrotherapy spa... a suction fitting or pump, make sure you select for home use the spa on a level surface. The surface of the spa shell can cause...
User Manual - Page 4
... drowning. failure to recognize the need to swim under the influence of the spa.
22. fetal damage in danger of drowning: • Never use the hydrotherapy spa alone. • Children should ... increase the risk of drowning: Exercise extreme caution to prevent unauthorized and unsupervised use the hydrotherapy spa if you plan to exit the spa or hot tub and unconsciousness resulting...
User Manual - Page 5
... exposure of a localized area of this product. The included warning sign must be posted where all instructions before using the hydrotherapy spa.
WARNING: The spa jets produce a stream of the hydrotherapy spa can see and read it. (See POSTING THE WARNING SIGN on the decals. WARNING DECAL PLACEMENT: Locate the decals shown below...
User Manual - Page 6
..., which is IMSB71620 or IMSG71620. Hydrotherapy is a proven method for selecting the new IMAGE® RENEW 716 hydrotherapy spa.
Central Time (excluding holidays). For your best. The innovative RENEW 716 allows you , please mention the product model number and serial number when calling. Air Controls
Console
Jets
Jets
Spa Shell
Jet Filter
Access Panel
Locking Buckle
6
Panel
User Manual - Page 7
... pounds when it is filled with water, plus the weight of the spa are 84" W x 84" L x 36" H. Be sure to set up the hydrotherapy spa inside or outside :
1. The spa is room around the spa to set up the spa. You may need to permit servicing of carrying 30 amps. Check local building codes concerning the...
User Manual - Page 8
...the drawings.
• Read each assembly step before you assemble them, unless instructed to the spa. Close the valve knob on the heater). Make sure that the gate valves are oriented ...begin.
• Tighten all parts in a cleared area and remove the packing materials from the spa shell. Assembly
Before beginning assembly, carefully read and understand the information in the inset drawing. ...
User Manual - Page 9
... easily service it is filled, it will be easily serviced, if needed.
5. Do not place the Buckle over the grooves between the high or low positions.
3
47
4.
Remove the Spa Cover (11) from the spa.
3
Fill to the inset drawing. 3. The hydrotherapy spa operates on the opposite side of the electronics package for use...
User Manual - Page 10
... use the spa, you are available at about connecting the spa to operate with a 240 volt AC power source. SECURING THE SPA COVER ON THE SPA
To secure the spa cover,
snap the latches on the
spa cover into a grounded circuit with the controls on the console (see SECURING THE SPA COVER ON THE SPA on the spa by a qualified...
User Manual - Page 11
...the jet, turn the rim counterclockwise;
Never operate the spa without the suction covers in place over the fittings. Ozone helps sanitize the spa with minimal chemical treatment.
11 Spa Shell Diagram
D
K
D
E
E
M
J ...for the light. to close the jets, turn the jets counterclockwise. The console controls the spa jets, turns the underwater light on and off, and adjusts the water ...
User Manual - Page 12
... 1: Determines the amount of air flowing through the hydrotherapy jets labeled 2 above . Jet Button: Turns the spa jets on and off . If the button is turned clockwise, the amount of air will appear in the....
Note: The word "COOL" will appear in the console display if the temperature of the water is pressed twice, the spa jets will automatically circulate the water and warm the plumbing...
User Manual - Page 13
... the steps below to the level
shown in clean water. • Replace the filter if needed (see CHECK- MAINTENANCE SCHEDULE
Daily • Check the water level and refill the spa to properly maintain your local pool and spa supply store.
phate (TSP) solution. Rinse the filter in step 5 on the
label, unless directed...
User Manual - Page 14
... shell surface and warping of the filter cycle may need to the sun while it with the 4 #10...a measure of chemicals-follow the directions on the console. Also, the sanitation agents in the water, ...spa jet unit. The spa must be effective if the pH level is not covered under warranty.
14 The hydrotherapy spa should use .
6. These high temperatures can be adjusted to last 2 to flash...
User Manual - Page 15
...this page). 3. Using the console, adjust the temperature to the lowest setting. Dry
the spa shell with chemicals
(see DRAINING THE HYDROTHER- Set the air controls to the spa shell. Re-attach the light ... sure the power to the spa is drained, the jet pumps should also be drained if the spa will need to remove the access panel to the spa. Refill the spa and treat the water with towels...
User Manual - Page 16
...to low.
This usually occurs only when the water level is no longer under warranty, contact a local spa and pool service provider.
5. Add water until 5 p.m.
Reset the GFCI breaker.
2. The pump ... Filter Covers are dirty. If you are using the spa indoors and the room temperature is maintained at 70°F, it is needed, call our Customer Service Department toll-free at a ...
User Manual - Page 17
... or replace the damaged seal.
If rapid water loss occurs, or if you can identify the location of the plumbing. Contact your local pool and spa service provider for excess water and watch the pump unit while it is operating to evaporation is running a filter cycle, the heater pump/motor will...
User Manual - Page 18
... 4
29 1
30 1
31 8
32 1
33 3
Description
Thermometer Fitting Jet Pump/Motor Power Cord Filter Cover Rubber Washer Filter Rubber Isolator Blue Light Cover Red Light Cover #10 x 1 1/2" Sheet Metal Screw 2-speed Pump...* Spa Cover Jet Housing Jet Pump/Motor O-ring Heater/Electronics... Console With Overlay Rotator 1/4" Washer Face Plate Assembly Panel
Key No. Part ...
User Manual - Page 20
... of the product (IMSB71620 or IMSG71620)
• The NAME of the product (IMAGE® RENEW 716 hydrotherapy spa)
• The SERIAL NUMBER of the product (see the front cover of this manual)
&#.... Some states do not allow limitations on pages 18 and 19)
Limited Warranty
ICON Health & Fitness, Inc. (ICON), warrants this warranty is authorized by ICON. This warranty gives you , please...
Similar Questions
Image Spa Renew 631
my spa gets a oh reading and shuts down what is the problem?
my spa gets a oh reading and shuts down what is the problem?
(Posted by DNY1 2 years ago)
Oh And An Sn Message On The Control Panel
Water is at ambient air temp. Have reset unti at breaker several times. Pump runs and then stops as ...
Water is at ambient air temp. Have reset unti at breaker several times. Pump runs and then stops as ...
(Posted by jwoell 3 years ago)
Image Renew 631 Filter Cover
Where can i buy a 631 image renew filter cover , I would like a parts manual for my spa.
Where can i buy a 631 image renew filter cover , I would like a parts manual for my spa.
(Posted by Anonymous-139384 9 years ago)
The Console Does Not Come On When Key Is Inserted.
(Posted by Johnlucierjr 10 years ago)
Image Pillow Image Renew 615 Sports & Fitness Equipment Model #imhs61500
I need the pillows for this spa. I want to purchase 6 of them. [email protected]
I need the pillows for this spa. I want to purchase 6 of them. [email protected]
(Posted by inspector0073 10 years ago)