2008 Hyundai Accent Support Question
2008 Hyundai Accent Support Question
Find answers below for this question about 2008 Hyundai Accent.Need a 2008 Hyundai Accent manual? We have 1 online manual for this item!
Question posted by dajerzboy on May 12th, 2015
A/c Not Blowing?
A/C worked perfect yesterday, but today when turning it on, no air blowing, hot or cold. Could this be a fuse?
Current Answers
Related Manual Pages
Owner's Manual - Page 12
... AT A GLANCE
B255A02MC-AAT
INDICATOR SYMBOLS ON THE INSTRUMENT PANEL SRS (Airbag) Warning Light ABS Service Reminder Indicator (If Installed) O/D OFF Indicator (Automatic transaxle only) Turn Signal Indicator Lights High Beam Indicator Light Low Oil Pressure Warning Light Parking Brake/Low Brake Fluid Level Warning Light Charging System Warning Light Door...
Owner's Manual - Page 17
...
Locking from Outside
o When locking the door from outside, be careful not to unlock all doors, turn the key again toward the rear within 4 seconds (With the central door locking system). The doors ...always remove the ignition key, close the door. B040C04MC OMC025005
o The door can be unlocked by turning the key once toward the front of the passenger's door to the "LOCK" position so that ...
Owner's Manual - Page 19
... not cause harmful interference. Operation is located on the driver's armrest. Including interference that may be ejected from the vehicle and can be opened by turning the key in rapid succession with Part 15 of the door lock switch, all vehicle doors will remain locked when closed.
o When depressing the rear...
Owner's Manual - Page 20
... time all doors. 2. At the same time the driver's door unlocks, the turn signal lights. The battery in the transmitter is extremely cold. -
Push the "LOCK" button on the transmitter again within 4 seconds.
Unlocking doors
1. When the transmitter does not work if any liquid. Push the "UNLOCK" button on the transmitter. 2.
If triggered...
Owner's Manual - Page 23
Battery
B050A01A-AAT B060A02MC-AAT
POWER WINDOWS (If Installed)
4 Door
3 Door
3FDA2015
1KMA2003
To raise or lower the window, turn the window regulator handle clockwise or counterclockwise.
The window moves as long as the switch is in the transmitter.
!
B060A01MC
2. WARNING:
When opening or closing ...
Owner's Manual - Page 24
...windows, press the window lock switch. To stop and cannot be operated without the ignition key turned to operate the main switch on the driver's door and a switch on the armrest of ... of the passenger front (4/3 Door) and rear windows (4Door), a window lock switch(2) is turned to move, entangle themselves or others. o Passengers can be operated for obstructions before raising any ...
Owner's Manual - Page 27
... must be snug against severe neck injuries when properly adjusted. Headrests are designed to an occupant may provide protection against your hips and chest to work properly. To raise the headrest, pull it up on the recliner control lever at the same height as the top of the occupant's eyes. Headrests...
Owner's Manual - Page 52
... pre-tensioner seat belt is not working properly, this warning light will illuminate for approximately 6 seconds after the ignition key has been turned to inspect or replace the pre-...Improper handling of the SRS airbag. o The pre-tensioner seat belt assembly mechanisms become hot during a collision. WARNING:
o Pre-tensioners are designed to improper operation or inadvertent ...
Owner's Manual - Page 55
... "ON" position, remains illuminated after approximately 6 seconds when the ignition key is turned to deploy at 1-800633-5151.
o If you are combined with the occupant classification system. If a seat track position sensor or an occupant classification system is not working properly, the SRS airbag warnAIR ing light BAG on the topside of...
Owner's Manual - Page 60
.... If there is not working properly.
the airbags are not hazardous - 1 FEATURES OF YOUR HYUNDAI
48 Passenger's Front Airbag
o When installing a container of liquid air freshener inside the vehicle, do... not place it may damage these parts.
o The SRS can function only when the ignition key is turned to the "ON" position...
Owner's Manual - Page 65
... key is turned to the "ON" position, remains illuminated after approximately 6 seconds when the ignition key is turned to the "ON" position or after the engine is not working properly, the...HYUNDAI
1
53 53
NOTE:
The "PASSENGER AIR BAG OFF" indicator illuminates for child restraints should ride in the front passenger's seat. o If the "PASSENGER AIR BAG OFF" indicator is illuminated when the ...
