Home » Hyundai » Troubleshooting » 2008 Hyundai Tucson

2008 Hyundai Tucson Support Question

Find answers below for this question about 2008 Hyundai Tucson.
Need a 2008 Hyundai Tucson manual? We have 1 online manual for this item!

Hyundai Overview Questions Manuals Reviews Videos Research

Question posted by andrealajoie on October 28th, 2012

Emmissions Light

I learned that the gas cap was loose, tightened it, but emmissions light is still on. Is there a reset I can do?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 11

...: When installing a container of liquid air freshener inside the vehicle, do not place it may damage these areas, wash them with water immediately. Front Fog Light Switch (If installed) 12. Shift Lever (If installed) 19. Small Article Tray / Ashtray (If installed) 16. Cruise Control Switch (If installed) 17. Heating/Air Conditioning...

Owner's Manual - Page 12

...) Service Reminder Indicator (SRI) Turn Signal Indicator Lights Seat Belt Reminder Light and Chime High Beam Indicator Light Low Oil Pressure Warning Light Parking Brake/Brake Fluid Level Warning Light Charging System Warning Light Tail Gate Open Warning Light Door Ajar Warning Light and Chime (If installed) Low Fuel Level Warning Light F10 * More detailed explanations of these items...

Owner's Manual - Page 13

... ...1-4 Power Windows ...1-11 Seats ...1-12 Seat Belts...1-18 Child Restraint System ...1-25 Supplemental Restraint (AIRBAG) system ...1-33 Instrument Cluster and Indicator Lights ...1-46 Warning and Indicator Lights ...1-48 Multi-Function Light Switch ...1-58 Windshield Wiper/Washer Switch ...1-60 Sunroof ...1-68 Mirror ...1-73 How to use Luggage Room ...1-79 Hood Release ...1-84 Cruise Control...

Owner's Manual - Page 14

... can reduce vehicle performance and damage components of an accident. o Tighten the cap until it clicks, otherwise the " " light will illuminate. However, if your Hyundai. Fuels with a Pump Octane... installed securely to the fuel system and any performance problems that the fuel cap is recommended. 1FEATURES OF YOUR HYUNDAI 2 FUEL RECOMMENDATIONS B010A05A-AAT B010B01A-AAT...

Owner's Manual - Page 16

... to your convenience, provided the ignition switch is opened, the ignition switch will not be dangerous. Before you can be recorded in the vehicle. The light will go off approximately 10 seconds after closing the door or when the ignition switch is stamped on . 1FEATURES OF YOUR HYUNDAI 4 B030B01A-AAT B030C01JM...

Owner's Manual - Page 62

...'s side front door is open simultaneously. Malfunction Indicator Light This light illuminates when there is not functioning properly so that the exhaust gas regulation values are not satisfied. If the ABS SRI... dealer as soon as possible. If both the ABS SRI and Parking Brake/ Brake fluid level warning lights remain "ON" or come on , you that there may be a problem with the fuel level...

Owner's Manual - Page 95

... be sure to light cigarettes around a gas station. Sparks by electrical equipment of an accident. Before refueling, always stop the engine and never smoke or allow sparks and open the fuel filler cap during high ambient temperatures, a slight "pressure sound" may be replaced, only use cellular phones around a gas station. o Tighten the cap until the filling...

Owner's Manual - Page 98

... ticket. Raise or lower the steering wheel to unlock. 2. WARNING: Do not attempt to adjust the steering wheel while driving as this light is opened. After adjustment, securely tighten the lever by pulling it upward. The purpose of this may cause serious injury or death. 1FEATURES OF YOUR HYUNDAI 86 B580C01LZ-AAT...

Owner's Manual - Page 138

If the tape is loose, tighten it by turning one of the hubs with a low height clearance, be sure to hot, warm, or...a tape before putting it may be folded into only front position. If the label is a removable type. If a tape is fully tightened to ensure proper reception. 1 FEATURES OF YOUR HYUNDAI 126 ANTENNA B870D02JM-AAT Roof Antenna ! Your car uses a roof antenna to remove the...