Owner's Manual - Page 76
...authorized Hyundai dealer. B260D01A-AAT
Turn Signal Indicator Lights
The blinking green arrow on , the overdrive off . If the arrow comes on when the SRS is not working properly. This light also ... level warning lights remain "ON" or come on for approximately 6 seconds after the key is turned to the high beam or flash position. High Beam Indicator Light
The high beam indicator light comes...
Owner's Manual - Page 77
... not stop in either the brake electrical system or brake hydraulic system is safe to do so, turn the engine off the roadway. FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI
1
65 65
B260G01A...
If the brakes fail while you still have your car with only a portion of the dual systems working . If the light comes on while the engine is started , the light should not be checked by...
Owner's Manual - Page 80
... vehicle speed immediately and stop and check your tires is significantly underinflated.
If you turned the ignition key to the "ON" position, the Tire Pressure Monitoring System is above... warning light will cause the tires to loss of the engine coolant is not working properly. WARNING:
Significantly low tire pressure makes the vehicle unstable and can contribute ... coolant is hot.
Owner's Manual - Page 81
... (Tire Pressure Monitoring System) Malfunction Indicator (If Installed)
TPMS malfunction indicator comes on for about 3 seconds when you turned the ignition key to the "ON" position, the Tire Pressure Monitoring System is not working porperly.
o The TPMS cannot alert you to a safe position off . B270A01A-AAT
BRAKE PAD WEAR WARNING SOUND
The...
Owner's Manual - Page 95
..."ACC" position or the "ON" position.
MIN - When this is necessary to work, the key must be turned off.
This can damage the heating element and create a fire hazard. Push "M" to 12 : ... CLOCK
B400A01A-AAT
CIGARETTE LIGHTER
B420A01A-AAT
(If Installed)
OMC025098-A OMC025062
HHR2098A
To turn on the front fog lights, push the switch. When the element has heated, the lighter will pop ...
Owner's Manual - Page 128
1 FEATURES OF YOUR HYUNDAI
116
CLIMATE CONTROL AIR FILTER
B760A07A-AAT
(For evaporator and blow unit)
! The climate control air filter is located in severe conditions such as dusty, rough roads, more frequent climate control air filter inspections and changes are required. CAUTION:
Outside air
Inside of pollutants entering the car. It operates to the page...
Owner's Manual - Page 226
... same or lower rating from an accessory you suspect a blown fuse, follow this operation). 3. Turn off the ignition and all other electrical accessories stop working, a blown (open) fuse could be found low on the dashboard on the driver's side. Replace the blown fuse by each fuse. If you can temporarily get along without (the radio or...
Owner's Manual - Page 227
If you replace a fuse and it blows as soon as the accessory is turned on, the problem is serious and should be discharged by ...is parked without being operated for diagnosis and repair. Turn off the headlights and tail lights. 3.
NOTE: See page 6-29 for prolonged periods. 1. Never replace a fuse with anything except a fuse with a power connector to prevent battery discharge if ...
Owner's Manual - Page 242
... requirements of fuel vapors into the induction system. Inside the crankcase, the fresh air mixes with an emission control system to prevent fuel vapors from escaping into the atmosphere...Emission Control System is equipped with blow-by gases being emitted from the fuel tank to prevent air pollution caused by blow-by gases, then passes through the air intake hose. 7 EMISSION CONTROL...
Similar Questions
Vehicle Does Nothing When Key Is Turned In Ignition Switch.
my hand slipped off of key when starting. I continued to turn , from partial turned position, starte...
my hand slipped off of key when starting. I continued to turn , from partial turned position, starte...
(Posted by treycrossaustell 8 years ago)
How To Turn Off Door Chime For 2008 Hyundai Accent
(Posted by edwatufty 10 years ago)
2008 Hyundai Accent Ignition Switch Key Wont Turn
(Posted by Kofiallan 10 years ago)
My Turn Signal Light Not Working But Hazard Light Working.
I changed my relay and still not working.
I changed my relay and still not working.
(Posted by luziphilip 10 years ago)
My Front Parking Lights Don't Turn On Replaced Bulbs Already Back Parkin Work
Back parking lights work fine headlights work
Back parking lights work fine headlights work
(Posted by Anonymous-107305 11 years ago)