Owner's Manual - Page 144

...when the engine starts. After turning the ignition key to avoid inadvertent motion of the area. The carbon monoxide gas emitted is needed to placing the vehicle in "P" (park) position. 3. C050A01E-1 ! 2 DRIVING YOUR ... the "ON" position, make certain all warning lights and gauges are functioning properly before starting a manual transaxle vehicle. Be sure that the clutch is fully...

Owner's Manual - Page 163

...inflation pressure shown on low beam. Always check tires are properly inflated before driving your lights regularly for further information and tread limits. Worn-out tires can cause poor handling, ... possible and should be used for proper tire pressures and further information. Drive belt: A loose or damaged drive belt may result in loss of poor visibility, it is dangerous. Tires...

Owner's Manual - Page 174

.... In addition, push or pull starting may be sure they are clean and tight. 3. If the light dims or goes out when you operate the starter, the battery is set the shift lever in the ... not start, do not push or pull the car to be sure they are securely tightened. 5. Try to be disconnected or loose. 3. D010F01A-AAT If the engine stalls at a crossroad or crossing If the engine ...

Owner's Manual - Page 175

...explosive. Do not smoke or allow a spark or an open flame in both vehicles. 3. The gas produced by the battery during the jump-start . Next, using the normal starting , wear protective ... discharged battery using the other end of the booster battery. o The gas produced by your battery became discharged (because the lights were left on the illustration. o The battery being used to the ...

Owner's Manual - Page 186

... the wheel nuts on the mounting surface between the wheel and hub, the wheel nuts could come loose and cause the loss of a wheel. Jiggle the tire to avoid possible severe injury. WARNING: ...with their small diameter ends directed inward. Loss of the vehicle. If there is completely seated, then tighten the nuts as much as mud, tar, gravel, etc.) that interferes with the wheel from fitting...

Owner's Manual - Page 187

...pipe over the nut. If the cap is too high, adjust it as soon as shown in the drawing and tighten the wheel nuts. If you have a technician tighten the wheel nuts to the ground ... TO DO IN AN EMERGENCY 3 15 D060I01E-AAT 8. Lower Vehicle and Tighten Nuts After changing wheels, have a tire gauge, remove the valve cap and check the air pressure. Then double-check each nut for tightness. ...

Owner's Manual - Page 205

... engine oil as possible after handling used engine oil in contact with the household trash. Oil pan drain plug tightening torque: 3.5 ~ 4.5 kgf.m (2.7L) 4.0 ~ 4.5 kgf.m (2.0L) 5. Refer to the State of.... Always protect your skin by a funnel. Open the hood and remove the engine oil filler cap. 3. So be placed in with the skin for engine oil capacity. ! This product contains ...

Owner's Manual - Page 213

... a sealed container. This will also damage your braking system. Follow the instructions printed on the reservoir and tighten. Do not overfill. Carefully replace the cap on the container. It can damage the brake system and cause improper operation. Slowly pour the recommended fluid ...your vision if it up to remain open any dirt then unscrew the fluid reservoir cap.

Owner's Manual - Page 214

The reservoir cap must be used. These can damage your eyes. Consult your vehicle's paint if spilled on the fluid reservoir. Use caution when ... it and not removed immediately. Fill as required. HJM5007 WARNING: The clutch fluid level in the master cylinder should be fully tightened to avoid bending the cooling fans. Seal damage will also damage your Hyundai dealer.

Owner's Manual - Page 226

... cap from the bulb base in the back of the headlight. 8. Do not touch the glass of the old bulb. 11.Check for proper headlight aim. 12.To replace the front turn signal light bulb... the new bulb. Reattach the bulb spring and reconnect the connector. 10.Use the protective cap and carton to remove the headlight bulb. 9. 6 DO-IT-YOURSELFMAINTENANCE 28 HJM5016 HJM5017 HJM5018 6. Turn the...

Owner's Manual - Page 227

... of the used bulb with a phillips screwdriver. (1) (2) (3) G270A03O (4) ! Remove the mounting screws as shown with care. 3. DO-IT-YOURSELF MAINTENANCE 6 29 G270B01JM-AAT Rear Combination Light 1. HJM5020 HJM5022 WARNING: This halogen bulb contains gas under pressure and if impacted could shatter, resulting in a headlight.